Where do i change the flasher - 2000 Chevrolet Venture

find and change the turn signal flasher. it looks the same as the e-flasher.

The Combination Flasher, also referred to as the combo-flasher, is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in a rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification.
The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher). The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.

Ref: http://www.10w40.com/questions/auto-repair-questions/where-is-the-flasher-relay-on-a-2000-chrysler-concorde
Good Luck

the flasher is under the dash on the drivers side. if you turn on the hazard lights and look under the dash you will see what turn signal flasher looks like and know which flasher not to change thinking its the right one. look for the signal flasher and change it.

Very easy once you find it. Just pull off the electrical connector, unclip the flasher from its bracket, and the new one in...presto! The flasher will be somewhere under the dash, usually somewhere around the steering column. If you have a flasher for the blinkers and a separate flasher for the hazards, put the hazard lights on, and that flasher will be clicking-change the other one for the blinkers.
Good luck.

i assume you mean that you have hazard flashers work and not the signals.there are two flasher units on the car.one is for the hazards and the other is for the turn signals.they look exactly the same but have there own circuits.it sounds like you changed the hazard flasher thinking it was the signal flasher.you need to look for the flasher unit and change it.it should be on the fuse panel or under the dash in the same general area.

did u change the correct flasher?there are 2 flashers,the regular turn signal one and the 4way flashers,make sure u changed the right one,,,

IS THEY TWO WAYS OF FITING IT

Try adjusting the brake light switch on the brake pedal.

The flashers have a relay in the circuit, test it and see what you get . The flasher switch may be the culprit also. By pass the switch with a pair of jumper wires and see if flashers work.

you may have replaced the wrong flasher, some vehicles have separate flasher for the turn signals and the emergency flashers

You changed the hazard flasher or the turn signal flasher? It has two, one for the hazard and one for the turn signals