Question about 1997 Jeep Cherokee

1 Answer

Engine modification how do i disable 2 cylinders on a 97 grand cherkoee

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has answered 200 questions.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 242 Answers

I suppose if you undid the electrical plug on the injector , the injectors wouldn't fire. I guess you can test it out and see for sure. If you just remove the spark plug wires, it would run really rough. If you do remove the clip, you will get a check engine light that denotes the missing signal from the corresponding injector. Make sure you don't do it on the #1 cylinder (closest to the front). The computer uses that cylinder to adjust timing and start-up checks. Are you trying to go from 8 to 6 or 6 to 4?

Posted on Oct 27, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Problem getting 97 van to start

All timing marks aligned and distributor rotor pointing at # 1 cylinder at TDC as it should? All that has been confirmed properly aligned? What engine?

Mar 29, 2014 | 1997 Plymouth Grand Voyager

1 Answer

How to bleed brakes on a 1996 grand cherkoee after changing calipers

Easy way is fill the master cyl.,leave the cap loose,open a bleeder
gravity will do the rest ,wait till pure fluid runs out ,no bubbles,then the other side.
Might take 10 min. or so per side but pumping the pedal and bleeding can leave some whipped up air. Have to keep an eye on the fluid in
the master while gravity is working

Mar 02, 2013 | 2004 Dodge Ram 1500

2 Answers

Which cylinder is #1 on a 97 jeep grand cherokee laredo4.0L?

the front cylinder closest to the front of the car

Dec 23, 2010 | 1997 Jeep Grand Cherokee

3 Answers

Is the #1 cylinder at the front of the engine on a 97 Jeep Grand Cherokee laredo

number one is always the further cylinder of the engine .the heads are not equal so the more in frt is the nuber one

Oct 22, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Firing order for a 97 pontiac grand am se

For the 1997 Pontiac Grand Am:
I do not know if you have the 2.4L DOHC In-Line 4-Cylinder or the 3.1L V6. However I have included both below. I suspect based on the SE Model you have the 3.1L V6.

For the 2.4L DOHC In-Line 4-Cylinder:
Firing Order:

For the 3.1L V6:
Firing Order:
Ignition Coil Connections

Let me know if this helped.....

May 16, 2010 | 1997 Pontiac Grand Am

2 Answers


The vss is mounted on the rt axle shaft housing at the top of the housing on an automatic and man trans.

Feb 24, 2010 | 1997 Pontiac Grand Am

1 Answer

97 grand jeep cherokee, security system self

you have two options: 1 keep the system working properly. In this option all you need to do is replace the key lock cylinder (it contains both the cylinder and electrical contacts in one piece). 2 disable permamently the system, to do thay you locate the violet/yellow wire coming through the hinge rubber hose in the driver door, peel say about half an inche use a splice connector to ground a piece of wirte from there, next cover it with isolator tape and you are all done.

Dec 20, 2009 | 1997 Jeep Cherokee

1 Answer

Factory alarm 97 grand prix

1st the system alarm is intagrated into the engine control electronics, it can not be disabled without poss damage to ther systems and controls, 2nd the most common cause of your issue is the sensor in the ignition lock cylinder being defective, this is the most common issue on all GM anti-theft systems.

Nov 18, 2008 | 1997 Pontiac Grand Prix

3 Answers

Pontiac Grand Am 97'

if it is a 4cyl probably a bad coil cover

Aug 21, 2008 | 1997 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides