Question about 1990 Geo Prizm

2 Answers

1990 Geo prizm

I had a fire under the hood. The wiring caught on fire that is underneath the overflow from the radiator. A few wires I think I could replace, if I could get a diagram. Wires to fan motors, and the fuse box on top to the left of battery got a little melted. So did the battery. ????????

Posted by on

  • geoprizm Jun 14, 2008

    Need to get a schematic diagrams of a wiring harness Soon!! Very Soon!!

  • c87cancer Dec 19, 2008

    can you show me a diagram

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I MOVE THE FUSE AROUND INSIDE THE CAR LAST NIGHT.....THIS MORNING THE CAR WOULD NOT CRANK ....LIGHTS ,HORN IS GOOD....THIS IS ON A 84 GEO PRIZM....

Posted on Jan 09, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 337 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the spark plug gap.


open hood
look up
under hood, see that sticker
there, shows gap and timing and other data.
no engine stated.
this is 1.6L i think.

4AFE, 1.6L DOHC EFI , injected. Iron block, starting in 1990 model.
this ?

4AFE, spark gap 0.031

this car is Toyota Corolla. (cept stickers)

first google hit of 1000

http://www.toyotaownersclub.com/forums/topic/9479-spark-plug-gap-size/

for sure, all engines, on any prizm are here. all 3.

Feb 01, 2016 | 1991 Geo Prizm

1 Answer

Disconnected rear window defogger...car won't start 1994 geo metro


ops
i think you mean, I disconnected , rigth?
and the wire hit ground and the switch was one the fuse will blow.
its a huge fuse, and may take out others. up stream.
the car has fuses under dash (cab) and under hood, one is blown.

Aug 11, 2013 | 1995 Geo Prizm

1 Answer

Where is the brake light switch for a 1990 Geo Prism located?


If it is not on the brake pedal,under the dash,then it is under the hood on the master cylinder or a line at the master cylinder.

Aug 17, 2010 | 1990 Geo Prizm

1 Answer

Im trying to retrieve codes from a 1990 geo, prizm. Found no DLC under the dash. Is it under the hood? I found what might be the connection but i must input individual wires. I don't what wire color goes...


DIAGNOSTIC TERMINAL IS UNDER THE HOOD IN WHICH YOU FOUND. WITH IGNITION SWITCH ON POSITION USE JUMPER WIRE TO TERMINAL T AND E1 OF THE DIAGNOSTIC CONNECTOR.YOU NEED ECM CODE BOOK.THE CHECK ENGINE FLASHES WILL BE YOUR CODES.TWO FLASHES AND PAUSE THEN THREE MORE FLASHES IS CODE 23.THAT HOW YOU DO IT.TO ERASE CODES AFTER THE REPAIR.REMOVE NEGATIVE BATTERY CABLE FOR 1 MINUTE TO REMOVE CODE.

Jun 08, 2010 | 1990 Geo Prizm

1 Answer

Fans dont come on. Where is the fuse box located? on a 1990 Geo Prizm


There are 2 fuse boxes on a Geo Prizm. One is located in the interior of the car, on the drivers side, on the side of the dash, near the door. The other is located on the drivers side underneath the hood.

Oct 05, 2009 | 1990 Geo Prizm

3 Answers

Location of fuel pump relay on a 1990 Geo Prizm


under the hood in a fusebox near the firewall

Sep 10, 2009 | 1990 Geo Prizm

1 Answer

The radiator fan on my 1992 Geo Prizm will not come on. I have tested the fan motor via a wire by pass and confirmed the motor is good. I have also replaced the relay and still the fan will not come on....


pull the cooling switch/sensor Usually the one next to or on thermostat housing. I do believe it a 2 wire. the 1 wire is for your guage. I think you can short it and see if it comes on. take a wire and plug into each other creating a complete circuit. if it comes on then replace the sensor which I think is your issue anyways.

Apr 15, 2009 | 1992 Geo Prizm

2 Answers

Blower motor location 1990 geo prizm


In my 1992 it is underneath the dash on the passenger's side, but you have to take the whole front panel including the glove box off to access it. When that is done there is a rectangular housing and a more circular housing. On the bottom of the circular housing there are three screws that hold the blower motor up. Remove the screws and it will drop right out.

Dec 14, 2008 | 1990 Geo Prizm

Not finding what you are looking for?
1990 Geo Prizm Logo

406 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...