Question about 2007 Mercedes-Benz E320 BLUETEC Sedan

1 Answer

SRS light What fuse control that ???

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

We had the seat pan replaced on the passenger side because the SRS indication came on. My wife put her knee right in the middle of the seat, probably breaking the sensor, while assisting the kids in the back seat.

Posted on Oct 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 e320 wdb210 srs light on blinks once stays on? help


You should have it scanned but before that make sure you didn't blow any fuses in fuse panel or box

Dec 09, 2015 | Cars & Trucks

1 Answer

Fix airbag warning light which stays on


Airbag Service Reset Tools

Find the fuse panel cover in the foot well on the driver's side of the vehicle. Pull down on it to open it.
Find a yellow connector inside the fuse panel. Pull out this connector. This is the airbag power connector, also called the SRS power connector.
Insert one end of the paperclip into one terminal of the SRS power connector and insert the other end of the paperclip into the other terminal.
Put the key into the ignition and turn on the vehicle, making sure you don't start the engine. The paperclip shorts out the SRS light, thus resetting and turning it off. Plug the SRS power connector back into the fuse panel. Put the cover back on the fuse panel and shut off the vehicle.
Wait a couple of minutes, then turn the engine on. Look on the instrument panel to ensure that the SRS light has turned off. Turn off the engine and remove the keys from the vehicle.

Oct 10, 2014 | Cars & Trucks

1 Answer

Driver side fuse box95 trooper


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System

Nov 01, 2012 | Cars & Trucks

1 Answer

The srs light comes on the power windows does not work, the work brake appears in red letters Message appears that states drive to workshop


Hello there. It appears you have three issues. First your srs light could be several issues by itself. This really needs to be diagnosed by first having the DTC's for srs read out. Next, if it is not a specific window but all windows, it could be as simple as checking and replacing the proper fuse, It could also be a more serious issue involving a control module. Unfortunately if this is not a fuse problem, it is also something that needs to be checked with a diagnostic computer, and or qualified technician. There are several fuse panels located within the vehicle located on one or both sides of the dash as you open the front doors. There are many other fuses located in the Signal Aquisition Modules but again should be serviced by a qualified technician. Your red brake light can be as simple as low brake fluid or worn brake parts causing low fluid levels. If it is anything but low brake fluid this is also something that should be addressed by a qualified technician, I say this because your vehicle is equipped with SBC brakes which are electro hydraulic brakes. If these brakes are not disabled before servicing serious bodily harm or damage can occur. Your srs light may be covered by a campaign or recall at no cost to you other than the diagnostic charge.

Jun 13, 2010 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

95 Camry interior lights don't work


The ecu-ig fuse is for the ignition from the Electronic Control Unit, or computer. The SRS fuse is for the Supplemental Restraint System, that is for the air bag system. The dome light is fused with a 7.5A fuse called "dome", which is up in the engine compartment junction block #2, on the inside of the left front wheel well. The "dome" fuse is in the lower left quadrant of the block.

May 11, 2010 | Cars & Trucks

1 Answer

Maintenace


tcs=Traction control system srs=Safety restraint system
check fuses, pull codes off of computer. take to dealer

Sep 23, 2009 | 2005 Honda Odyssey

1 Answer

2002 Honda Accord. SRS LIGHT CAME ON


Open the door of both sides (driver and passenger) and look for the panel for the fuses. Remove the panel and you will see the fuse box. The information of the fuses is on the panel.

Apr 08, 2009 | 2002 Honda Accord

1 Answer

SRS light, horn and cruise control not working... need help?


Most likely the clock spring assembly which the wires run through for airbag, cruise switches and horn button. Requires steering wheel removal to access part.

Mar 29, 2009 | 1997 Honda Civic

1 Answer

My srs lights came off after my radio shut off


the problem may be a malfunction with one of the srs sensors ... i would recomend taking the car to a honda dealer to have the srs sensors tested !!!

Mar 25, 2009 | 1996 Honda Accord

Not finding what you are looking for?
2007 Mercedes-Benz E320 BLUETEC Sedan Logo

Related Topics:

473 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60867 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

164 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...