Question about 1996 Toyota RAV4

1 Answer

Removing a flat battery

The alarm kicks in when the battery is dis connected how do you over ride

Posted by on

  • sunshine7 Aug 26, 2008

    I am not technical, so sorry about wording. central locking fob has not worked for some months despite new battery.(in fob) Have closed doors manually. Today engine is immoblised. Red light in central console is on and indicators flashing when opening doors, etc. Cannot turn off immobiliser. Taking battery terminals on/off makes no difference. Any ideas would be greatly appreciated. Chris.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

New battery

Posted on Jul 18, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I accedentallly hit the paniuc button on the keypad and now it wont start


Try dis-connecting the battery and alarm fuse and leave unhooked for at least 15 minutes. Re-attach the battery cables and reinsert the fuse to the alarm. Manually open the driver door with the key and turn left and right 2 times. Turn the ignition on but do not try to start the car yet. Turn off and on at least 7 times. Then try to start the car. If this does not work, then you may need to call the dealer about the correct way to reset the alarm system. You could also try removing the battery from the key and then starting the process over. I am not sure this will work but it is worth a shot. Good Luck!

May 03, 2016 | 2003 Toyota Camry

1 Answer

The factory alarm is killing the battery because the alarm is always going off. How do I dis-connect the factory alarm?


Your car is equipped with a shock sensor which is faulty or one of the doors is not being sensed by the alarm.
This is quite technical and unfortunately it is easier for you to see a specialist. If you pull the wrong wires, you could burn the car down (short circuit).

Feb 04, 2011 | 2001 Hyundai Elantra

1 Answer

Alarm keeps going off took battery cables off 2 try and let computer reset still goes off


Hi,

Alarm Modules are one of the Common problem in these Models.You could try:
Find the Red / Black wire at the Hood Switch, located above the Fan & connect one end of a piece of wire to the Red / Black wire.
Connect the other end of the piece of wire to Ground (chassis)
This should Dis Arm the Alarm until the wire is removed.

This will only work "if" the Alarm Module is Not Defective.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Feb 12, 2010 | 2001 Hyundai Santa Fe

2 Answers

How to disarm alarm system. I lost the alarm key pack. When I use the spare key to crack up the interior lights flashes. I am unable to turn them off. Then that runs the battery down.


REMOVE THE DRIVERS SIDE KICK PANEL,PULL THE WIRE PACK OUT,THERES APURPLE WIRE WITH A YELLOW STRIPE.......GROUND IT OUT!! THATLL KILL YOUR FACTORY ALARM

Nov 30, 2009 | 1995 Jeep Grand Cherokee

1 Answer

The rear end on my moms 1990 lincoln continenatlal is higher than the front because of the air ride is unlevel. what is wrong and how do i fix it?


jack up the car to where it is level on all four wheels and dis connect and re-connect the battery. this will reset the ride height.

Apr 22, 2009 | 1990 Lincoln Continental

1 Answer

Electrical drain from car alarm


dis connect wires t-tapped into ign swith

Mar 08, 2009 | 1997 Toyota Camry

1 Answer

Heater Core


1) disconnectnegative battery cable
2) remove coolant reservoir
3) dis-connect heater hoses from heater core and plug holes in heater core, some coolant will drain out
4) remove mounting bolts and nuts on fire wall
5) remove glove box liner and door
6) lable and dis-connectheater controls
7) dis-connectand remove computer and mounting bracket
8) move radio antenna wire
9) remove kick pannel and un-bolt lower corner of dash
10) remove screws and nuts holding the housing inside the cab
11)remove the heater housing from the vehicle
12) detatch the core retaining straps and remove the heater core
13) installation is this procedure in reverse
I hope that this fixes your problem good luck and please take the time to rate this response.

Oct 17, 2008 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

How to replace heater core on 89 s15


disconnect negative battery cable
remove coolant reservoir
dis-connect heater hoses at heater core
remove mounting screws and nuts from the heater housing in the engine compartment
remove glove box door and liner
disconnect heater controls ( be sure to lable them so you know where to put them later )
disconnect the computer ( ECM ) an mounting bracket
remove the radio antenna cable
remove the kick pannel and detech the right lower corner of the dash pannel.
pull the heater assembly to the rear for access and dis-connect the wiring harness
remove the screws and nuts retaining the heater housing inside the cab
remove the heater housing from the vehicle
detach the core retaining straps
and wala you got it
to install it just reverse these steps.
good luck

Jun 16, 2008 | 1988 GMC S-15

1 Answer

CAINT GET MY 2001 DODGE STRATUS STARTED AFTER REMOVING BATTERYTHE ALARM OR ANTI THEFT DEVICE IS ON THERE IS A RED BLINKING LIGHT ON AT THE LEFT OF THE STERRING WHEEL SAID WE NEED CODE BUT DONT KNOW IT


when they installed the alarm they also in stalled a valette switch on your ride this is to shut off the alarm im looking for the site for your remote that has the way to get your code back in but for now find the valette switch which can be under dash or right side driver kick panel you might have to hold the vallette switch for 5 seconds till it goes off i will post the other solution once i find it for you

May 19, 2008 | 2001 Dodge Stratus

Not finding what you are looking for?
1996 Toyota RAV4 Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...