Question about 2003 Chrysler Town & Country

1 Answer

Why do the headlamps keep flashing - 2003 Chrysler Town & Country

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 25 Answers

You probably have a bad circuit breaker. in the head light circuit there is a self resetting breaker that can get week over time. thats what i would suspect in this case.

Posted on Oct 17, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the wiper motor located


Section 17-01: Lighting, Exterior 1995 Town Car, Crown Victoria, Grand Marquis Workshop Manual REMOVAL AND INSTALLATION Headlamp Assembly Removal and Installation
  1. ssa~us~en~file=ani_caut.gif~gen~ref.gif WARNING: THE HALOGEN HEADLAMP BULB CONTAINS GAS UNDER PRESSURE. THE HEADLAMP BULB MAY SHATTER IF THE GLASS ENVELOPE IS SCRATCHED OR THE HEADLAMP BULB AND RETAINER (13N021) ARE DROPPED. HANDLE BULB CAREFULLY. GRASP HEADLAMP BULB AND RETAINER ONLY BY ITS PLASTIC BASE. AVOID TOUCHING GLASS ENVELOPE. KEEP HEADLAMP BULB AND RETAINER OUT OF REACH OF CHILDREN.
    NOTE: The headlamp (13008) on this vehicle does not need replacement when the headlamp bulb and retainer burns out. Refer to Headlamp Bulb for removal and installation of headlamp bulb and retainer .
    Position headlamp in the OFF position.
  1. Remove headlamp dash panel junction wire (14290) from headlamp bulb and retainers by grasping wires firmly and carefully snapping connector downward.
  1. NOTE: Use snap-ring pliers to spread headlamp mounting clips (13N129) , then pull straight upward to disengage.
    Remove three headlamp mounting clips attaching headlamp to radiator grille opening panel reinforcement (8A284) .
  1. Remove headlamp from vehicle.
  1. To install, reverse Removal procedure.
  1. Aim headlamp .

Oct 21, 2010 | 1999 Mercury Grand Marquis

1 Answer

If i turn on my headlights, they flash but nothing else is wrong with the truck. can you please help fix this?


sounds like a bad headlamp switch it has an internal circuit breaker seems like it keeps tripping off

Aug 11, 2010 | Ford F-150 Cars & Trucks

1 Answer

Front passenger head lights keep flashing in and out


If you haven't already done so change the bulb and see if this corrects it. I broken element in the bulb will do this when the element bounces up and down and makes brief contact. If you have tried this then it could be caused from a broken wire on the headlamp harness or a bad headlamp socket. I would first remove the headlamp leaving it attached in the socket, with the lights on shake the harness and see if you can get the bulb to flash. If it does flash inspect the wires going to the headlamp socket for and damage or breaks and inspect the socket itself for a loose fitting bulb. If you find bad wiring repair it using water tight **** connectors that will need to be heated to seal the wires. If you find a bad or worn socket from excessive heat then contact you dealer or local junk yard for a replacement and again use water tight **** connectors or shrink tube.

Jul 30, 2010 | 2002 Chevrolet Tahoe

1 Answer

Low beam headlights keep burning out, 8 times on


If you visit many forums for Elantras, you will see that frequent headlamp failure is very common. It has been discussed over and over again and it is thought that always turning the lights off and on via the stalk switch is recommended. If you leave the light switch in the on position, when you start your car, the lights briefly flash on then off again as you turn your ignition to the start position and then turn on again as you release the key to return to the "on" position. This may be causing a power surge which creates stress on the bulb filament and can only be avoided by using the light switch instead of the ignition to power up the headlamps.

Jan 08, 2010 | 2004 Hyundai Elantra

1 Answer

I need to change a dead bulb in my headlights and I dont have the owner manual.


96 sable, only ino I have. should be similar. Please rate, thanks

  1. sth~us~en~file=ani_caut.gif~gen~ref.gif WARNING: THE REPLACEABLE HALOGEN HEADLAMP BULB CONTAINS GAS UNDER PRESSURE. THE HALOGEN HEADLAMP BULB MAY SHATTER IF THE GLASS ENVELOPE IS SCRATCHED OR THE HALOGEN HEADLAMP BULB IS DROPPED. HANDLE HALOGEN HEADLAMP BULB CAREFULLY. GRASP HALOGEN HEADLAMP BULB ONLY BY ITS PLASTIC BASE. AVOID TOUCHING GLASS ENVELOPE. KEEP HALOGEN HEADLAMP BULB OUT OF REACH OF CHILDREN.
    NOTE: A properly aimed headlamp (13008) assembly normally need not be re-aimed after installation of bulb. A burned out headlamp bulb and retainer (13N021) should not be removed from the headlamp until just before a replacement headlamp bulb and retainer is to be installed. Removal of a headlamp bulb and retainer for an extended period of time may allow contaminants (dust, moisture, smoke) to enter the headlamp and affect the performance of the headlamp. When servicing the headlamp bulb and retainer, energize the headlamp bulb and retainer only while it is contained within the headlamp body.

    Make sure headlamp switch (11654) is in OFF position.
  1. NOTE: On some models the clamps holding the integrated relay control module (IRCM) may need to be unsnapped and the module pulled aside to gain access to the driver side bulb.

    Open hood and locate headlamp bulb through hole in upper radiator support assembly.
  1. Remove headlamp wire connector from headlamp bulb and retainer by pulling the connector and wires in a rearward direction.
  1. Remove headlamp bulb retainer (13N019) by rotating counterclockwise (when viewed from rear) about one-eighth turn and sliding headlamp bulb retainer off headlamp bulb and retainer. Keep headlamp bulb retainer as it will be used again to retain new headlamp bulb and retainer.
  1. Carefully remove headlamp bulb and retainer from opening in headlamp bulb (13007) by gently pulling straight out of opening. Do not rotate headlamp bulb and retainer during removal.
0a1a11c.gif

Jul 05, 2009 | 1991 Mercury Sable

1 Answer

I have 2006 Grand Prix How do I change head lamp?


Caution Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
Turn off the lamp switch and allow the bulb to cool before changing the bulb.
Leave the lamp switch OFF until the bulb change is complete. Always wear eye protection when changing a halogen bulb. Handle the bulb only by its base. Avoid touching the glass. Keep dirt and moisture off the bulb. Properly dispose of the used bulb. Keep halogen bulbs out of the reach of children.
Raise the hood.
Remove the headlamp assembly bolts from the upper fascia support.
Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support.
Position the headlamp assembly away from the vehicle body to access the electrical connector.
Disconnect the electrical connector from the headlamp assembly.
Remove the headlamp assembly from the vehicle.
Disconnect the electrical connector from the headlamp bulb/socket.
Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise.
Remove the headlamp bulb/socket from the headlamp assembly.

Jun 13, 2009 | 2006 Pontiac Grand Prix

1 Answer

Headlights do not turn on at the light switch.


manual headlamps

Visual Inspection Chart
Mechanical Electrical
  • Headlamp switch
  • Multifunction switch
  • Central junction box (CJB) fuse:
    • 7 (30A)
    • 30 (15A)
    • 46 (10A)
    • 47 (10A)
  • Circuitry
  • Headlamp bulbs
  • Daytime running lamp (DRL) relay No.1


Autolamps

Visual Inspection Chart Mechanical Electrical
  • Headlamp switch
  • Central junction box (CJB) fuses:
    • 19 (5A)
    • 56 (30A)
  • Circuitry
  • Headlamp bulb
  • Daytime running lamps (DRL) full relay No.1 (if equipped)
  • Vehicle security module
  • Photocell


If autolamp system, Vehicle security module has a headlamp rela inside of it. under left side of dash.

May 26, 2009 | 2002 Ford F250 Super Duty SuperCab

1 Answer

1994 ford f-150 with day time running lights headlightnot working


Daytime Running Lamps
The daytime running lamp (DRL) system is designed to turn the high beam headlamps on, with a reduced light output, and without illuminating the high beam indicator lamp in the instrument panel. You have a DRL Module.
The multifunction switch is the stalk on your column.

This is 96 F150 circuit. Don't have 94.

51f651c.gif
Symptom Chart, Headlamps HEADLAMPS Condition Possible Source Action
  • Headlamps Inoperative
  • Circuitry open/shorted.
  • Damaged headlamp switch.
  • Blown fuse.
  • GO to Pinpoint Test A .
  • Headlamps On Continuously
  • Circuitry open/shorted.
  • Damaged headlamp switch.
  • GO to Pinpoint Test B .
  • High Beams or Low Beams Inoperative
  • Circuitry open/shorted.
  • Damaged multi-function switch.
  • GO to Pinpoint Test C .
  • One High Beam or One Low Beam Headlamp Inoperative
  • Circuitry open/shorted.
  • Damaged connector.
  • Headlamp bulb damaged.
  • GO to Pinpoint Test D .
  • Flash-to-Pass Inoperative
  • Blown fuse.
  • Circuitry open/shorted.
  • Damaged multi-function switch.
  • GO to Pinpoint Test E .



73d6d64.gif

Feb 25, 2009 | 1994 Ford F150 Styleside Supercab

1 Answer

Flashed headlamps


the new Lamborghini Gallardo Spyder triggers more flashed headlamps and thumbs-up signals than the inevitable flock of Maybachs, Maseratis, Ferraris, and Bentleys. This car seems to collect dates faster than George Clooney at large, which is a bit surprising when you consider that the Gallardo coupe was first released back in 2003. But in Miami's extroverted environment, being able to lower the Gallardo's canvas roof--a fully automatic, twenty-second procedure--makes all the difference.

May 14, 2008 | 2000 Lamborghini Gallardo

Not finding what you are looking for?
2003 Chrysler Town & Country Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...