Question about 1994 Isuzu Trooper

Open Question

Power steering hard to turn in idle - 1994 Isuzu Trooper

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is power steering pump switch?


If it is hard to steer, I don't think that switch is the problem? More likely the power steering pump or rack/pinion. Just my opinion.

Usually that switch is to help up the idle, so the vehicle doesn't stall when turning at idle.

Mar 04, 2015 | 1999 Mercury Villager

1 Answer

Lumina troubleshooting


first check the condition and level of p/s fluid. if low top off first and turn your steering wheel left to right and back several times to try to bleed air out of p/s system. if p/s is still stiff or hard your p/s pump pressure output can be measured with a pressure gauge. if pressure is below specs its time to replace it. if your p/s output pressure is good then you would need to inspect your p/s hose or lines for kinks or restrictions to your steering rack. on certain model vehicles p/s sensitivity can be adjusted on the steering rack. you would need to check the vehicles service manual to see if its possible to adjust steering rack sensitivity.

Aug 29, 2014 | Chevrolet Lumina Cars & Trucks

1 Answer

Power steering hard to turn


Engine running ask someone to turn steering wheel for you . Look for power steering hose move like there is pressure. and noise from power steering pump . if not change power steering pump
You don't really need power assistance when moving on the road ... where you need it more specially in parking or not really moving
hope it helps

Mar 31, 2014 | 2002 Chevrolet Tahoe

3 Answers

Power steering pump replaced, start to work ok, after 10 milles driving, steering wheel is hard, like pump is not working, under hood everything look ok.


YOU HAVE AIR IN THE POWER STEERING SYSTEM.YOU NEED TO BLEED POWER STEERING PUMP FIRST BEFORE DRIVING VECHICLE.CHECK POWER STEERING FLUID LEVEL ADD MORE POWER STEERING UNTIL REACH FULL COLD MARK..RAISE VECHICLE FRONT WHEELS OFF THE GROUND.START ENGINE LET IT IDLE WHILE TURNING STEERING WHEEL LEFT TO RIGHT NON STOP DONT LOCK OR STOP STEERING WHEEL KEEP TURNING IT SEVERAL TIMES CHECK POWER STEERING FLUID IF LOW ADD UNTIL YOU GET COLD MARK ON DIP STICK DONT OVER FILL POWER STEERING PUMP BLOW A SEAL.IF POWER STEERING FLUID LOOK TAN COLOR SYSTEM FULL OF AIR.TURN OFF IGNITION LET CAR SET FOR A WHILE CHECK FLUID LEVEL.IF STEERING WHEEL FEEL STIFF HARD TURNING DONT DRIVE CAR UNTIL YOU HAVE NORMAL STEERING.IF STILL HAVE AIR IN SYSTEM BLEED SYSTEM UNTIL AIR IS OUT.

Feb 25, 2011 | 2002 Chevrolet Avalanche

1 Answer

Power steering hard to turn at idle only on 2000 chrysler lhs.power steering rack and pinion and pump already replaced.


start with checking your tire pressure if thats ok check the belt for proper tension and fluid level and last that your idle speed is set correctly while the vehicle is idle in drive not idle in park hope this helps.

Jan 03, 2011 | Chrysler LHS Cars & Trucks

1 Answer

I have had the power steering pump replaced on my 99 pontiac grand prix, since then it has had no problems with power steering for about two months......then all of a sudden its making that whining noise...


YOU NEED TO BLEED POWER STEERING SYSTEM BY HAVING LOW FLUID AIR ENTER THE SYSTEM.PARK CAR ON SOLID LEVEL GROUND SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS.YOU CAN LEAVE CAR ON GROUND BUT TURNING STEERING WHEELS BACK AND FORTH WILL WEAR SPOT IN TIRES.TURN STEERING WHEEL TO THE LEFT WITH THE ENGINE OFF.CHECK POWER STEERING FLUID.ADD MORE FLUID IF LOW.MAKE SURE FLUID LEVEL ON COLD MARK ON DIP STICK.THE YOU CRANK CAR UP LET IDLE LITTLE HIGH FOR 15 SECONDS.THEN TURN OFF ENGINE.CHECK POWER STEERING FLUID LEVEL MAKE SURE ITS ON COLD MARK AT DIP STICK.THEN YOU START THE CAR UP WHILE IDLING TURN STEERING WHEEL IN BOTH DIRECTIONS SLOWLY TO THE STOPS DONT HOLD IN STOP TURN STEERING WHEEL LEFT AND RIGHT FOR SEVERAL TURNS.STOP ENGINE CHECK FLUID IF FLUID TAN STILL HAS AIR IN SYSTEM.LET CAR SET A LITTLE WHILE TRY THE BLEEDING PROCEDURE AGAIN.THERE IS A REASON POWER STEERING FLUID WAS LOW CHECK ALL POWER STEERING HOSES AT POWER STEERING PUMP TO THE RACK PINION ASSEMBLY.

Jun 13, 2010 | 1999 Pontiac Grand Prix

1 Answer

My steering wheel is hard on my 98 camaro on turns


Sounds like the power steering pump is getting some wear on it and cant build the required pressure at an idle. Replacement ma be the only cure.

Apr 06, 2010 | 1998 Chevrolet Camaro

Not finding what you are looking for?
1994 Isuzu Trooper Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...