Question about Mercury Marquis
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2003 mercury grand marquis LS
The blend door is stuck in cold position. That usually happens because the blend door actuator has failed.
You will need to test and replace the blend door actuator.
To replace the actuator you will need to take apart the dash and remove completely the instrument panel,d isconnect the connector, remove the four screws, remove the temperature blend door actuator and replace it.
The replacement is not a job for beginners, since you have to take apart the dash to access the actuator.
Posted on Nov 18, 2009
loosen pressure cap slowly at coolant tank to relieve pressure,when pressure is relieved remove cap,place a suitable container under drain valve at bottom of radiator open drain valve.when coolant has stopped draining,close valve.then remove thermostat,[this is a good time to replace t.stat since it must be removed to refill cooling system],disconnect heater core coolant supply hose at rear of intake manifold.add coolant thru t.stat opening until coolant comes out of coolant supply hose fitting,reinstall hose and tighten[not to tight] reinstall thermostat o ring and thermostat.add coolant to tank until the coolant level is between the COOLANT FILL LEVEL marks.select the maximum heater temperature and blower speed settings run engine until it reaches operating temp.add coolant until the coolant level is between the COOLANT FILL LEVEL marks.turn off engine allow it to cool, recheck coolant level,add as needed .ford requires this procedure to avoid engine damage due to trapped air.
Posted on Jan 20, 2010
You have a described one of the coils going bad. You need to ru na power balance test to determine which cylinder it is so only one is replaced.
Posted on Mar 17, 2010
Testimonial: "Thank you, I will get right to it"
SOURCE: How to reset Check Engine
You can remove the NEG battery terminal for 10 minutes and it will clear. Or go to Autozone or Oreillys for a free scan, find out why it came on, then have them clear it with their scanner.
Posted on Dec 02, 2010
Tips for a great answer:
Feb 23, 2015 | 2001 Mercury Grand Marquis LS
Jun 03, 2014 | 2001 Mercury Grand Marquis
Sep 15, 2012 | 2001 Mercury Grand Marquis
Mar 04, 2011 | 2001 Mercury Grand Marquis
Dec 22, 2010 | 2002 Mercury Grand Marquis
Sep 28, 2010 | 2001 Mercury Grand Marquis
Aug 03, 2010 | 2001 Mercury Grand Marquis
May 27, 2010 | 2001 Mercury Grand Marquis
58 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: