Question about 1994 Mitsubishi Galant

1 Answer

Where is the fuel pump switch located - 1994 Mitsubishi Galant

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

It should be in the back behind one of the panel and this information should be in your owner manual give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop or call your local Mitsubishi dealership and they be able to tell you where it is located wish you the best of luck Michigan Man.

Posted on Oct 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the inertial fuel shutoff located on a 1999 Mercury villager van?


It is called the inertia switch or fuel pump cut-off switch

The fuel pump shut-off switch is

located in the driver's foot well,

behind the kick panel. The reset

button for the fuel pump shut-off

switch is accessible through an

opening in the kick panel.

Use the following procedure to reset the fuel pump shut-off switch.

1. Turn the ignition to the OFF position.

2. Check the fuel system for leaks.

3. If no fuel leak is apparent, reset the fuel pump shut-off switch by

pushing in on the reset button.

4. Turn the ignition to the RUN position. Pause for a few seconds and

return the key to the OFF position.
5. Make a further check for leaks in the fuel system.

Jun 26, 2017 | Mercury Cars & Trucks

1 Answer

No voltage to fuel pump 2002 saburban


vehicles have a safty device that kills the fuel pump in case of a roll-over accident so the fuel will not be poured on to the car and ignite. also, this fuel pump kill switch is used when you are going to remove the fuel pump to de-pressurize the fuel line by cranking the engine while the fuel pump safety switch is off. you can restore the power back to the fuel pump by resetting the fuel pump safety (kill) switch. some are located in the trunk, by the fender well, behind the carpet. some are located inside the kick panel where the front passenger sits. check your motor manuel for that vehicle or ask a parts person at the dealership for the location of the safety switch for the fuel pump.

Mar 29, 2014 | 2002 Chevrolet Suburban

1 Answer

1989 f-250 inertia fuel shut-off switch switch location


This should be in the owner's manual. I found the below on autozone.com, their repair help location:
An inertia switch is used as a safety device in the fuel system. The inertia switch is located in the cab, generally under the dashboard on the right side. It is designed to open the fuel pump power circuit in the event of a collision. The switch is reset by pushing each of 2 buttons on the switch simultaneously (some models use switches with only one reset button). The inertia switch should not be reset until the fuel system has been inspected for damage or leaks.
When the ignition switch is ON , it turns the EEC power relay ON . The EEC power relay provides power to the powertrain control module (PCM) and the control side of the fuel pump relay. Power for the fuel pump(s) is supplied through a fuse link or high current fuse attached to the starter solenoid (battery side). From the fuse link or high current fuse, current flows through the fuel pump relay and inertia switch to the fuel pump(s). The fuel pump relay is controlled by the PCM.
When the ignition switch is turned ON , the fuel pump(s) will operate. If the ignition switch is not turned to the START position the PCM will shut the fuel pump(s) OFF after 1 second. The PCM will operate the fuel pump(s) operate the fuel pump(s) when the ignition switch is turn to START position to provide fuel while cranking.
After the engine starts, the PCM will continue to operate the fuel pump(s) unless the engine stops, drops below 120 rpm or the inertia switch is tripped.

Dec 28, 2013 | 1989 Ford F 250

1 Answer

95 style protege fuel kick off switch location car just cranks but no fuel , pump will not turn on .


The fuel pump relay is located under the dash on the right side of the center console.



8_22_2012_2_22_01_am.jpg

Aug 22, 2012 | Mazda Protege Cars & Trucks

2 Answers

Where is fuel pump relay is location on Ford expedition 2001 4.6


It is located in the relay and Maxi fuse box under the hood near the battery, both the fuel pump fuse and relay are in this box, the fuel pump fuse is a 20Amp and is marked #10, the fuel pump relay is is marked as relay #301.

There is also a fuel pump cutoff switch (triggered by an accident exceeding 3 G's)

The fuel pump shut-off switch is

located in the passenger's foot well,
by the kick panel.

Jul 19, 2011 | 2001 Ford Expedition

2 Answers

Ford explorer 93 where is the fuel shut off switch


For details regarding fuel pump and fuel pump switch click the link below:--- http://technoanswers.blogspot.com/2011/06/where-is-fuel-shut-off-switch-on-1993.html This switch is also called inertia switch For fuel pump reset switch location and diagram click this link below:--- http://technoanswers.blogspot.com/2011/06/fuel-pump-reset-switch-location.html ---------- This should help.Thanks.Helpmech.

Jun 04, 2011 | Ford Explorer Cars & Trucks

3 Answers

No power to fuel pump on 1999 crown victoria


Hello abzalkhan193
Heres a few things to check that could cut power to the fuel pump. The fuel pump inertia shutoff sw
in the trunk on the left side, there is a reset button on the switch if you push the button down and
you hear/feel a click then the switch was tripped and you just reset it. The switch's job is to cut off
the fuel in case of an accident. Next, the fuel pump fuse located in the battery fuse block under the
hood on the right fender well, fuse #1 20amp fuse. Next, the fuel pump relay, the relay is located in
relay center on the left fender well. Hope this is helpful.

Mar 11, 2011 | 2001 Ford Crown Victoria

1 Answer

Does a 1996 crown victoria have a fuel pump reset switch?....and if it does where is it located??


To answer your question about the fuel pump switch...yes. The location of the fuel pump cut off switch is typically located in the upper left corner of the trunk. You may need to pull the carpet down a bit to access it. If it is not in the upper left corner, then it is probably on the right. Usually, the switch is located on the side of vehicle where the fuel filler cap is. Once you locate the switch, press down on the button...you should either feel or hear a "click".

Nov 06, 2010 | 1996 Ford Crown Victoria

2 Answers

Wher is the fuel pump switch on my 97 ranger


Inertia fuel shutoff (IFS) swicht location in instrument panel below radio.Thanks3d52b4b.jpg

Mar 24, 2010 | 1997 Ford Explorer AWD

Not finding what you are looking for?
1994 Mitsubishi Galant Logo

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...