Question about 1989 Jeep Cherokee

1 Answer

How to remove front brake pads from a Jeep Cherokee 1989 ? Seems to be different from Cherokee 1991.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,074 Answers

This should help Tim:

Posted on Oct 16, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi I need to know if have disc brakes can I replace brake pads with ceramic pads on a 2005 jeep grand cherokee Laredo

hi, your jeep has disk brakes front and rear. You can use ceramic pads its more a personal preference. Good luck

Sep 11, 2010 | Jeep Grand Cherokee Cars & Trucks

1 Answer

How do you remove front brake pads from 4x4 jeep Comanche. Pands wont come out. do I deed to remove slide pins?

U need to remove the two bolts holding the caliper,slide back the outer half, then u can remove the pads.

May 20, 2010 | 1989 Jeep Comanche

1 Answer

Fitting jeep cherokee front brakes

remove the front wheels and set on a jack stand! remove the caliper bolts once you have pried back the caliper with a bar or useing a Big!! C- clamp! then slide the caliper up take old pads out and reverse the process takes 15 minutes pr wheel

Jan 22, 2010 | 2001 Jeep Cherokee

1 Answer

Installing keeper clips on my 1989 jeep cherokee 4x4 front disc brakes. I need to check the positioning.

check that the steering knuckles do not have grooves worn in them from the brake pads.....a common problem they can be welded up to solve the issue instead of replacing the knuckles

Dec 16, 2009 | 1989 Jeep Cherokee

1 Answer

How to change front brakes on 2000 jeep cherokee

open hood/remove brake fluid cap and rap rags around /jack up front/pull wheels/do one side at a time/remove caliper pins/with Cclamp push piston slowley !!! to the bottem/put new pads on/if disc has groves ,replace,not exspecev.

Dec 12, 2009 | 2000 Jeep Grand Cherokee

1 Answer

How to replace rear brake pads on 2004 Jeep Cherokee 4x4

take it to a mechanic....;) I have a 2003 jeep grand cherokee 4 wheel drive V8. there probably is not much difference between year models. frist thing remove the back tire you will see the caliper and rotor. check the rotor if it has deep groves on the front or back you will need to bring it in to have it turned or replaced if it is still smooth it should be ok. remove the caliper by taking the two bolts off the back of the caliper. using a pice of wire hang the caliper so it isn't dangling from the brake line. Now is the time to replace rotor if needed .Get a pair of vice grips crimp off the brake line so any trash in the caliper doesn't get into the brake system (if you let the contaminants get into the brake system it can cause costly repairs to the abs system). open up the bleeder valve most of the time close to where the brake line goes into the caliper and usually has a rubber cap. open bleeder valve, take a c-clamp place on inner brake pad and outside of caliper tighten until caliper is all of the way open close bleeder valve. replace brake pads put caliper back on recommend using lock tight on bolts holding caliper on snug fasteners but do not over tighten, lock tight will keep bolts from backing out. do the other side the same way. pull up emergency brake to and pump brake pedal to adjust brakes. bleed brakes and you are done

Nov 14, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Front end shakes when braking

One or both of your new rotors probably have some run-out in them.Not entirely unusual to have warped rotors right out of the box.I would check this before considering other things. machine rotors....good luck

Jul 29, 2009 | 1991 Jeep Cherokee Limited

2 Answers

Changed front brake pads. brake pedal goes to floor. no brakes

Something doesn't sound right, you shouldn't have to remove the brake line to install pads. Did you have to do this on both sides? Do the new pads and the old pads look the same? Did you get the caliper on crooked? Just recheck your work first before replacing more parts. When you install the caliper, You have to hook the pad on one side first before you slide it over the rotor.

Mar 26, 2009 | 2000 Jeep Grand Cherokee

1 Answer

How repair front brakes jep cherokee 1989

I think you are mean the anti-rattle clips. They go on the anchor plate that holds the pads in place. If you need more information, let me know, I will try to find a diagram for you, or explain the proper position of the clips.

Oct 11, 2008 | 1989 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides