Question about Volkswagen Jetta

1 Answer

Oil light on and check engine light on wasn't on until i change the oil and plugs and wires what wrong engine is a 2.0liter. and also can't find where u hook a on board diagnosis system to find what codes it is.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Volkswagen Master
  • 22,095 Answers

Dealer only job to change the oil on these vehicles if its a europeon import it will not have a OBDII only a VW diagnostic plug and encrypted software ,also you cannot change the front brake pads either without the dealer only ABS software .

Posted on Oct 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003 Mitt Lancer Oz Rally. Oil light goes on alway under 2000 to 1500rpm. After i did a oil change


Check your sensor or take your black wire off from your battery for ten minutes then check.

Mar 20, 2016 | Cars & Trucks

2 Answers

What causes it to misfire and skip until the tachometer drops to zero?


Check Engine Light and Misfire Due to Ignition Module/Coil ...

repairpal.com > Problems > Chevrolet > Cobalt
Check Engine Light Due to Engine Misfire on Chevrolet Cobalt .... 2007 Chevrolet CobaltVisitor ... The coil pack was bad and was making the cylinders misfire.

Oct 01, 2015 | 2007 Chevrolet Chevrolet Cobalt LS

1 Answer

Codes P0325, P0330, P0300, P0308, P1404, P0058. I know. ..just went to get my oil change the mechanic told me he had found the engine light with those codes. It's a 2005 Dodge Durango V8-287 4.7L SOHC. I...


These codes are telling you that you are having cylinders misfiring..And the knock sensor is picking up detonation knocks..with all these codes your engine must be running really bad.. Start by checking your spark plugs.. spark plug wires, coils.. EGR system. If you allow this condition to continue it will ruin youir cats.. a very costly repair. Check to see which cylinder is misfiring.. One of the codes indicated it was #8 cylindler. run the engine and disconnect the spark plug.. if there is no change or very little change in how the engine is running.. try moving the wire to another plug and moving that plug wire to the #8.. If the Problem travels with the wire.. its the wire.. if #8 still has the problem.check the plug and coil... Keep looking until you find the ofending cylinders and repair them.. Check to make sure the hoses are hooked up to your EGR and it is functioning... post a comment here and let us know how you are doing.

May 26, 2014 | Cars & Trucks

1 Answer

2002 Toyota Tundra runs rough (shakes) when first starts up within a mile or two, runs fine. Check-Engine code says misfire 3 and 4. 144,000 miles


It certainly will be cheaper to pay a professional to test the problem for and hundred bucks or so, than it would be to replace parts that may not be needed and or damage other components while driving it until you fix it, and if your not driving it, the cost of a rental car. the problem you have can be any of the following, and until everything is tested it's a wild guess to determine what's wrong.
Coil, plugs, injectors, timing belt, control module, compression/head gasket, coil to plug boot, wires, vacuum leak, etc.

Mar 05, 2017 | 2002 Toyota Tundra

1 Answer

I have a 2004 Freestar and had the oil changed and it immediately started misfiring and knocking, come to find out they put the wrong oil in and have been doing so for 4 years! They are denying that is the...


The type of oil in the engine will not affect the check engine light. The engine light only comes on when something in the engine management system is out of specifications. Any sensor reading out of specification, e.g. oxygen sensor, mass air flow sensor, throttle position sensor etc., will trip the engine light. The only way I can think that the oil changers could be responsible is if they moved or damaged some wiring or a sensor etc. while doing the oil change.

Jul 01, 2011 | 2006 Ford Freestar

2 Answers

My check engine light is on in my 2005 chevy colorado. It came on when the change oil came on. I just got the oil change but the engine light is still on.


HAVE AUTO ZONE SCAN VECHICLE THEY WILL DO IT FREE.CHECK ENGINE WILL COME ON IF YOU PUT TOO MUCH OIL IN TRUCK WILL CAUSE ENGINE MISFIRE OIL WILL GET ON SPARK PLUGS.TRY THIS RESET YOUR CHANGE OIL LIGHT.TURN IGNITION ON POSITION WITH ENGINE OFF.PRESS BUTTON ON BOTTOM OF SPEEDOMETER AND HOLD BUTTON UNTIL 3 CHIMES SOUND.INDICATING RESETTING IS COMPLETE.THEN TURN OFF IGNITION. IF CHECK ENGINE LIGHT STILL REMAIN ON TAKE VECHICLE TO AUTO ZONE HAVE THEM SCAN VECHICLE OR THE PLACE YOU HAD OIL CHANGE.SHOW THEM CHECK ENGINE LIGHT CAME ON AFTER THEY CHANGED OIL.HAVE THEM SCAN VECHICLE SEE WHAT WRONG.YOU PAID FOR SERVICE AND YOU GOT ANOTHER PROBLEM.

Jan 04, 2011 | 2005 Chevrolet Colorado

1 Answer

2001 daewoo lanos check engine light


oil is non conductive so I doubt that's the problem, but the oil leak should be fixed to reduce problems down the road.
as for the misfire could be a couple things, fouled plug(s), a plug wire(s) that has cracks, or even valves that are not seating which i doubt from your explanation.
I would change your plugs and wires first, and fix oil leak. if this does not fix the issue there are other things going on.

Apr 22, 2009 | 2000 Daewoo Lanos

1 Answer

Oil pressure gauge on max - running rough


install a fresh set of plugs. make sure to check them for proper gap, even if they are " pre-gapped "


hope2help shack

Apr 19, 2009 | Jeep Grand Cherokee Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...