How to replace coolant for nissan altima 2006
Park the Nissan Altima on a flat surface and set the parking brake. Next, open the hood and check the external temperature of the radiator. If the radiator is warm to the touch, wait for the radiator to cool before you continue.
Twist the radiator cap one turn to relieve any pressure. Step back from the radiator and allow a few seconds to pass, and then completely remove the radiator cap.
Place a bucket or tray with at least a 2-gallon capacity underneath the radiator and below the drain plug. The drain plug on a Nissan Altima is on the passenger side bottom of the radiator.
Loosen the drain plug and let the old coolant drain completely into the bucket. Take care while loosening the drain plug, because it's plastic and can be brittle. Pour the old coolant into a sealable container for proper disposal later and put the bucket back under the drain plug opening.
Close the drain plug and pour distilled water into the radiator until it's full. Then, open the drain plug and let the water flow into the bucket. Keep repeating this procedure until the water runs clear and debris free into the bucket. You will need at least 3 gallons of distilled water.
Make sure to tighten the drain plug and fill the radiator with fresh coolant. Refill the radiator to within an inch of it overflowing. Check the drain plug and hoses for any possible leaks.
Start the Nissan Altima and turn the heater to the high setting. Let it run for about 10 minutes and shut the engine off. Check the coolant level and refill, if necessary. Finally, put the radiator cap on and close the hood.
Oct 23, 2010 |
2006 Nissan Altima