Question about Ford Ranger

Open Question

I need a 1997 ford ranger fuel pump diagram - Ranger Ford Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: i need a 2002 ford ranger fuse box diagram and afuel pump relay switch diagram

Hi

go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.

Good luck and I hope this will awnser your question.

Posted on Nov 08, 2008

Ad
  • 65 Answers

SOURCE: 2000 ranger fuse diagram

Fuel Pump relay switch is in the main box usually located on the drivers side Fender in a black box. According to the owner's manual in the power distribution box in the engine
compartment (Ford recommends disconnecting your battery)
Relay # 5 is the fuel pump relay , and also in the PD BOX is a 20 amp mini-fuse
for the fuel pump relay + RAP module in location # 9


( P.S. - don't forget your fuel pump inertia switch , in the right front passenger area ,
by the right front kick panel )Sometimes this gets kicked by passenger or if the car is bummed hard it could set this item to shut down fuel system. Best of Luck

Posted on Aug 28, 2009

Testimonial: "I was skeptical, but the answer fit & worked. Thanks!"

  • 13 Answers

SOURCE: where is the fuel pump reset switch in a 1997 ford

fuel pump shut off switch and reset is located on the right hand side floor board underneath the floor carpet, just pull carpet back.

Posted on Sep 26, 2009

sscullys
  • 984 Answers

SOURCE: 1997 Ford F150 Electric Fuel Pump will npt pump

Did you check the fuel inertia switch in the passenger side kick panel ?

The fuel pump is powered :
the fuse to the fuel pump relay.
The fuel pump relay to the fuel inertia switch
The fuel inertia switch to the fuel pump itself.

At the fuel inertia switch in the kick panel, power from the relay is the Dark Green w/ Yellow stripe wire and the pink w/ black stripe wire is the power. from the fuel inertia switch to the fuel pump.

If you jumper the fuel pump relay, you should hear it run. If not pull the fuel pump relay, and check the pins in the relay socket, pin 30 should be the power from the fuse.

50b0c31.jpg

If you have power at pin #30, jumper the relay socket as shown with the red line above, and check the dark green w/ yellow stripe wire at the fuel inertia switch for power.
Press the button on the top of the fuel inertia switch, and check for power leaving the fuel inertia switch on the pink w/ black stripe wire.

This is tests good, check for power at the fuel pump, same pink w/ black stripe wire.
Fuel inertia switch info is in the owners manual, If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Posted on Jan 03, 2010

fordfixer
  • 58 Answers

SOURCE: 1999 ford ranger fuel pump needs replaced.

Hello!

REMOVAL

WARNING:

  • DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY FUEL-RELATED COMPONENT. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE IGNITED, RESULTING IN POSSIBLE PERSONAL INJURY.
  • FUEL IN THE FUEL SYSTEM REMAINS UNDER HIGH PRESSURE EVEN WHEN THE ENGINE IS NOT RUNNING. BEFORE REPAIRING OR DISCONNECTING ANY OF THE FUEL LINES OR FUEL SYSTEM COMPONENTS, THE FUEL SYSTEM PRESSURE MUST BE RELIEVED TO PREVENT ACCIDENTAL SPRAYING OF FUEL, CAUSING PERSONAL INJURY OR A FIRE HAZARD.
  1. Disconnect the battery.
  2. Relieve the system pressure.
  3. Raise the vehicle.
  4. Drain the fuel tank.

cc999cb.gif
  1. Disconnect the fill pipe hoses.
    • Loosen fill pipe hose clamps.
    • Disconnect fill pipe hoses from the fuel tank.

f3fcce3.gif
  1. Remove the 4 bolts (2 each side) and remove the skid plate if equipped.
  2. Support the fuel tank.

918ba9a.gif
  1. Remove the bolts and pivot the fuel tank support straps away from the fuel tank.

e19f38e.gif
  1. Disconnect the fuel pump connector.
    • Lower the fuel tank slightly. Disconnect the fuel pump connector.


958d5a3.gif
Disconnect the fuel supply line push-connect fitting and the vapor tube fitting at the fuel pump


80378e1.gif
  1. Disconnect the vapor line fitting at the rear of the fuel tank.
  2. Lower the fuel tank.

62ccbfd.gif
To install, reverse the removal procedure


df22959.gif Special Tool(s)

REMOVAL

  1. Clean the area around the fuel pump mounting flange.



b28c7f0.gif
  1. Using the special tool, remove the fuel tank pump assembly locking retainer ring.
  2. Remove the fuel pump assembly. CAUTION: The fuel pump assembly must be removed and handled carefully to avoid damage to the float arm and filter.
  3. Remove and discard the fuel pump mounting gasket.
INSTALLATION
  1. Clean the fuel pump mounting flange and the fuel tank mounting surface.
  2. Apply a light coat of Premium Long Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B to the gasket to hold it in position during assembly. Install the fuel pump mounting gasket.

4976d12.gif
  1. Using the special tool, tighten the fuel pump assembly locking retainer ring.

Posted on Mar 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 ford ranger 3.0 wiring diag for fuel sys pump


free wiring diagrams http://bbbind.com/free_tsb.html Enter vehicle info . System - click on engine , subsystem click on fuel controls . Click search button . Click on blue links one at a time till you fine fuel pump wiring diagram .

Oct 02, 2016 | 2004 Ford Ranger

1 Answer

What is the fuse # for fuel pump relay on 97 ford ranger


need to know where fuse is for 97 ford explorer fuel pump

May 14, 2012 | 1997 Ford Explorer AWD

1 Answer

Need diagram for timing belt for 1997 ford ranger


My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/1997/make/ford/model/ranger/1997_ford_ranger_timing_belt_diagram_marks.htm

Oct 29, 2009 | 1997 Ford Ranger SuperCab

1 Answer

Where is the fuel pump reset switch in a 1997 ford ranger xlt


fuel pump shut off switch and reset is located on the right hand side floor board underneath the floor carpet, just pull carpet back.

Sep 25, 2009 | 1997 Ford Ranger SuperCab

1 Answer

2000 ranger fuse diagram


Fuel Pump relay switch is in the main box usually located on the drivers side Fender in a black box. According to the owner's manual in the power distribution box in the engine
compartment (Ford recommends disconnecting your battery)
Relay # 5 is the fuel pump relay , and also in the PD BOX is a 20 amp mini-fuse
for the fuel pump relay + RAP module in location # 9


( P.S. - don't forget your fuel pump inertia switch , in the right front passenger area ,
by the right front kick panel )Sometimes this gets kicked by passenger or if the car is bummed hard it could set this item to shut down fuel system. Best of Luck

Aug 28, 2009 | 2000 Ford Ranger SuperCab

2 Answers

I keep blowing the 30 amp max fuse. I don't know if it is to the ignition or the fuel pump.


look under the top of the power distribution box it has a diagram.
The max fuse blowing means you have a serious short,a hot wire touching ground perhaps it's broken or pinched somewhere.

Aug 12, 2009 | 1996 Ford Ranger SuperCab

1 Answer

I need a 2002 ford ranger fuse box diagram and afuel pump relay switch diagram


Hi

go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.

Good luck and I hope this will awnser your question.

Oct 27, 2008 | 2002 Ford Ranger Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...