Adjust the vertical headlight aim into the specified range by
turning aiming screw A with a screwdriver.
This diagram must be for a different model than the 2008 double cab. There is no screw close to the bottom on the back side of the assembly but close to the top there is a plastic cover over a gear but when I turned it it didn't seem to make any difference. Will know when I take it out for a test run at night to be sure. Thanks anyway.
there should be a gear at the bottom that you use a Philips screw driver to turn right or left and it will adjust some after market replacement lamps reposition this adjust to the top.. has the light been replaced ???
×
SOURCE: on adjusting headlight on 08 tundra does clockwise
clock wise should pull light up. counter clock wise should tilt down
SOURCE: how do I locate the adjustment screws to reaim
located in the lightlight assembly it's self are two screws....one for up and down adjustment, the other for side to side. refer to repair manual for proper adjustment procedure.
SOURCE: how do you adjust the highbeam headlight on 08 G6
there is no separate for the highbeam. Basically, you are forced to use one screw for both and have to compromise
3,015 views
Usually answered in minutes!
×