Question about 2005 Jeep Grand Cherokee

1 Answer

Noise from rear end after having the drive line replaced do to a bad u-joint

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 183 Answers

U joint is probably installed wrong.

Posted on Oct 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rincon. Why is there grinding noise in rear end and rear wheels will not drive?


Could be bad u-joints, wheel bearings. Raise rear of vehicle and rotate wheel by hand, if noisy remove and replace. Hope that helps.

Dec 18, 2015 | Honda Cars & Trucks

2 Answers

REAR END MAKES A LOUD VIBRATING /TREMBLING TYPE NOISE


when was the last time you checked the fluid in your rear hand more than likely you have damaged it

If you need further help, reach me via phone at https://www.6ya.com/expert/james_9c1b039055413ffa

Mar 06, 2015 | Cars & Trucks

1 Answer

Rear end problems


If you are definitely sure it is coming from the rear end you have to remove the rear end cover. You will see the condition of the fluid check the fluid while that is being done. You will have a bird's eye view of the condition of the ring and pinion gears and the pinion bearings. The rumble from the rear end is usually a bad pinion bearing.

If you're not sure it is the rear, another often overlooked problem is the rear universal joint on the drive shaft. You have to remove the drive shaft to check the pinion bearing so you'll find the "U" joint is bad right then and there. If the joint is bad, don't cheese out, get both of them replaced.

Mar 22, 2014 | 2006 Ford F-150 Regular

2 Answers

Loud noise when put into drive


If it is one big clunk then it might just be the universal joint that connects the drive shaft to the rear end. It is very dangerous to drive a vehicle with bad U-joints. If they break the whole drive shaft falls out. If the front u joint breaks it can act like a pole vault for your vehicle.

May 29, 2010 | 2000 Jeep Grand Cherokee

2 Answers

Clanking Noise in rear end,when I start from a Dead stop,


I recommend an inspection of all universal joints or CV(constant volocity) joints, whichever apply on the vehicle! A quick inspection of the rear suspension at the same time should reveal the source of the unusual noises that you describe.
A reputable service shop will do the inspection for free or for a minimal fee.
Have a great day!

Mar 14, 2010 | 2000 Dodge Durango

1 Answer

Noise in Reverse


Transfer case would only be if you are in 4 wheel drive. this sounds like a rear end or u joint issues. Get under the truck and grab the drive line, if you are able to turn it more then a 1/4 inch each way bad u joints. If not then check the rear end.

Jan 02, 2010 | 2001 Chevrolet Silverado 1500

1 Answer

Rear end noise when i let off the throttle


Check the U joints, there more common to go bad then the differential, unless you are low on differential fluids. You can take it to a drive line shop and have them replace the u joints and differential fluid and also have them readjust the ring and pin in the differential to give you more life out of the rear end. Good luck and keep me posted. Be glad to answer any questions you may have.

Aug 08, 2009 | 2004 Dodge Ram 1500

1 Answer

2004 dodge 2500 transmission noise


Check the U Joints in the Drive Shaft and the Rear End. Sometimes the Rear end U Joint can be Bad and sound like the Tranny.

Jan 24, 2009 | 2004 Dodge Ram 2500

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...