An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert that has over 500 points.
An expert who has answered 200 questions.
Re: paint peeling from my bmw
This usually occurs when the bar isnt prepaired properly for painting the car wash could have contributed but it was probably bound to happen if you get it repaired make sure they prepare and prime it properly before painting it
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
several mfg of coatings nowdays offer , spray applied coatings that work on plastic and tin shutters well, ask at your local paint store for them , also make sure you remove the silicone coatings you have applied previously to allow coatings to stick properly
call and ask gm but I would say no- sounds like contaminated primer - if you have time, you can strip and do yourself- brake fluid will easily strip paint- rent booth and shoot it- keep smiling- its only cosmetic
sounds like a port of entry paint repair. A lot of times cars get damaged in transit and the repairs are carried out with out the knowledge of the dealer or the new owner at the port of entry. Usually without much thought of using the right flexable products so the bumper lasts, it looks good but cracks later.
of the Molding
Take the Molding Trim whether it is
stock black or painted. Mine is black because my car is a year 2000.
Painted side moldings were done in the year 2001. Snap them into
place. 5 Installation
of the Rubber Gaskets
From the stock bumper, retrieve the upper
rubber gaskets unless you ordered new ones. Simply take a screw
driver and pry a corner off to get you started. Wash thoroughly.
NOTE which one belongs on which side.
Place the rubber gasket on the M5 Front Bumper onto
its appropriate side. Top
The M5 Bumper is now Fully Assembled!!!
Place aside where it can't be damaged.
hi the only soloution to the top coat peeling is a complete repaint as the top coat is not bonding to the base coat due to bad preperation with is done before you start to paint its a bit like when you paint somrthing at home and can,t be bothered to clean and rub down the old paint work then when it peels yougot to do it again sorry no short cut here any one that says there is is going to do a shoddy job and it will peel again yates210456