Question about 2005 Ford Ranger

1 Answer

Replaced back shopes on ford ranger 2006. seem to drag and squeel even if i back off the drag great for first mile or so but when they heat up the priblen=m staerts

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 341 Answers

You have either the self adjusting mechanisms too tight or the E brake cables are sticking or incorrectly adjusted. It could also be a siezed wheel cylinder as well. I would doubt the later if it was both wheels though I would not totally discount the possibly. Did you get grease, oil, or brakefluid on the shoes?Was one shoe smaller that the other.They could be on backwards.Some brakes have a primary and a secondary shoe.The larger shoe goes to the rear.

Posted on Oct 16, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2006 ford ranger with automatic transmission downshifts going uphill

It would at first blush appear this would be because you are going at a sufficiently low speed and/or the load is that great that it needs a lower gear for the torque needed to apply to offset that load.

Sep 21, 2014 | 2006 Ford Ranger 3.0

1 Answer

1986 Ford Ranger w/39,000 actual miles stalls when going around corners, changing lanes but normally restarts immediately. Otherwise runs great, but wouldn't restart yesterday after sitting for a

at that year, it could have moisture in the line or fuel filter. back then fuel filters where small and see thru usually in the engine compartment.

Jul 22, 2012 | Ford Cars & Trucks

1 Answer

I have a 2006 Ford Ranger and the heat is stuck on on. Even when I move the handle to cool it still heats. Do you have any suggestions, thanks Al Shults.

This problem is caused by one or both of the following parts, one is the air temperature control blend door actuator motor, the next is the actual blend door, the shaft that the electric actuator moves is snapped off due to the door binding, both problems cause no air temperature control and you either get heat or cold with no control to change it. The problem is very common in the Ranger and the Explorer.

Dec 27, 2010 | 2006 Ford Ranger

2 Answers

99Accord NO HP or Tourqe? cant get up to 3500rpms in any gear!

have your catalytic convertor checked. also check your fuel filter first.

Nov 04, 2009 | 1999 Honda Accord

1 Answer

2006 Ford Ranger does not shift into 4WD

have you ever changed the fluid in the transfer case? this should bre done ever 60,000 miles, this may cure the problem.

Oct 19, 2009 | 2006 Ford Ranger

1 Answer

My 1988 Ford Ranger misses while warming up.

COOLANT temp sensor

is bad not allowing engine to run enriched fuel

engine heats up enriched fuel is not needed

proof can be found in fault memory

Mar 02, 2009 | 1993 Ford Ranger SuperCab

Not finding what you are looking for?
2005 Ford Ranger Logo

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides