Question about Ford Crown Victoria

1 Answer

Whenever i put 2003 Ford crown Victoria in gear with a/c or heater on, it pops a fuse then quits working. As long as im sitting still, it will work fine. What could the problem be. My LCM(lighting control module) is also bad cuz my lights doesnt stay on all da time. Could that be the problem?

Posted by on

  • buironhur Oct 16, 2010

    Please send me the wiring diagram. Send it to buironhur@yahoo.com. U said basically the Blower motor Speed Controller or a short on the headlights/Cooling Fan or a bad ground connection?

  • buironhur Oct 16, 2010

    Discard which one? Which 1 is da right 1?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.
    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,796 Answers

Hi
If your A/C has Automatic Temp. Control the fuse that pops is Fuse #15 -15A, for Manual A/C Temp. Control, the fuse is #103 - 40A, the problem may be a lose or corroded Ground connection. Check the Ground Junction on the Front of Right Front Fender Apron, the Blower Motor, Headlamps Circuit, Engine Cooling Fan Motor, among other things get their ground from that Junction. If the Ground contact is not nice and tight, the Blower Motor will overheat, as soon as you add more load to the circuit, the fuse blows to avoid damage to the components.
Another things that can cause this is the Blower Motor Speed Controller or a short on the Headlights/Cooling Fan Motor wiring harness.
If you need wiring diagrams of this systems, please provide an email address. This site only allows images smaller than 150k.
Keep me posted!!

Posted on Oct 16, 2010

  • Rene J Solis Oct 16, 2010

    Never mind, they are the right diagrams, only one of them is going to apply to your vehicle. Discard the other one to avoid confusion.

  • Rene J Solis Oct 16, 2010

    There are for the two types of systems, Automatic or Manual Temp. Control. The diagrams are labeled as Automatic or Manual.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

6ya.com

6ya - Get Instant Help

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can an engine be rebuilt in a 2003 crown victoria police car
Yes it can, there are many parts around for a rebuild, even upgrade some parts, you can also rebuild your transmission too, even change gears. But you can also find used low mile engines around as well as a replacement , These are modular engines , Grand Marquis will work as well

Oct 04, 2014 | 2003 Ford Crown Victoria

1 Answer

Location of wiper motor control module on 2003 crown victoria
See this pic .
ea4f1bb6-5b64-449e-a4b5-d59601a7a3b3.jpg


if this doesn't help please visit this forum for full details.
ELECTRICAL Windshield Washer Motor Fuse Location Crownvic net

Sep 13, 2014 | 2003 Ford Crown Victoria

1 Answer

Why won't the gauges on a2003 ford crown Victoria work
check the dashboard fuse in the fuse box.

Sep 03, 2014 | 2003 Ford Crown Victoria

1 Answer

Dashboard light quit working and heater too and cant lock and unlock doors from inside car but will work with keyless entry
Blew a fuse in the fuse panel by your left foot sitting in the car. Look in the owners manual to see which one is the lighter fuse. It's usually a yellow 20 amp fuse.if you pull it out and look at it,you'll see a wire that loops inside it. If the wire is broken,replace the fuse and keep the screwdrivers out of the lighter socket.Good luck!

Jan 13, 2014 | 1999 Ford Crown Victoria

1 Answer

Where is the heater fuse on the 2003 crown Victoria?
in the fuse panel box it should me marked

Jan 07, 2012 | 2003 Ford Crown Victoria

1 Answer

I need fuse panel diagrams for ford crown victoria 2002 police interceptor
For check passenger compartment fuse panel, is located below and to the left of the steering wheel by the brake pedal. Remove the panel cover to access the fuses.

Other details and descriptrions can find it in 2003 Ford Crown Victoria - Owners Manual (page 164 and next).

Hope helps (remember rated this).

Aug 04, 2010 | 2003 Ford Crown Victoria

1 Answer

Ford crown victoria
you must replace the multi fuction switch! also known as the turn signal switch! its common on ford crown vic!

Mar 06, 2010 | 2001 Ford Crown Victoria

1 Answer

Heater just stoped working on my 2003 crown vic today wut do u think it could be
I am sure you checked the fuse if not look at F1.103 40Amp oryou might check the motor resister assembly.

Oct 15, 2009 | 2003 Ford Crown Victoria

1 Answer

I own a 2003 Ford crown victoria, When I turn the ac or heat on there is no air flow. Other times it just starts up again working normally. Does anyone have a solution? Thanks, Liz
could be a faulty heater ressistor,,,

Apr 21, 2009 | 2004 Ford Crown Victoria

1 Answer

The heater switch quit working, wiper's are fine JUST the
could be the resister tht controls the 4 speeds. It's in te plenum case to keep it cool. Or blower motor is failing

Mar 24, 2009 | 1996 Ford Crown Victoria

Not finding what you are looking for?

View Most Popular

Cars & Trucks

Related Question

Can an engine be rebuilt in a 2003 crown victoria police car

  • 2003 Ford Crown Victoria

Open Questions:

0 Answers

Hi i have replaced clutch kit of ford bantam 1994.i do not have clutch when car is idling?

Apr 23, 2018 | Ford Cars & Trucks

0 Answers

The chain guide on my 1.3 Ford Bantam Rocam motor broke in half. Can it be replace without dismantalling the enjin?

Apr 23, 2018 | Ford Cars & Trucks

0 Answers

my 97 f150 odometer isn't working, the speedometer works fine

Apr 23, 2018 | Ford F-150 Cars & Trucks

0 Answers

I have a Ford Explorer 1998 while driving i heard a loud click and then my engine started to run as if it had no fuel and o2 was off . it chugged til it stalled . when i ooened the hood i could hear a high pitch squeal. I had to leave it for a few days and when i come back the battery was almost dead . what could this be ? I thought it was low oil but it wasnt empty. I feel it most be a relay or switch givin that sound i heard

Apr 22, 2018 | 1998 Ford Explorer

Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

2003 Ford Crown Victoria

1992 Ford Crown Victoria

1997 Ford Crown Victoria

2003 Ford Crown Victoria

2004 Ford Crown Victoria

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Ford Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...