Question about 1992 Nissan King Cab

1 Answer

Speedomoter cable plug has been unpluged and the wires cut

The speedomoter cable has been seperated at the conector plug and the two wires leading to the spedomoter cable have been cut. Will it work for a quick fix to simply splice the wires together. The cable itself is still intact. The conector plug coming off the transmission has a female end and the male counterpart normally housing the wires coming from the spedo-cable has been removed leaving bare wires.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 422 Answers

Hi there, yea for a quick fix that is what i would do. just make sure they wont touch anything metal that would cause it to short out on you

Posted on Aug 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Got stuck in snow today, shortly after check engine light came on it says problem is the speed sensor? What is this?


speed sensor is what monitors speed & milage newer cars are electric older cars are cable operated check to see if wires are broken or plug is pulled off if not it probably needs replacing which is easy to do take bolt out along with clamp twist &pull sensor out &put new one in place put bolt &clamp back on reconnect wire plug & you are done hope this helps

Mar 03, 2013 | Cars & Trucks

1 Answer

Once speed senor is replaced, how do you zero out you speedomoter


IT WILL EITHER BE AN "ECM" RE-SET, OR DROPPING THE NEGATIVE BATT TERMINAL FOR 10 MINUTES MAY DO IT ALSO

Aug 10, 2012 | 2004 Chevrolet TrailBlazer

1 Answer

Car runs and shifts but does not move could this be a sensor?


i had a car that done this it sat for 3 months until i found out that they are 2 different kinds of speedomoter cables one diganel the other a standard speedometer cable mine took the digental if you get under your car an look where the tranmisson is youll see a cable going into the tranmisson if you do its a digintal one an mine was broke at the little bulb that went into the tranmisson an your car will start an shiff gears but it will not move at all replace this an then it will drive a machanic told me i needed a new tranmisson but i didnt so they are 2 kinds of speedomoter cables this was my cars problem

Jun 07, 2012 | 2003 Chrysler PT Cruiser

1 Answer

: A red light of a hand with a car has started flashing underneath the speedomoter and the interior lights won't turn off


First try to remove the red lead from your battey then replace it to reset the onboard programming. If this does not work, return for more solutions to the lights and indicator display.

Jan 27, 2011 | Ford F Cars & Trucks

1 Answer

So if i got a peice of a tree cought under my suv last night and when i pulled it out the abs, brake light, came on and also my speedomoter doesnt work now any suggestions


Sounds like the cable for the speedometer and/or the cable for a sensor was damaged. I wouldn't be surprised if you looked under your car and found a piece of wire dangling somewhere.

Good luck on this repair.

Dec 12, 2010 | 2000 Chevrolet Blazer

1 Answer

I have a 1983 Ford Falcon XE. The speedomoter


You most likely have a faulty speedometer transducer, or loose/poor connections to this unit.
The unit is generally unrepairable - replacement required.
The transducer unit is mounted on the gearbox at the tailshaft drive output.

Oct 26, 2009 | 1978 Ford Granada

1 Answer

2000 Hyundai Elantra--No Cruise Control, etc.


there are alot of harnesses to unplug.they missed a few by the sounds of it.
the cruise control is a cylinder that is vacuum operated and connected to the throttle cable.
check the vacuum lines and the wiring and make sure no wiring has been damaged installing the new engine.look for a plug that has clean looking pins,as the plug on an 8 year old car is clean on the inside.

Jun 13, 2009 | 2000 Hyundai Elantra

1 Answer

None of the instruments in the cluster work (Gas gauge, speedomot


It is possible that the connector came off the back of the circuit board behind the speedometer. Do the lights work IN the speedometer and gauges? Could also be that the ground wire loosened up under the dash, usually on the drivers side. Just some suggestions that I thought might help. Best wishes to you.

Jan 19, 2009 | 2000 Buick Century

Not finding what you are looking for?
1992 Nissan King Cab Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...