Question about Mitsubishi Galant

Open Question

I have a 2000 mitsubishi Galant GTZ V6 3.0L recently when engaged in reverse gear car vibrates but other gears runs smoothly

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: MITSUBISHI GALANT

may be it is the engine that good condition...

Posted on Jul 14, 2008

Ad
MrScary66613
  • 1990 Answers

SOURCE: transmission delayed engagement at cold start

Depending on how Cold it is where you are, The cold will effect the Operation of the Tranny. I am pretty sure that your Tranny is Fine, Just Really Cold. Depending also on where you live, I use Valvoline Quick Change to service my Vehicles when I am on the Road. Have never had a Problem with them. On the Fluid, They make so many Different Kinds now adays that it is hard to Choose. Look in the Back of your Owners Manual and Use what is Suggested in there.

Posted on Jan 25, 2009

greg_margo
  • 1959 Answers

SOURCE: 2001 Mitsubishi Galant Transmission problem?

Could be a few things:

  1. Low on auto transmission fluid; this would cause you to lose a few of the forward gears (reverse is used less often so its the last gear to go Start the car and add fluid to the specified markings on the Auto Transmission dipstick
  2. Bad auto transmission fluid; Check the fluid, if its brown and gives off a burning smell, it needs changing along with the filter
  3. Bad transmisssion; if neither of the above are true, then it sounds like the clutches have burned out on the transmission or the transmission itself is bad; if 1 or 2 hasn't solved your issue the car needs to be diagnosed at a reputable transmission shop; Make sure they lay out all of your options and if you decide to have a major transmission repair done, the Kelly Blue Book value on a similar car similarlly equipted in exellent condition is about $6,800 retail
I hope this leads you in the right direction. Don't be afraid to post back with any questions. Best of luck.
Greg

Posted on May 23, 2009

co7196
  • 3433 Answers

SOURCE: 2000 mitsubishi galant vibrates if not in neutral

sounds like a vacuum leak on engine

Posted on Jun 24, 2009

  • 333 Answers

SOURCE: water pump chang on mitsubishi Galant 2.5 V6

Waterpump replacement requires removal and replacement of your timing belt. Because of this it is not your typical do it yourself repair. Engine timing is critical, and not having your belt set correctly can lead to catastrophic engine damage.

You can purchase a service manual at your local parts store to get an idea of what is involved, however this being an interference engine you should leave this job to a professional if you are uncertain enough about your abilities that you need to ask for help on it. The cost to replace the waterpump is far far less than the cost to repair a engine that had an incorrectly set timing belt.

Posted on Sep 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

V46 mitsubishi pajero reverse gear is not working


run fault codes and look for a reverse solenoid/ servo or TCM fault.

Dec 16, 2013 | 1992 Mitsubishi Pajero

1 Answer

My 1997 mitsubishi galant idles at 1000rpm. soon as on gear(like drive/reverse) rpm drops to 500 rpm and runs rough. if I run the A/C the engine runs rough and seems like it has no power to move on drive...


Have you run an error check on vehicle. You can have this done for free at most auto parts stores. Almost sounds like the idle sensor is having issues, but can not be sure at this point. Make sure the choke isn't sticking or hanging up if carbureted.

Sep 02, 2013 | 1997 Mitsubishi Galant

1 Answer

Galant vrg-gdi-when i engage reverse the car stalls--but once you start moving --ok


You vehicle uses a Idle air control motor,(IAC) when you put a load on the vehicle (Drive or reverse) the ECM detects the load and idles up the IAC, even for the A/C (air conditioner) You can try a throttle body cleaning. or a new IAC

Mar 01, 2012 | Cars & Trucks

1 Answer

Mitsubishi 2000 Galant GLS Inadvertently refuses to access reverse. Mitsubishi have recently replaced clutch ... no improvement. This is like a complete block on entering reverse, but will enter if...


Check the gear linkages for wear at all the joints and connections. Check for worn or missing rubber or nylon bushes or loose connector ends. Have someone hold the gear shift input into the box and move the gear lever, there should be minimal movement except in the neutral position and then only left to right.

Mar 06, 2011 | 2000 Mitsubishi Galant

1 Answer

2000 mitsubishi mirage 1.8 installed a new radiator- took out for a test drive no leaks. then when i put the car in reverse it jumped then i put it in drive and it would not engage 1 2 3 d . i noticed...


you may have broken the shift cable, that's why it shows the vehicle is in park and won't go in any gear.
put your car in neutral with engine off and try to push it. if it does not move then you know it's in park and the cable is broke

Mar 11, 2010 | 1997 Mitsubishi Galant

1 Answer

Won't accelerate properly


HI, sounds like a tranny issue. you will need to check the fluid level in the transmission. if the level is proper, this will confirm gear pack failure. you will need to rebuild the tranny soon. you ca inspect the condition of the transmission by dropping the pan. if you notice any metal fragment on the bottom of the pan, this will confirm major gear friction and failure.

This is major slippage.

May 21, 2009 | 2000 Mitsubishi Eclipse

1 Answer

2001 mitsubishi galant, gear selector all the way to the tranny will go into gear but it's like none of the gears are working. the nuetral safety switch recognizes when it's in park or nuetral


I had a similar problem the reverse gear works fine but when i shift to drive the transmission runs
as if its stuck on third.
My problem was a burnt fuse located in the interior fusebox

May 15, 2009 | 2001 Mitsubishi Galant

4 Answers

Automatic transmission is stuck in 2nd gear (limp mode)


it is eletical eather a fuse is blown or the speed sensor didnt get hooked up dose spedo work

Dec 03, 2008 | Mitsubishi Passenger Cars & Trucks

1 Answer

Galant 2003,Abnormal whinning noise on gear shifting.


I would have the transmission fluid checked to see if it needs any added and if it doesn't it sounds like a bearing going out or something. I would take the car to the dealer, since it's fairly a newer model and see if they can find the source of the problem. they are best when it comes to knowing everything about your car than any other shop around.

Oct 13, 2008 | 2003 Mitsubishi Galant

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...