Question about 2006 Mazda Miata

1 Answer

Will not startl

Did head gasket engine ran for 5 minutes tried to quiet lifters by reving up slighty when i let off gas it stalled abruptly will not start plugs foul imediatly like its geting to much gas took compretion test ok

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 241 Answers

HOW WHERE THE SPARK PLUGS ?? BURNT ? WET WITH WATER ? WET WITH FUEL ?
DO YOU HAVE PRESSURE ON YOUR FUEL SYSTEM.

Posted on Jun 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 mazda4cycl over head cam knocking noice like a lifter noise or bent rod when reving but noice cycles knocks a minute an stops for a minute an starts and stops


Hi Troy I owned a motor bike years ago and I had the same problem, It would start off with a quiet knocking sound and get louder then suddenly stop but start up quietly again and again and so on which turned out to be the timing chain was worn.... SERIOUS mate. Good luck......

Apr 17, 2016 | Cars & Trucks

1 Answer

2001 jeep ran hot and cot off and was not registering hot and now lifter is tapping


Hi here is a quick fix for the lifter tapping. Try adding 4 Oz. of tramsmission fluid to the motor oil , and run the engine for two minutes at 1500 RPM. This should quiet the lifter tapping.It works everytime i come across this problem.

Jun 27, 2014 | 2001 Jeep Grand Cherokee

1 Answer

I have a 1992 ford ranger it has a 2.3L four cylinder engine.it has a ticking noise so i think its a lifter.its real bad when i first start it and slows alittle bit when the engine worms up,the ticking...


Before you change lifters try this trick. Drain 2 quarts of oil from the engine and top it off with auto trans fluid. Let the truck idle for 45 minutes or until quite , then change the oil and filter. I have made many lifters get quiet this way and it will not damage engine.

Jan 30, 2011 | Ford Ranger Cars & Trucks

1 Answer

Why are the lifters of my pajero io noisy


those engines are known for lifters draining in order to restore them you must run the engine rpm about 2000 rpm for 5 minutes .they shoudld quiet down mitsubishi says to run them at 4000 rpm for 10 min,but i rebuild *** engines for 20+ years i dont recomend this with out causing damage to eng just hold the rpm to 2000 until the get quiet make sure you have fresh oil and the engine as good oil press

Aug 28, 2010 | 2000 Mitsubishi Eclipse

2 Answers

All lifters started clicking at once


Sounds more likely to be a timing rattle rather then all the lifters at once making noise, if your EGR valve is bad this will happen and if the timing is off it will also do this, I can't buy the theory all 16 hydraulic lifters are noisey unless you over reved it something fierce, or ran it out of oil, or had someone loosen all the rockers.
Happy Motoring!!

Aug 04, 2010 | 1998 Chevrolet C1500

2 Answers

I have a 1998 chevy 2500 4x4 6.5 diesel pu.truck starts and seems to run normal ,maybe a little loud, i heard chevy diesels this year are louder than fords etc. blows a little white smoke at startup some...


the head gaskets are blown you can believe that anytime on any engine gas or deisel that you get oil in the radiator and there water/ antifreeze in the oil pan the gaskets and or cylinder heads are bad

Jan 20, 2010 | Chevrolet 2500 Cars & Trucks

2 Answers

Will not start after it stalls untill about 5-10 minutes


spray carb cleaner on the intake manifold near cylinder 1... common problem is the intake manifold gasket leaks vacuum causing a misfire...the not starting could be due to a faulty crank sensor

Feb 27, 2009 | 2002 Saturn Sl

2 Answers

1997 Accord overheats and rpm revs from 1000 to 2500 continuosly


If you have runaway reving, you probably have a clogged MAP sensor.

Feb 13, 2009 | 1997 Honda Accord

Not finding what you are looking for?
2006 Mazda Miata Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...