Question about 1991 Chevrolet S-10 Blazer

1 Answer

2002 chevy trailblazer

My key gets stuck in the ignition when I try to start the car and all of the energy is gone from the vehicle. There is no energy going back to the vehicle after I try that and the key is still stuck.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 92 Answers

Spray some wd-40 into the ignition not allot though. if that dont work get back to me.,

Posted on Dec 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jump start trailblazer will run that day but next day it is dead there is a short some where


2006 Trailblazer won't start - Discussion on Topix

www.topix.com > Chevrolet TrailBlazer
Sep 6, 2012 - My 2006 Trailblazer will not start, bought a new battery, still will notstart, not even with a jump. ... i get a jump i drive it and charged the battery it seemed fine but then i went ... Then, next morning, when I turn key, all lights come on and radio... back a day and 360$ well that pos still will crank but will not start. 02 trailblazer a/c problem
Jul 21, 2011
2003 trailblazer key is stuck in ignition
Dec 21, 2009
2003 Chevy Trailblazer will not start
Jul 21, 2009
2002 trailblazers won't start
Aug 24, 2007
More results from www.topix.com

Oct 29, 2015 | 2005 Chevrolet TrailBlazer

1 Answer

Why can't I turn the ignition key all the way off in my 2002 Chevy Trailblazer?


Your Trailblazer may be one of the many GM vehicles recalled because of defective ignition switches.

Mar 05, 2015 | Chevrolet Chevy Cars & Trucks

1 Answer

Cant find the key release on 2006 chevy trailblazer. Key stuck in ignition


There is no key release on that vehicle. The key should come right out. Has the key being bent or twisted before? Also make sure steering wheel is not turned all the way to one side or the other.

Sep 13, 2010 | 2006 Chevrolet Trailblazer

2 Answers

2003 chevy tahoe with key stuck in ignition. vehicle previously broken into and stolen with scewdriver to ignition. ignition replaced. key now stuck and cannot turn vehcile off. can shift to driver,...


I have towed several of these with same problem. Sounds like to me it needs to go back in for the ignition switch again. Unless it's not going into park. If it's not going into park it would be a shift linkage issue and needs to be adjusted. Chris J.C. Towing & Recovery

Apr 09, 2010 | 2002 Chevrolet Tahoe

2 Answers

Key stuck in ignition of Trailblazer.


There is a small 1/4'' oblong cover plate on the underside of the stearing column. Pop this out and there is a button you push in ( like the Crysler key relase) and this will allow you to remove the key.

Dec 22, 2008 | 2002 Chevrolet TrailBlazer

2 Answers

Key stuck in ignition of 2002 chev. trailblazer


Remove the cover of the switch, there is a silver button below the place where you put the key. Press it and the key will be released!

Dec 21, 2008 | 2002 Chevrolet TrailBlazer

1 Answer

2002 chevy trailblazer


i have the same problem i think its a saftey hazzard when i went to start my car it was dead and the key would not come out and i couldnt shift it in (N) to move it even the button that u push to shift out of park didnt work

Jul 27, 2008 | 2001 Pontiac Grand Prix

4 Answers

Ignition switch on a 2002 chevy trailblazer


under the steering column, there are three or four little holes in the plastic covering. If you look inside, one of them (the one on the right side toward the dash) there is a brass pin inside. This is the pin to release the key. As far as the key not turning, I have had the same problem. The first time I replaced the ignition switch and that solved the problem. However, this makes no sense because the ignition switch has nothing to do with the tumbler being locked. GMC thinks that my anti theft system, which is inside the ignition cylinder is the problem. By removing the ignition switch, it reset the pass lock anti-theft system and temporarily fixed the problem. So, try removing the ignition switch and then plugging it back in. If that doesn't work, your in the same boat as I am, and we may both need new ignition cylinders.

May 26, 2008 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
1991 Chevrolet S-10 Blazer Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...