Question about 1995 Chevrolet Corvette

1 Answer

I have a 95 corvette, after turning on the ignition I get a "SYS" prompt on the drivers invformation panel next to the fuel and other guages information. Do you know what might be the cause? The manual says possible electrical problem. Is there any other information on this.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 265 Answers

Check your battery terminals, or your battery itself... SYS .. is just letting you know that something electrical is going bad.. I know it happens alot when people install aftermarket stereo systems in these cars ...

Posted on Oct 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i shut off 72 chevrolet the gas guage falls past full not em


Well, short of the gauge being defective, there might me a voltage regulator on the back of the instrument panel causing your issue.

May 03, 2010 | 1972 Chevrolet Corvette

1 Answer

On a 95 chevy truck. the fuel guage goes to E with any motion like turns stops . Had sending unit in tank replaced . No change in problem...


the fuel guage will only be accurate on level ground,, when you stop or go around the corner the fuel sloshes around in to tank causing the level at the float to change,, thus the guage reads different

Mar 28, 2010 | Chevrolet 1500 Cars & Trucks

1 Answer

Purchased a new clicker.from g/m.i can't program it.i have replaced the transformer under the dash panel that was used.. i have been told 96 models has several transmitters on it.


1. Move all Keyless Remotes out of range of vehicle. (10 to 15 feet)
2. Turn ignition key to the ON position.
3. Push the TRIP/ODO button on the DIC (Driver Info Center) twice.
4. Within 5 seconds, push & hold the FUEL INFO button on the DIC until
the PKE light comes on and stays on.
5. Turn the ignition to the OFF position, but leave the key in the ignition.
The PKE light will begin flashing.
6. Bring one Keyless Remote into range. The PKE light will stop flashing
and stay on to show the code is stored. Move the Keyless Remote out
of range. The PKE light will begin flashing indicating the system is ready
for the next Keyless Remote.
7. If more than one Keyless Remote is being programmed, move the first
Keyless Remote out of range and repeat step 6 for any additional Keyless
Remotes. Up to three Keyless Remotes can be programmed.
8. To turn off the programming mode, simply remove the key from the ignition
or turn the ignition switch on.
9. The programming mode will shut off after two minutes if.
A) You have not programmed any Keyless Remotes.
B) Removed the key from the ignition.
C) After three Keyless Remotes have been programmed.

Good luck and keep me posted.

Jan 23, 2010 | 1996 Chevrolet Corvette

1 Answer

Is anyone else having problems with their fuel guage


theres a recall on guage cluster it should be covered

Jan 08, 2010 | 1998 Chevrolet Corvette

1 Answer

Fuel Sending Unit


You do need to replace the guage sending unit in the gas tank, u must remove the gas tank, this is not really a job for a DIYer.

Mar 08, 2009 | 1996 Volvo 960

1 Answer

Sys light comming on


SYS means that there is a malfunction and that it's registered in the car's computer. You need to have the system tested for fault codes.

Apr 02, 2017 | 1992 Chevrolet Corvette

1 Answer

95 jeep yj wont start


have you checked the fuel pump ? the fuel pump is in the fuel tank and it may be that the fuel guage inside the tank is broken and or not attached to the pump. This is a big job but with a little help from buddys and a bit patients it can be repaired.

Jan 31, 2009 | 1995 Jeep Wrangler

1 Answer

Fuel guage reads 1/4 at all times even when full. How do I repair


1.If the needle on the guage is stuck. you can try tapping the guage to see if the needle moves or turn the ignition on and off a few times to see if you can get it to move. If the guage drops to empty when you turn off the ignition you know that its not the guage. (note that the guage does not drop to zero when ignition is off with all cars of this age).

2. The problem could be with the sensor in the fuel tank itself. Rocking the vehicle up and down from the rear (you will need help doing this) may free the sensor level indicator ball in the tank.

Dec 17, 2008 | 1983 Jeep CJ7

1 Answer

95 buick park avenue ignition problem


What is the fuel pressure it has to be at least
  1. Ignition "OFF" for 10 Seconds.
  2. With ignition "ON," engine "OFF" and fuel pump running, pressure should be 333-376 kPa (48-55 psi). For additional fuel pressure testing, See: Computers and Control Systems\Testing and Inspection\Symptom Related Diagnostic Procedures\A - E Charts & Related Test Procedures\A Charts\Chart A-7 Fuel System Diagnosis
  3. Have you tested the compression?
  4. A totally plugged cataltic converter can cause tis too because the engine cannot breathe
  5. to verify a plugged cat connect a vacuum guage to manifold vacuum and ccrank the engine you should get at least 2-4" of cranking vacuum providing the timing chain has not jumped and the cat is not plugged
If you find this information helpful please give me a good rating

www.aceautomotive1.com

Aug 16, 2008 | 1995 Buick Riviera

Not finding what you are looking for?
1995 Chevrolet Corvette Logo

Related Topics:

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...