Question about 1997 Plymouth Grand Voyager

Open Question

Does the 1997 Plymouth Voyager have a tachometer port somewhere eventhough there is no tachometer gauge in the dash? I'm thinking of adding a tach and was hoping I might find something under the dash as opposed to running a wire to the coil.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: fan relay

I had this problem with my 98. There is a relay mounted on the wheel well below the battery. There is also a relay in the ecm. The engine computer. Hope this helps.

Posted on Aug 12, 2008

  • 99 Answers

SOURCE: 1997 plymouth voyager radiator fans

I don't believe your particular vehicle's cooling system needs to be bled during coolant filling, but check the coolant level first. It seems that the coolant level is too low for the sensors to be able to sense the temperature, or the sensors are disconnected. Look for a connector on the intake manifold, near the coolant outlet. Ensure it is properly connected.

Posted on Aug 17, 2008

tommyboinow
  • 324 Answers

SOURCE: tachometer gauge

your relay is going bad, replace it.

Posted on Nov 26, 2008

heavymetal77
  • 721 Answers

SOURCE: Car: Nissan Maxima SE 1997 tachometer broken

the dash voltage egulator probably went bad. First,check the battery & make sure you have 12 volts,not running. Check it again running & you should see about 14.5 volts. If that's good,I'd replace the guage assembly.

Posted on Jun 28, 2009

  • 523 Answers

SOURCE: 1998 Plymouth Grand Voyager instrument cluster problem

There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
As I fore mentioned I had the exact same issue as you are describing, our is a 99. The most tricky part is the dash, take your time with it.
I hope this may have assited you,
Tom

Posted on Oct 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Gauges in my 97 Plymouth voyager quit working my gas gauge odometer temp gauge what sould I do ???? I took my dash off and plugged it back in and it started working some how I un plugged it when...


I am assuming you have it back in. If it is still working, I would fasten the plug to something solid to keep t attached. These things can be annoying sometimes especially working under the dash.

May 10, 2015 | 1997 Plymouth Voyager

1 Answer

97 plymouth breeze speedometer,tach gauge,temp gauge,brake lights, dont work.


circuitry behind the gauge panel. you will have to pull the dash to see behind there and track the problem down

Nov 28, 2013 | 1997 Plymouth Breeze

1 Answer

1997 plymounth grand voyager. My airbag light is on! Is there any recalls? Also my dash gages quit working.


Recalls only go back ten years. since you are having other dash problems, it probably time to replace the dash panel. They have computer chips in them that run most all the gauges and warning lights. I would get one from the salvage yard. they can tell you what years will work in the van

Oct 02, 2011 | 1997 Plymouth Voyager

1 Answer

1998 Plymouth Grand Voyager.........Dashboard instruments quit working and don't light up. Speedo, tach, fuel gauge, temp gauge, and mileage indicators and lights for same stopped working. ABS...


You have some wiring problems shorting out that is coming from the dash board so if you or anyone you know how to use a multimeter to check the wireing harnesses plus check any connectors that might be just very touching the connector of dashboard which means a bad connection to dashboard.

Jun 04, 2011 | 1998 Plymouth Voyager

1 Answer

Entire instrument cluster in my 97 plymouth voyager not working


To fix the dash going out try this. This is a common problem with the voyager,caravans and Town & Countrys. What the problem is is a cold soder in the interment cluster itself. The problem area is where the plug comes from the van into the cluster. You need to take the circuit board out of the cluster and reheat the soder on the back side of the circuit board were the plug plugs into. This will fix the cold soder permanitly I think its about 16 pins you have to reheat with the soder gun. If you don't feel comfrotable doing that you can just replace the interment cluster and it will be fine but if you buy a used one make sure it was tested. This also may fix the ABS light and the airbag light. Hope this helps I have done several of them.

May 12, 2010 | 1997 Plymouth Voyager

1 Answer

None of the dash gauges work including the speedometer and tach. any suggestions?


check the fuses, if they are all good, test relays with ohmmeter

Jul 10, 2009 | 1998 Plymouth Grand Voyager

1 Answer

Dashboard gauges out


There was a recall years ago on the ignition switch. Something wears and causes the switch to catch and hang a little so it doesn't spring back all the way to run position. The car runs but some of the other contacts are out of line or something. On mine it only happens occasionally and if I nudge the switch backwards just a little bit the dash lights and everything start working as it should. Or just shut it off and restart. Or go ahead and replace the switch itself.

Jul 03, 2009 | 1997 Plymouth Grand Voyager

1 Answer

I have a 1998 plymouth voyager and the insturment panel and gauges and wipers and locks stopped working how could this be fixed


you have to replace the " body control module " located under dash drivers side. and most of time they have to be reprogrammend unless you buy it new from dealer and they do it before you get it. the body control mod controls all those items and go bad alot.

May 25, 2009 | 1997 Plymouth Voyager

1 Answer

HELP! Problems on my 1997 Grand Caravan P1698, P0138, P0140


you need to go over your entire wiring harness, under the hood and inside the dash. Start with the ground wire on the battery and work your way inside. It sounds like there is a loose ground wire somewhere

May 06, 2009 | 1999 Plymouth Grand Voyager

Not finding what you are looking for?
1997 Plymouth Grand Voyager Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...