Question about 2001 Mercury Villager

1 Answer

Where can i get a lower priced fan switch (part # YH1498) for 2000 Mercury Villager. Thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

Ebay for sure, or through me at 10% over cost.

go here too for tech help

http://groups.yahoo.com/group/villagerquest/

Posted on Oct 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is crankshaft pisition sensor for 1995 mercury villager


1995 Mercury Truck Villager Van 3.0L EFI SOHC 6cyl

The Crankshaft Position Sensor is located: Under hood, passenger side, lower engine area, front of crankshaft pulley, mounted in engine block.

Jul 22, 2015 | Mercury Cars & Trucks

3 Answers

Where is the cooling fan temperature switch in a 1997 Mercury Villager...cannot find a diagram


dnt think there is 1 m8 its controlled by engin when it gets to curtain heat it turns on

Jul 31, 2014 | 1997 Mercury Villager

1 Answer

Where exactly is the inertia switch on a 99 mercury villager


go to villager-quest yahoo group for more help

Inertia Fuel Shutoff (IFS) Switch Removal
  1. Remove the LH scuff plate.
    gh2340a.gif
  1. Remove the LH lower A-pillar trim panel.
    gh2341a.gif
  1. Remove the inertia fuel shutoff (IFS) switch.
    1. Disconnect the electrical connector.
    1. Remove the screws.
    gv1421a.gif

Sep 30, 2011 | 2000 Mercury Villager

1 Answer

A/C fan switch only works on high


it's your blower motor resistor in the plenum case. They usually blow the thermal limiter because the blower motor is drawing too much current. It's starting to go.
You can replace the resistor, 2 screws under the dash on the passenger side. It has a 4 or 5 wie connector. About $25 from a Ford or Mercury dealer.
Also go to the Villager site for more help.

http://groups.yahoo.com/group/villagerquest/

Jun 15, 2010 | 2001 Mercury Villager

1 Answer

How do ypou change out the blow fan in a mercury villager 1999


There are 3 screws holding it in. But, you have to remove lower center console (4 attachments, 2 on each side), then remove center trim above console, then remove glove box, then remove 2 ft long steel brace beow glove box, then remove blower. 2 hour job. one screw is hidden by carpet, pull carpet outward for access.

May 29, 2010 | 1999 Mercury Villager

1 Answer

Heater blower will not run


Check for 12v at the blower motor connector,

If no current then the switch is bad, or the relay is bad.

Obviously check your fuse as well.

Could also be your blower motor resistor if the fan only works on high speed on not the lower speeds.

Apr 01, 2010 | 1999 Mercury Villager

1 Answer

I have a 1999 mercury Villager . I was adjusting the brake light switch by the brake pedal and i notice another switch controlled by the foot pedal. What does this switch control? Thanks.


please rate highly if this helps.

also, go here for villager help anytime.

the deactivator switch (deactivates cruise control when you tap brake pedal) and brake pedal position (BPP) switch electrical connectors.

May 10, 2009 | 1999 Mercury Villager

1 Answer

1996 Mercury VIllager


power window has 30 amp fuse in fuse panel on left lower IP behind removeable panel.

There are a bunch of relays under hood by battery and by passenger side fender

Jul 30, 2008 | 1996 Mercury Villager

Not finding what you are looking for?
2001 Mercury Villager Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...