Question about 1990 Dodge Ram

1 Answer

Need a picture schematic for fuel lines front to back 1990 350hd trk 360 engine/auto trans.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,016 Answers


These should help you out.

Need a picture schematic for - 089db70.jpg

Unfortunately this is as much of a diagram you can get as there is no actual fuel line diagram as such for this vehicle.

Let me know if you need more information.



Posted on Oct 15, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need schematic for fuel system 1989 fleetwood bounder

WELL, if it is a gasoline engine (you did not specify), there isn't much to the "fuel system..." only a single line with one or two pumps routing fuel to the fuel pressure regulator, and a single fuel line from the fuel pressure regulator routing bypass fuel back to the tank. Oh... and the fuel rail and injectors, which are all connected to the fuel pressure regulator.
If it is a diesel engine, it is even simpler!
Why would you need a diagram??

May 21, 2015 | Cars & Trucks

3 Answers

Transmission fluid leaking for front bumper 2002 jeep grand cherokee

most likely it is leaking where it connect to the Trans cooler behind the front grill. If the trans lines use clamps you will most likely just need to tighten them up. If it uses quick disconnect fittings you will need to buy a set of quick disconnect tools about 10$ at auto parts store pull the leaking line off and replace the seal inside the line. Good Luck I hope that helps.

May 10, 2014 | 2002 Jeep Grand Cherokee

1 Answer

1996 Ford Explorer front end makes noises after putting it in 4wd lo and red lining the engine, whats wrong with it?

You have to be in park or be in drive or moving slowly to
engage 4 wd

You can not have the trans in neutral to use 4wd or have the
transfer in neutral to shift trans

Either combo you grind gears in trans or transfer

Dec 12, 2012 | 1996 Ford Explorer

1 Answer


that would be on the drivers side under the trk on the rear of engine and on the front of trans, a round 4" diameter cylinder aprox 8" long

Jan 13, 2011 | 1999 Ford Explorer

1 Answer

How do you remove a transmission out of a 1995 Lincoln town car. The engines a 4.6

1 jack car up far enough to work under car use jack stands to support care during work for safety
2 Disconnect all fluid lines and electrical wires.
3 Disconnect trans from engine leave one bolt loosen on right and left side
4 place floor jack trans for support
5 disconnect drive shaft from transmission (there are two point in this process disconnect from rear axle housing an slide the drive line out from trans if this does not work disconnect drive line ujoint closes to trans also
6 Disconnect any trans linkage and supports remove bolts from
trans engine connection while supporting the trans with floor jack. while removing trans pull backward and be aware that the toque converter is in the front housing of trans and will fall out if front of trans is facing to far downward.
I recommend you use an auto manual to read up on this process before taking it on.

Oct 04, 2010 | 1995 Lincoln Town Car

1 Answer

Changing the fuel filter

Your gas tank is in the back of your car between the frame rails. The fuel line runs up toward the engine along the drivers side frame rail on the inside of the frame rail. The fuel filter is located along that fuel line inside the drivers side frame rail, about at the back of your front door. You should be able to trace the fuel line all the way to the intake of your engine. Once you locate the fuel filter, you will need a special tool to remove the filter from the line. You should be able to get the 'fuel filter tool' at your local auto parts store for under $10. The tool has a flanged end on it, and it 'scissors' open and closed. Place the proper sized end on your fuel line just in front of the filter so that the flange sticks in toward the filter. Gently push the tool in toward the filter, while pulling back on the fuel line. The line should come disconnected. Remember, the fuel line is pressurized and may spray gas for a second or two when it comes apart. Then do the same to the other end of the fuel line. Good luck. Any problems, write back.

Jul 31, 2010 | 2002 Ford Escape

2 Answers

I ran over a large rock during a recent snow storm. There are 4 lines that run from the engine area to the back=possible fuel line? One of the lines was compressed. What are the four lines? Do I need to...

I am not familiar with the Yaris, having never worked on one, but a steel line from the engine area back could be: transmission cooling line (automatic trans.), or a brake line, or as you stated, a fuel line. You need to follow the line forward and backward for a clue to there beginning or end to help determine what it is. A brake line would go to the back of the wheel, and to engine compartment to master cylinder on firewall, a fuel line would go to the gas tank, to engine compartment, trans. cooling line would go to trans to radiator.
Yes, if the line was crushed and compressed by striking the rock, you should have it repaired. It would limit whatever fluid travels through it, which could cause problems (insufficient cooling for the trans., brakes not working due to no fluid to brake caliper/cylinder, engine starving for fuel due to restricted flow.

Mar 17, 2010 | Toyota Yaris Cars & Trucks

2 Answers

Wheres the fuel filter located at,on a 1988 dodge D250 ram truck 360 V8 auto trans.

follow the fuel line up from the gas tank and you will find a round canister this is the filter also it is usually located on the driver side under that area

Nov 13, 2009 | 1988 Dodge Ram Wagon

1 Answer

Fuel supply on 1976 CJ-7

Large amounts of unburnt fuel is most likely what your seeing in the exhaust at first start up.Have you had the carburator rebuilt?Pull your plugs before you start it and look and smell for unburnt fuel.This may be solved by leaning the carb out or replacing or adjusting the float/needle valve,and check all the fuel line connections.As far as the fuel supply line shape this is not a problem,a good fuel pump and supply lines should not lose it's prime and not allow the fuel to drain back regardless of shape or routing.

Jun 01, 2009 | AMC CJ7 Cars & Trucks

Not finding what you are looking for?
1990 Dodge Ram Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides