Question about Chevrolet Blazer

Open Question

How do i pull the abs fuse on a chevy blazer 1997 and where is it

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ewashmidas
  • 362 Answers

SOURCE: 2005 CHEVY +TRAIL BLAZER ABS AND BRAKE LIGHTS ON

When the ABS light is on when driving there is a problem in the anti lock brake system and you will need to have it tested to find out what the problem is. As long as the light is on the ABS has been shut off by the computer until it is repaired. There could be problems with one of the wheel speed sensors, wiring or the ABS pump. On some vehicles the red brake light will come on too.

Posted on Jan 28, 2009

Ad
  • 47 Answers

SOURCE: need to replace rear brakes on 1997 chevy blazer

disk or drum?

Posted on Jun 23, 2009

johnjohn2
  • 5763 Answers

SOURCE: 1997 chevy blazer heater does not blow already

check the blower motor resistor, it on passenger side under dash bolted to heater box, those go bad often, hope this is helpful.

Posted on Nov 25, 2009

  • 2841 Answers

SOURCE: I have a 1997 chevy blazer the hazards work fine

Replace the Turn Signal Flasher Relay. It has 2 relays. One for the Hazard lights and one for the Turn Signals. The Turn Signal Flasher Relay is located Front seating area, driver side, passenger side of steering column, under dash, mounted near cigarette lighter. Optional mounting location is under dash, on driver side of steering column. (Curtorsey Auto Zone)

Posted on Dec 15, 2009

  • 48 Answers

SOURCE: My 1997 Chevy Blazer ABS light comes on and then

One of the wheel speed sensors is going bad probably. If the brake is shuddering when pressed like when the ABS kicks in then the sensor is bad.

Posted on Jun 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 1997 Chevy Blazer ABS light comes on and then shuts off but does it regularly. Also it makes a noise on the front brakes when using them. What could be the problem?


One of the wheel speed sensors is going bad probably. If the brake is shuddering when pressed like when the ABS kicks in then the sensor is bad.

Jun 13, 2010 | 1997 Chevrolet Blazer

1 Answer

1997 chevy s10 blazerdash wont light up when key


the dash sound's like a fuse, check the fuse box under the hood and in the door jamb on the side of the dash, also check your fuel filter and fuel pump, im betting on the pump because i have a 2001 chevy blazer that has had two replaced and it has 233000km on it!

Jun 04, 2010 | 1997 Chevrolet Blazer

1 Answer

What does a ABS sensor look like on a 97 chevy blazer


mid size blazer- take off wheel-brake caliper-brake caliper bracket- rotor-and behind the hub u will see a wire going into the back of hub and is secured by a hex/torx head bolt that is ur abs sensor it looks like a small cylinder with wires attached---on the s-10 blazer some of the abs sensors set ups-- are part of the hub assembly/wheel bearing would have to change the whole unit

Mar 05, 2010 | 1997 Chevrolet Blazer

1 Answer

I want to disconnect the abs system on a 2000 chevy blazer 4wd, how do i do this and can I


You can disconnect it by just pulling the fuse out for the ABS sytem. The fuse will be located at the end of the dash on the drivers side. Note that the ABS light on the dash will come on that will indicate that your ABS system is not working. You can ether live with it on, or pull the light out from the instrument panel. Good luck and this should help.

Feb 27, 2010 | 2000 Chevrolet Blazer

1 Answer

Flex plate or terk converter on a 1997 Chevy Blazer for sell


Fly wheel or torque converter,either way your pulling out the transmission,very costly!

Nov 25, 2009 | 1997 Chevrolet Blazer

1 Answer

Where can I find a brake proportioning valve for my 97 S-10?


When people tell me they hate there ABS, alot of people who pull trailer do. I tell them just to pull the fuse this will stop them completely. Yeah theres a light ont he dash but that can alos be delt with by removing the bulb for it. But int he long run just pulling the fuse is quick and Free.

May 17, 2009 | 1997 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...