Question about 2001 Ford Mustang

1 Answer

My top goes down when i push button but will not go up its a 2001 mustang gt

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 36 Answers

It is most likely your switch when you try to raise the top push a little harder and see if that makes it try to raise up the top, what you are doing is reversing the hydraulic rams in the trunk, if when depressing the switch you hear clicking from the trunk you may have a bad relay.

Posted on Oct 14, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 pontiac grand prix gt moonroof only goes up and down from back


did you try to push the button again after you pushed it to get the back of it to go up? i know with my 01 prix one push pops it up than pushing it again will make it slide open.

Jan 03, 2012 | 2001 Pontiac Grand Prix

1 Answer

Need diagram of vacuum line that comes out of the back of the throttle body.a/c heater control.2001 mustang GT.


I have a 2001 mustang gt with ac i dont have air comming out of the front vents so i bought heater controls and no difference then i found a yellow vacume line off but cant find where it goes can any one help me !!!!!! thanks mary

Aug 08, 2010 | 2001 Ford Mustang

1 Answer

I HAVE A 2001 FORD MUSTANG GT THAT WON'T START, I ALREADY REPLACED THE FUEL PUMP AND FUEL PUMP DRIVER MODULE, IT HAVE SPARK AND CURRENT GOING TO THE FUEL PUMP BUT NOT GROUND OR PULSE TO THE INJECTORS


Before you go any further open the trunk and check the fuel pump roll over valve switch, mounted on the left side inside the trunk, push the switch down and try the vehicle.

Jun 05, 2010 | 2001 Ford Mustang

3 Answers

How do you put down the top on a ford 1998 mustang convertible


Make sure the parking brake is engaged first. Then just push the button next to the parjing brake.

Mar 27, 2010 | 1998 Ford Mustang

1 Answer

Need to know how to put the top down on 96 mustang dont have manu


First thing to do is put the car in park and then set the parking brake. Next, release the drivers and passenger side handles (located at the top, above your head when you are sitting in the car, where the part of the top meets the windshield) Both handles are black and you simply pull the lever to release the hooks. After both hooks are released, push the button located near the speedometer (should be underneath the speedometer) on the dash and the top motor will engage and begain to retract the top. Hold the button untill the top disapears behing the back seat

Feb 28, 2010 | 2007 Ford Mustang GT California Special...

2 Answers

Mustang 2001 convertible top goes up but not down.


Sounds like the switch is bad. Also check the relays. You might have one for up and one for down.

May 23, 2009 | 2001 Ford Mustang

1 Answer

2001 Mustang GT convertible won't go up


You are probably low on fluid.
Behind the rear seat is your motor/pump/reservoir combination.
With the top down, fill the reservoir to overflowing with ATF.
Cycle the system a few times and repeat.
Do this till the reservoir will take no more fluid.
Check the lines and cylinders for leaks. The fluid must be going somewhere.
If you replace any lines or cylinders, always do them in pairs.
Karl at Topgunwon.com

Sep 29, 2008 | 2007 Ford Mustang GT California Special...

1 Answer

2001 Mustang GT rear brake job


yep this is a two man job, onece you get air in the lines is better to do all four, my has abs and i was able to do it, but next time don't take anylines lose just turn the piston clockwise and you should be able to push it in.

Sep 11, 2008 | 2001 Ford Mustang

Not finding what you are looking for?
2001 Ford Mustang Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...