Question about 1999 Dodge Durango

Open Question

My cruise control on my 2000 dodge durango will not work what could cause this not to work?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1999 Dodge Grand Caravan horn and Cruise control

I recently had the same issue, but my airbag warning lights also turned on. If this is the case, it might be the clockspring. There is a recall on clocksprings for Caravans 1998 - 2000 I believe. I got it replaced for free in the dealership. Enter your VIN in this site and it will tell you if you are covered in the free replacement warranty.
http://www.chrysler.com/webselfservice/chrysler/index.jsp?screenName=recall&country=us&emailUrl=goToEmailForm%28%27R%27%29

Hope this helps.
Sonny

Posted on Mar 06, 2009

Ad
  • 51 Answers

SOURCE: 2000 Dodge Van 3500 Cruise Control Doesn't work -

is your air bag light on and does your horn work this would also indicate a bad clock spring.

Posted on Mar 16, 2009

emissionwiz
  • 76070 Answers

SOURCE: fuse location for cruise control on a 2000 dodge caravan

The cruise has no dedicated fuse, you will most likely be looking to replace the clockspring rotating contact located under the steering wheel which connects the switches in the steering wheel (horn, cruise and air-bag) to the rest of the electrical system.

Posted on Apr 02, 2009

  • 1 Answer

SOURCE: my 2000 dodge durango turn signal lights stop working.

Had the same problem,its the hazard light relay,it's located under drivers side under dash, it has a relay that is maybe an inch in size (square). its alitle tuff to get to. hope this is helpful...

Posted on Apr 03, 2009

  • 83 Answers

SOURCE: 2000 grand marquis cruise control not working

Have seen this problem before. You need to look under dash at brake pedal and find a blue switch with plunger contacting pedal, disconnect connector and jump with a peice of wire and drive to see if cruise works and if it does replace deactivation switch this should get you going.

Posted on Aug 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a fuse or relay that run the cruise control on a 2000 dodge durango


Didn't see a relay, did see a fuse. Make sure the brake lites work. Are there any applicable trouble codes for the cruise system?
26087082-5xhhbfntzbebo4mt403s42wt-4-0.jpg

Feb 08, 2016 | 2000 Dodge Durango

1 Answer

2000 dodge durango cruise contol will not work


If your steering column has tilt, remove the covers and you'll find two broken wires .Make any necessary repairs and make sure to lengthen the wires a bit.

Dec 20, 2010 | 2000 Dodge Durango

1 Answer

Cannot find fuse 2004 durango cruise control


look under the hood in that fuse box

Feb 05, 2010 | 2004 Dodge Durango

1 Answer

On my '01 durango, neither the horn nor the cruise


Have you checked out all your relays or maybe a fusible link?

Sep 24, 2009 | 2001 Dodge Durango

1 Answer

Crusie control


the cruise control is run by the input and output speed sensors on your transmission these speed sensors tells the pcm vehicle speed and engine rpms this in turn adjust the cruise control module to adjust throtle via cable to the throttle body.

Sep 17, 2009 | 2003 Dodge Durango

3 Answers

2000 dodge durango 5.9 my horn and cruise control don't work. the fuses are good.


disconnect the plug to the horn then install a new fuse if the fuse does not blow out replace the horn. Do the reverse if the fuse does not blow out to the cruise. if the cruise is blowing fuses the unit may be seized up somewhere maybe the cable or actuator is corroded.

Jul 03, 2009 | 1999 Dodge Durango

2 Answers

Fuse location for cruise control on a 2000 dodge caravan


The cruise has no dedicated fuse, you will most likely be looking to replace the clockspring rotating contact located under the steering wheel which connects the switches in the steering wheel (horn, cruise and air-bag) to the rest of the electrical system.

Apr 02, 2009 | 2000 Dodge Caravan

1 Answer

1999 dodge durango horn does not work.


First thing I need to ask is are you having problems with your cruise control also? If so the problem is more than likely the clock spring. It is located behind the steering wheel and allows for the connection between the steering wheel and the wiring harness to stay in place when the wheel is turning. I have replaced 1 on a 2000 Durango and at least 4 others on different Mopar vehicles.

Feb 14, 2009 | 1999 Dodge Durango

1 Answer

2000 durango shifts out of overdrive when using cruise control.


My Durango did the same exact thing. It would seem it was shifting from o/d to third constantly while driving down the road. As it turns out, it was the throttle position sensor. This may or may not solve your problem, but is a good place to start.

Nov 12, 2008 | 2000 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...