Question about 1997 Volkswagen Jetta

Open Question

How to install rear stub axle 1997 vw jetta tdi

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 16 Answers

SOURCE: 2003 vw jetta tdi fuel filter

It is on the passenger side right behind the washer fluid fill tube. You can follow the fuel lines (look like 1/4" black tubes, some are clear) from the injector pump to it. It is a caniser a bit bigger than a normal looking oil filter and sits between the washer bottle and the metal that forms the wheel well. It is held in by a screw type clamp about half way down the cylinder. Probably isn't the fuel filter unless there is air in the lines to the injector pump or they didn't bother to fill the fuel filter up with diesel after putting it in. There is not a fuel pump in the tank in these cars so everything is sucked up by the injector pump and it needs to be primed properly.

Posted on Sep 11, 2008

Ad
  • 100 Answers

SOURCE: transmission fluid check on a vw jetta tdi

TO CHECK OR ADD TRANSMISSION FLUID TO JETTA IT HAS TO BE BROUGHT IN TO A VOLKSWAGON DEALEALER THERE IS NO DIP STICK EVERYTHING IS SEALED SO ONLY THE MECHANIC CAN CHECK IT.

Posted on Dec 17, 2008

  • 4 Answers

SOURCE: 97 VW Jetta TDI Timing Belt, How difficult is it?

Hi There,

Here's a step-by-step from some great guys over at TDIClub.com
for an AAZ (which I'm assuming you have)
http://www.tdiclub.com/articles/A3-TimingBelt/

It's pretty involved, and some special tools are needed. I've seen kits for sale
http://www.volkswaparts.com/Pre-1999TDITools.htm.

Posted on Mar 16, 2009

  • 11 Answers

SOURCE: 2006 vw jetta tdi service engine light reset

With the key in the ignition (but not turned), press and hold the Odometer Reset Button on the right hand side of the panel. While still holding that button, turn the key (although not far enough to start the engine) and then press and hold the Minute button on the left side of the instrument pane(if pressing doesnt work try turning the knob clockwise until service light has gone off and skip the pressing)l. Release both buttons at the same time.

Posted on May 30, 2009

  • 15 Answers

SOURCE: VW Jetta torque setting and hub nut size????

129 ft/lbs. Per Bentley...I'm pretty sure it's a 30 mm 12 point socket.

Posted on Jun 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove the rear stub axle on a 98 vw jetta gl drum brakes


Hi
Put car on stands securely and remove wheel.
Release handbrake, Remove brake drum.
Four bolts secure the stub axle, they will be very tight so use a freeze spray penetrating oil...lots of it. Some of these cars use allen head bolts so make sure the allen socket is good quality and is fullyhome before you undo the bolts.
When refitting, check the correct torque setting for these bolts.
These are usually replaced because the bearings have failed nd scored the hard surfaces....so...do fit new..god quality bearings and regrease properly!
Refitting is a reverse...please do clean and adjust brake shoes before adjusting handbrake. And always check your brake cylinders too.
Good luck
Roger

Mar 27, 2014 | Cars & Trucks

1 Answer

How do i get the axle stub out of the transaxle of my 97 vw jetta


drive out cv joint out of transmission using a hammer and brass punch.

Sep 25, 2012 | 1997 Volkswagen Jetta

1 Answer

Front axle removal


remove the axle stub retaining nut, disconnect the lower ball joint, disconnect the tie rod end, pull the spindle out and away from the axle stub tapping on the end of the stub if necessary with a hammer (just be careful) to pull the bearing hub loose from the axle stub. after separating the outside slide under vehicle (make sure the car is on jack stands and the rear wheels are blocked from rolling and very secure before crawling under any vehicle) look at where the inside axle stub goes into the transmission. you'll need a good sized pry bar to pop the axle out of the transmission. work the pry bar in between the inside axle stub and a good thick part of the transmission and pry the axle away from the trans., there is a snap ring on the inside axle stub that internally retains the axle you have to pry hard enough to compress the snap ring into the axle groove which will release the axle for removal. it's not a bad idea to replace the axle seal in the transmission while you're there but if it's not leaking and you don't damage it in the removal of the axle it's not necessary. measure and compare the new axle to the old one, it may have some differences in the shaft like missing vibration dampeners but if it's the same length and both axle stubs match the old ones in size and number of teeth you should be good. when you install the new axle line it up by hand and slide it in as far as possible manually then tap it in with a wooden or rubber mallet. if you don't have a mallet use a scrap of wood to protect the new axle stub threads and tap it in with a hammer. after you feel the snap ring collapse and the axle slide in tap on it gently to make sure it's fully seated then grab the inner axle stub and tug on it to insure the snap ring is in place. then reassemble in reverse order of removal making sure all nuts and bolts are tightened properly and all retainers are in place. good luck

Jan 06, 2011 | 1997 Chrysler Concorde

1 Answer

Volkswagen golf 2.0 tdi service manual


1993-2005 Volkswagen Jetta, Golf, GTI, Cabrio (A3-A4) Hatchback & Sedan Workshop Repair Service Manual - 350MB PDF

1993 2005 Volkswagen Jetta Golf GTI Cabrio A3 A4 Hatchback Sedan...

This is a COMPLETE Service and Repair Manual for your 1993 1994 1955 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 VW Jetta, Golf, GTI, Cabrio (1.8L turbo, 1.9L TDI and PD diesel 2.0L gasoline, 2.8 LVR6) (A3, A4 Platform) Hatchback & Sedan. It covers every single detail. All models, and all engines are included.

This QUALITY manual is 100 percents COMPLETE and INTACT, no MISSING/CORRUPT pages/sections to freak you out! Detailed illustrations, exploded diagrams, drawings and photos guide you through every service repair procedure. This manual can be viewed on any computer, as well as zoomed and printed. All repair procedures are covered A-Z. This manual for VW Jetta, Golf, GTI, Cabrio makes any repair job easy to do with very easy to follow step-by-step instructions & pictures on all areas of repair.

1993 1994 1955 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 VW Jetta, Golf, GTI, Cabrio (1.8L turbo, 1.9L TDI and PD diesel 2.0L gasoline, 2.8 LVR6) (A3, A4 Platform) Hatchback & Sedan
===========
Format: PDF
System: All Versions of Windows, Mac, iOS, BB, Android, etc..
Requirements: PDF Reader.
Printable: Yes

TABLE OF CONTENT (example)

GENERAL INFORMATION *

ENGINE *
engine mechanical
engine lubrication system
engine cooling system
engine control system
fuel system
exhaust system

TRANSMISSION/TRANSAXLE *
clutch
manual transaxle
automatic transaxle

DRIVELINE/AXLE *
front axle
rear axle

SUSPENSION *
front suspension
rear suspension
road wheels & tyres

BRAKES *
brake system
parking brake system
brake control system

STEERING *
power steering system
steering system

RESTRAINTS *
seat belts
supplemental restraint system (srs)

BODY *
body, lock & security system
glasses, window system & mirrors
roof
exterior & Interior
Instrumental panel
seat

AIR CONDITIONER *
air conditioner system

ELECTRICAL *
wiring diagrams
starting & charging system
lighting system
driver information system
wiper, washer & horn
body control system
lan system
audio visual, navigation & telephone system
auto cruise control system
power supply, ground & circuit elements

MAINTENANCE *
maintenance

INDEX *
alphabetical Index

1993 1994 1955 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 VW Jetta, Golf, GTI, Cabrio (1.8L turbo, 1.9L TDI and PD diesel 2.0L gasoline, 2.8 LVR6) (A3, A4 Platform) Hatchback & Sedan

Dec 21, 2010 | Volkswagen Golf Cars & Trucks

1 Answer

2001 VW Jetta TDI 1.9 Problem with the Volkswagen Jetta 2001 Jetta TDI 2001 VW Jetta TDI 1.9 having trouble obtaining correct alignment for both rear wheels, and this results in misalignment: The RIGHT...


if tires cant be aligned why cant they be what reason did they give you for not being able to align them fix the reason why they cant be aligned are the rims bent or is a part bad when they tried to align tires they should of given you a reason as to why they couldnt align them this is the reason as to your tire wear problem rather it be a bent rim or other things in the rear end of car when they do an alignment they tell you the reason as to why they couldnt align let me no how it goes any tire shop that does alignment will tell you why vehicle cant be aligned

Dec 13, 2010 | 2001 Volkswagen Jetta TDI

1 Answer

VW Jetta torque setting and hub nut size????


129 ft/lbs. Per Bentley...I'm pretty sure it's a 30 mm 12 point socket.

Mar 13, 2009 | 2002 Volkswagen Jetta TDI

Not finding what you are looking for?
1997 Volkswagen Jetta Logo

Related Topics:

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...