Question about 2002 Ford Explorer

1 Answer

My 2002 ford explorer all the electrical works except the keyless entry an all the inside locks they just stopped but fuses seem all to be good.

Posted by on

Ad

1 Answer

Will most likely, need to have a repair shop with a scanner ,check it out.

Posted on Oct 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Horn has stopped working on my 2006 Ford Explorer. The fuse seems to be fine. What could be the problem?


I would suspect an underhood fuse, the steering wheel clock spring, or a wiring problem. It's cheap to triple check all the fuses. The other two will require some troubleshooting to figure out. Since the horn works with the keyless entry, the relay, the horn, and its control wiring seem to be ok.

Sep 20, 2014 | 2006 Ford Explorer

1 Answer

Ford explorer door lock


Mine did not have the keyless pad problem - but replaced switch after checking it with ohm meter - showed switch was electrically stuck in unlock.

Jan 31, 2014 | Cars & Trucks

1 Answer

Keyless Entry and Remote


The alarm box might be disconnected. I would locate it and trace the wires. Start under the dash behind steering wheel. It usually a little black box

Dec 24, 2011 | 1996 Ford Explorer

1 Answer

1996 Ford Explorer wont lock


try uncovering the door side panels and start greasing up the door lock mechanisms, this will ease up the locking. but if it doesnt work still try replacing the power lock mechanisms. hope this helps

Jul 02, 2009 | 1996 Ford Explorer

1 Answer

Keyless Entry and Remote


I have had this problem take you drivers door put your key and un-lock from the out side with key (NO) then open the door push un-lock from the inside button and then set from you remote and it should set if not push un-lock then lock and then do the un-lock with the key. Let me know if that works. what my car did was locked from the inside and I had the problem were it would not work till I un-locked from the out side plus I had to go to radio shack and change the battery from the control.
Hope good happens.
Nikki2913

Oct 22, 2008 | 1996 Ford Explorer

1 Answer

2002 Ford Taurus keyless entry


if it was factory installed theres usually a fuse in the fuse panel whereever that may be...replace the fuse with the same voltage as the other one says. but if the fuse isn't in the fuse panel its most likely under the hood, to the right...hope this helps. =)

Oct 21, 2008 | 2002 Ford Taurus

2 Answers

2002 Ford Focus wagon remote keyless entry system


Driver door module is where to look also a broken or corroded wire and if you use your key to punch in the door code then the key pad has a hole in it or it just went bad it's not the remote control also check the master door lock switch for corrosion at the pins and the plugs same with the driver door module

Aug 15, 2017 | 2002 Ford SVT Focus

Not finding what you are looking for?
2002 Ford Explorer Logo

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...