Question about GMC Suburban

1 Answer

Car start wiil not run securty light will not go off

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Put your key in ignition. Turn to ON position. (Do NOT Start) Leave in the ON position for EXACTLY 10 Minutes. As SOON as the anti-theft light turns off, then IMMEDIATELY start the car.

Posted on Oct 14, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Securty problem truck wont start 2001 gmc searra died out driving


You have a fualty electrical condition,This can stem from a broken insulation wire to poor connection or the insulation that has rub through.The problem you have plaque GM. No need to by pass just get to the ignition area inspect the harness if anything you have a bad connection

Mar 12, 2012 | GMC Cars & Trucks

1 Answer

Put a new lock switch in securty light is on does not start


With a new switch comes a new key. Gm has a relearn procedure. You must do this 3 times. Turn the key on, engine off, wait ten minutes, turn the key off for 5 seconds. After the third time start the car. remember to turn the key off after the third time or you will have to start over. just a note , if you have daytime running lights , pull the fuse or relay to save the battery. It would be marked DRL

May 07, 2011 | 1993 Buick LeSabre

2 Answers

Securty light is on wont start


no good you will have to take to dealer to remap securty or sometimes turn key forward accessories only wait for light to turn off few up to fifteen minutes

Oct 02, 2010 | 1994 Pontiac Grand Prix

2 Answers

My caramo will not start, The problem is that my securty light is flashing. I can start the car by jumping the starter but it will shut down after a few seconds. i was told to turn my key to the run...


your key bro. go to the dealer and ask for the original key with resistor ur key is probably damaged or u might have to change your VATS module

Aug 13, 2010 | 1996 Chevrolet Camaro

1 Answer

Securty light came on and now the car will not


Open and shut the doors,and the trunk,and the hood,lock all doors,and set the anti-theft,leave it 5 minutes,then disarm it,and try and start,if this does not work,re-learn the key to the ignition,turn the key to on,leave it ten minutes,then turn it off,and right back on,do this three times,a total of thirty minutes,this should do it.

Jun 30, 2010 | 2003 Pontiac Grand Am

1 Answer

Has problem with securty system and other problems


mcdevito75 here, It"s possible the alrm system and the back fireing are associated, specially if the alarm (security system) is factory (built with the car) BEST BET have an auto alarm shop take a look, most auto shops that do glass, windshield, doors etc. also handle alarms.

Apr 05, 2009 | 1994 Buick Regal Gran Sport

1 Answer

Car will crank over but will not start


leave a battery charger on the car place keo key on engine off for roughly 10mins or until light goes out if light doesn't go off after30mins you need to repair securty problem first ie. pass lock sensor faild replace it first if you don't have proper diag equipment. if light goes out after 30mins start engine. you can also try disconnecting battery for 30mins and then hold pos and neg cables together with the battery still disconnected for 1sec to reset pcm /bcm. then relearn securty. good luck

Mar 23, 2009 | 1997 Pontiac Grand Am

2 Answers

Car won't start


turn the key to the on position until the securty light on dash go out takes bout 10 min to reset or u can disconnect the batt 30 sec

Mar 16, 2009 | 2001 Oldsmobile Alero

1 Answer

Replaced battery securty light came on power no start


Here is something that the emission wiz helped me with


PASS LOCK RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key
.

Mar 14, 2009 | 1997 Chevrolet Venture

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...