I want to get the door lock code for my explorer. Where do i go to get the number code?

Heres a YouTube video describing how to find it.

https://youtu.be/bbJCTMRZJx0

look where your jack is and using a flashlight shine it up towards the wheelwell and you will see a set of numbers thats your keyles entry code for your explorer

get VIN number and call dealership parts dept..they can give you the code

Do you have the code (sequence of numbers) for the lock? If not, you will not be able to change the lock code on the keypad without assistance from the Ford dealership. If you do then the owners manual gives step by step instructions. If you need an owners manual I can help with those instructions. Some vehicles have a card tucked up under the dash with the "code" for the locks from when the vehicle was first sold. I would look for that if you don't have the lock code.

FORD KEY PADS

• Enter permanent factory code
  
• Press the 1/2 button within 5 seconds to enter programming mode
  
• Within 5 seconds enter new code, doors will lock, unlock to verify code, this erases previous codes remotes will also need to be programmed. (MAYBE)
  

KEY PADS/REMOTES

• Insert key, turn ignition off-to- on eight times in succession, ending with key in on position doors will lock, unlock to verify in programming mode
  
• Press any button on new remote, doors will lock, unlock to verify
  
• Do the previous step with the second remote, doors will lock unlock to verify.
  
• Turn ignition off. Doors will again lock, unlock to verify.
  

NOTE-Some vehicles use 5 turns of the key instead of 8

FORD KEY PADS

• Enter permanent factory code
  
• Press the 1/2 button within 5 seconds to enter programming mode
  
• Within 5 seconds enter new code, doors will lock, unlock to verify code, this erases previous codes remotes will also need to be programmed.
  

FORD KEY PADS/REMOTES

• Insert key, turn ignition off-to- on eight times in succession, ending with key in on position doors will lock, unlock to verify in programming mode
  
• Press any button on new remote, doors will lock, unlock to verify
  
• Do the previous step with the second remote, doors will lock unlock to verify.
  
• Turn ignition off. Doors will again lock, unlock to verify.
  

NOTE-I found that some Explorer/Mountaineers enter program mode after 5 times-not 8.

Here is the link for further info.


http://www.2carpros.com/how_to/how_to_reprogram_key_remote_fob.htm


Your factory code is on a card in the owners manual. If that is lost, access the control module in the cargo area behind the left cover panel.

You MIGHT be able to see the code printed on it, or you might need to pull it out in order to see it.

1. Enter the factory set code.
2. Within 5 seconds press the 1-2 key
3. Enter your personal 5-digit code. Each number mus be entered within 5 seconds of each other.
4. Doors will lock and then unlock to confirm that your new code has been entered and accepted.

NOTES:
1. The factory code will still work even after you have entered your new personal code.
2. Entering a new personal code will erase the previous personal code.

there is one in the owners manual printed on a card, otherwise you will have to write down your vin number and contact the dealer for this. It's the only way.

2 ways to get code.....1- get a scanner to access security module to get code (local dealers can do that)....or 2- tear-apart the left rear quarter panel to access the security module and the number is printed on the label.....once you do that you can change it to your own code as outlined in your owners manual.......GL

you can find the keyless entry codes for the number pad, to unlock and lock your truck, on the keyless entry module, located under dash left side, the code will be the numbers in bold print, these are the factory code numbers