Question about Chevrolet G20

1 Answer

Where is the fuel filters. i have replace the one in the rear. is there any more

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 46 Answers

There is one in the tank called a "fuel strainer". This requires dropping the tank and usually isnt replaced unless the fuel pump fails. Olders chevys have one before the carburator.

Posted on Oct 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace a fuel filter


your vechicle has frame mounted inline filter,fuel filter mounts to the frame above the rear of the fuel tank, the fuel tank has to be loosen and lower down enough to replace fuel filter.first thing you need to do before replacing fuel filter,you need to relief fuel pressure by removing fuel pump relay in the power distribution center.

Jun 06, 2012 | 2000 Plymouth Breeze

2 Answers

Where is the fuel filter located


The fuel filter is located under the rear seat.
Fuel Filter Replacement:

  1. Reduce the internal pressure of the fuel lines and hoses by completing the following operations:
    • After removing the rear seat cushion, disconnect the fuel pump harness.
    • Start the engine. Allow it to stop by itself, then turn the ignition switch OFF .
    • Disconnect the battery negative (-) terminal.
    • Connect the fuel pump harness connector.

  2. Remove the eye bolts while holding the fuel filter nuts securely.
  3. CAUTION: Cover the fuel filter with a shop towel to avoid residual gasoline from splashing.
  4. Remove the fuel filter mounting bolts, then remove the fuel filter from the fuel filter clamp.
  5. After replacing the fuel filter, check for fuel leaks.

emissionwiz_96.gif

May 22, 2011 | 2001 Hyundai Accent

3 Answers

Where is it located? The fuel filter. My 2003 KIA sorrento will not accelerate up hills. Either hwy or city. On level ground it is fine. Is the fuel filter possible my proble. AGain if so, where is it...


For Kia Sorento 2003-2005 the fuel filter is located inside the fuel tank and is replaced with the fuel pump as an assembly.

Fuel Pump - Removal & Installation
  1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
  2. Remove or disconnect the following:
    Rear seat Access cover Fuel pump electrical connector
  3. Relieve the fuel system pressure.
    Fuel lines Fuel pump and filter assembly
To install:
  1. Install or connect the following:
    Fuel pump and filter assembly Fuel lines Fuel pump electrical connector Access cover Rear seat
  2. Start the engine and check for leaks.

Hope helped with this (remember rated this help) Good luck.

Nov 19, 2009 | 2003 Kia Sorento

3 Answers

Where is the fuel filter located


The fuel filter (2) is located under the rear of the car, behind the fuel tank. There is no service interval for fuel filter replacement. Replacement is required only if the fuel filter becomes restricted. e37512d.gif

Oct 30, 2009 | 1999 Chevrolet Malibu

1 Answer

Where is the fuel filter located in 2000 hyndai accent sedan?


The fuel filter is located under the rear seat.
  1. Reduce the internal pressure of the fuel lines and hoses by completing the following operations:
    • After removing the rear seat cushion, disconnect the fuel pump harness.
    • Start the engine. Allow it to stop by itself, then turn the ignition switch OFF .
    • Disconnect the battery negative (-) terminal.
    • Connect the fuel pump harness connector.

  2. Remove the eye bolts while holding the fuel filter nuts securely.
  3. Caution: Cover the fuel filter with a shop towel to avoid residual gasoline from splashing.
  4. Remove the fuel filter mounting bolts, then remove the fuel filter from the fuel filter clamp.
  5. After replacing the fuel filter, check for fuel leaks.
Good luck and hope this helps.

Jul 12, 2009 | 2000 Hyundai Accent

2 Answers

Where is fuel filter on 1998 Volvo S70 non turbo?


The fuel filter can be located under the carpeted cargo storage floor at the rear of the wagon. Remove the four 10mm bolts, remove the cover. You will then see a removable plate to the right just behind the rear passenger seat. Fuel filter can be seen through hole in hole. Replaced from underneath wagon. Be sure to make sure lines are fully inserted onto filter. Check for leaks. Note arrow on filter for correct fuel flow. Good luck and hope this helps and no smoking please LOL

Jul 11, 2009 | 1998 Volvo V70

2 Answers

Fuel filter


the fuel filter near the rear tire is the only filter. if you are still not getting any fuel pressure you may want to check your fuel pump.

May 22, 2009 | 1985 Honda Accord

2 Answers

Nissan 2004 Altima fuel filter location and replacement ?


filter is inside of the fuel tank and its a part of the fuel pump assembly. you need to remove the bottom section of the rear seat via 2 clips at the bottom of th eseat.you need a special tool to remove the lock ring on the top of the fuel tank. you wil also need a new o-ring to close itback up. the whole pump assembly has to come out and disassembled to replace flter. good luck.

May 11, 2009 | 2003 Nissan Altima

3 Answers

Fuel filter replacement


the fuel filter is located on the drivers side under neath where the rear seat would be connected to the frame. relieve fuel system pressure,disconnect negative terminal from the battery,raise rear of vehicleand support it securily on jackstands,detach fuel lines from the filter,some have quick connect . squeeze plastic tabs to pull the connector apart,if it has threaded fiting unscrew the fuel line from the filter.

May 09, 2009 | Cadillac DeVille Cars & Trucks

1 Answer

Basic service


Here are detailed instructions on the location, removal, and re-installation of your fuel filter. Hope it helps and have a great day!

REMOVAL & INSTALLATION
Carbureted Engines
These vehicles use two replaceable fuel filters. A small one is in the fuel line under the hood; a larger one is located at the rear, just inboard of the left rear wheel.
Whenever the filter(s) are replaced, take great care to avoid the entry of dirt into the lines. Also, pay attention to the correct installation position. It is possible to install the filter backwards.
FRONT
See Figure 2
  1. If applicable, disengage the filter or hose from its retaining clip.
  2. Using two fuel line clamps, pinch off both fuel lines. Take care not to crush the lines; just clamp them shut.
If the fuel hoses are hard or cracked, it is necessary to replace them.
0900c1528005f267.jpgFig. 2: Front fuel filter used on carbureted engines
  1. Loosen the fuel line clamps and slide them back.
  2. Using a twisting motion, remove the fuel lines from the filter.
  3. To install, use a new fuel filter and reverse the removal procedures. Start the engine and check for leaks. Correct any leaks immediately.
REAR
See Figures 3, 4, 5 and 6
  1. Raise and safely support the rear of the vehicle. Remove the left rear wheel.
  2. Remove the bolts securing the filter and its basket to the fuel tank.
0900c1528005f268.jpgFig. 3: Remove the bolts securing the filter and its basket to the fuel tank ...
  1. Push the fuel filter retaining tab and release it from the basket.
0900c1528005f269.jpgFig. 4: ... then release the basket from the filter
  1. Using two fuel line clamps, pinch off both fuel lines. Take care not to crush the lines; just clamp them shut.
0900c1528005f26a.jpgFig. 5: Clamp the fuel lines shut. If the lines are hard, cracked or brittle, they must be replacedIf the fuel hoses are hard or cracked, it is necessary to replace them.
  1. Loosen the fuel line clamps and slide them back.
  2. Using a twisting motion, pull the fuel lines from the fuel filter; remove the filter.
0900c1528005f26b.jpgFig. 6: After sliding the retaining clamps back, the filter can be removed from the linesTo install:
  1. Use a new filter and reverse the removal procedures.
  2. Make certain the retaining tabs are engaged when the filter is installed in the holder. Tighten the bolts until snug.
  3. Install the left rear wheel. Lower the car to the ground.
  4. Start the engine and check for leaks. Correct any leaks immediately.
Fuel Injected Engines
See Figures 7, 8, 9, 10, 11 and 12
The canister fuel filter is located in the engine compartment. When buying the new filter, also buy new washers for the banjo bolts and the service bolt. Failure to replace these washers invites high-pressure fuel leaks. Replacing the washers is required, not recommended.
  1. Disconnect the negative battery terminal.
  2. The fuel system is under pressure. Release pressure slowly and contain spillage. Observe "no smoking/no open flame" precautions. Have a Class B-C (dry powder) fire extinguisher within arm's reach at all times.
  3. Disconnect the banjo bolts and/or threaded fuel line fitting from the fuel filter. Use of a flare nut or line wrench is recommended for disconnecting and attaching this fitting.
0900c1528005f26c.jpgFig. 7: Fuel filter used on fuel injected Accords through 1989 0900c1528005f26d.jpgFig. 8: Fuel filter on 1990-93 fuel injected Accords 0900c1528005f26e.jpgFig. 9: Fuel filter used on fuel injected Preludes through 1991
  1. Loosen the fuel filter clamp bolt, then remove the filter.
To install:
  1. Install the new filter and secure the clamp bolt.
  2. The upper and lower washers on each banjo bolt and the washer on the service bolt MUST be replaced whenever the bolts are loosened. Install the washers and banjo bolts. Tighten the banjo bolts to 16 ft. lbs. (22 Nm) on all models except 1992-95 Preludes. On these models, tighten the bolt to 20 ft. lbs. (28 Nm). If applicable, tighten the threaded fuel line fitting to 27 ft. lbs. (37 Nm).
0900c1528005f26f.jpgFig. 10: Fuel filter used on 1992-95 Preludes 0900c1528005f270.jpgFig. 11: Fuel filter used on 1994-95 4-cylinder AccordsIt will be necessary to use a crow's foot attachment on a torque wrench to properly tighten the threaded fuel line fitting.
  1. Tighten the service bolt to 9 ft. lbs. (12 Nm).
  2. Start the engine and check for leaks. The engine may crank longer than normal until full fuel pressure is developed. Correct any leaks immediately.
0900c1528005f271.jpgFig. 12: V-6 Accord fuel filter

Nov 23, 2008 | 1985 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...