Question about 1999 Oldsmobile Alero
How do i install a water pump on a 1999 oldsmobile alero 2.4 liter
You need a haynes repair manually.because you have to remove timing chain cover. you have to remove timing chain tensioners.to unload timing chain.because water pump is going to interfere with timing chain housing.you will need a manually . too much to tell you in words.
Posted on Mar 22, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Dec 28, 2015 | 1999 Oldsmobile Cutlass
Aug 16, 2011 | 1999 Oldsmobile Alero
Jul 06, 2011 | 1999 Oldsmobile Alero
Dec 01, 2010 | 1999 Oldsmobile Alero
Remove the negative battery cable. Using a screwdriver, loosen the screw that connects the negative battery cable to the battery post. Pull the cable away from the post.
Lift th car using a jack. Support the Oldsmobile Alero with jack stands and the engine using a lift or some other engine support device.
Drain the Oldsmobile Alero's colling system by opening the cap on top of the radiator and unplugging the drain plug underneath the radiator. Position a large container under the drain hole to catch the draining coolant.
Disconnect the components that lead to the water pump with an adjustable wrench Lay them out in the order removed. In order, these parts include the automatic transaxle (if equipped), front wheel on the right side, splash shield, water pump sprocket and the access plate to the timing cover.
Use the access plate bolts to secure the water pump sprocket holding tool to the engine cover. Remove the pump bolts, front cover, thermostat housing, water pump feed pipe and two engine bolts using the adjustable wrench. Lift off the water pump.
Remove the bolts that secure the water pump to the block. Take off or scrape away the gasket. Remove and discard the o-ring between the water pump inlet pipe and the pump.
Spread a small amount of sealant on the water pump, on the areas where it mounts to the engine. Place the gasket on the sealant. Position the water pump onto the engine.
Insert the new bolts into the water pump. Torque the bolts to 89 inch pounds torque. Reconnect the other components in the order removed using an adjustable wrench.
Re-insert the drain plug into the radiator. Remove the engine support and jack stands. Lower the Olsmobile Alero to the floor.
Refill the radiator with coolant according to the instructions in your owner's manual. Screw on the radiator cap. Attach the negative battery cable to the post. Close the hood and test the car.
Nov 30, 2010 | 1999 Oldsmobile Alero
Mar 20, 2010 | 1999 Oldsmobile Alero
Feb 18, 2010 | 1999 Oldsmobile Alero
Sep 27, 2009 | 1999 Oldsmobile Alero
Jul 14, 2009 | 1999 Oldsmobile Alero
964 people viewed this question
Usually answered in minutes!