Question about 2004 Jeep Grand Cherokee

Open Question

Where is the ecu/computer located on a 2004 jeep grand cheroke?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2004 Jeep Grand Chrokee Neutral Safety Switch Location

The switch is on the transmission..It is usually a dealer item but you can get one from Rockauto.com for about 1/4 of what the dealers charge.

Posted on May 25, 2009

Ad
matney68
  • 426 Answers

SOURCE: trying to locate blower motor resistor in 1998 Jeep Grand Cheroke

blower resistor is right next to motor under passenger side of dash.

Posted on Jun 20, 2009

  • 316 Answers

SOURCE: airbag light jeep cheroke laredo 2004

The issue would not be related to a fuse. There is a fault in the airbag system somewhere, and your airbags are not operational at this time. The issue may be related to the seatbelts, but if you don't understand the airbag system it is best left to a professional. Airbags save lives, but can also be deadly if you don't know what you're doing.

Posted on Jun 26, 2009

  • 6982 Answers

SOURCE: 1998 Jeep grand Cheroke hard cranking, sputtering, rough idling

In READING what you wrote, it appears that your car is difficult to start and pretty much is rough while running....It also appears that your are randomly replacing parts...How did you verify that the parts your have replaced had failed? I suggest you get a basic manual like chiltons or haynes as well as a decent digital volt/ohmeter, then do some testing. Pay close attention to map sensor test and manifold air temp. Having a good fuel pump does not insure that your injectors are clean enough to deliver a good spray pattern This will not show up on any test...you need to actually look at them. There are other items to look at but I think you will likely find your problem in what i mentioned. (you already checked for vacuum leaks, right?)
Good luck!

Posted on Jul 27, 2009

  • 52 Answers

SOURCE: what type of transmission fluid should i use on my

General motors Dextron 3 is usually sufficient. If you want to know that for sure check the transmission's dip stick it should be stamped on it.

Posted on Sep 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

All turn signals on my jeep cheroke laredo are not working. Is the problem a bad fuse??


COULD BE BLOW FUSE.FAULTY TURN SIGNAL SWITCH OR FAULTY TURN SIGNAL FLASHERS WHICH IS LOCATED FUSE / RELAY BOX JUST LEFT OF THE STEERING COLUMN.

Dec 05, 2010 | 2003 Jeep Grand Cherokee

1 Answer

I have jeep grand cheroke 1995 V8 5.2L , only in the morning it start and check engin light on only after 5 min when sw let on


Your ecu is going bad. The power caps in the ecu are old and weak, needing time to build up current enough to supply the ignition and fuel systems. Only then will the check engine light illuminate and the vehicle start. You can either have the ecu replaced or the caps within it repaired

Nov 23, 2010 | 2000 Jeep Grand Cherokee

1 Answer

I have jeep grand cheroke 1995 V8 5.2L , only in the morning it start and check engin light on only after 5 min when sw let on


Your ecu is going bad. The power caps in the ecu are old and weak, needing time to build up current enough to supply the ignition and fuel systems. Only then will the check engine light illuminate and the vehicle start. You can either have the ecu replaced or the caps within it repaired.

Nov 23, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Horn wont blow in 2004 grand cheroke laredo jeep


get assistant to hold horn on then tap it with a hammer and see if it will work ,often works

Nov 14, 2010 | 2004 Jeep Grand Cherokee

1 Answer

My 2004 jeep grand cheroke makes a humming noise from 25mph all the way to 65mph weather I am on the gas or not, but stops when I start to slow down, any help would be great


Ummm.Not much to go on but get the universal joints checked and also the driveshaft centre bearing.This is the one that supports the 2 piece driveshaft and is bolted up onto the chassis.Hope this helps

Sep 01, 2010 | 2004 Jeep Grand Cherokee

1 Answer

I am trying to locate the fuse box on my jeep grand cheroke 1996


1998 Jeep Grand Cherokee Service Manual
http://rapidshare.com/files/138412864/ServiceManual.Jeep.Grand.Cherokee.1998_by_Parasico.rar

see ezg_8w.pdf, PDF page 46 of 448 for the junction box

SEE ALSO
http://www.scribd.com/doc/4790640/93ZJ-Secc-8W-Wiring-Diagrams
look for diagrams for fuse block, and relay center and power distribution center

fuse location is on front passenger side's side of dash (open door) OR underneath the dash, kick panel
the power distribution center is under hood.

Feb 27, 2010 | 1998 Jeep Grand Cherokee

1 Answer

Trying to locate blower motor resistor in 1998 Jeep Grand Cheroke


blower resistor is right next to motor under passenger side of dash.

Jun 20, 2009 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...