Question about 1996 Mercury Mystique

1 Answer

Not enough heat - 1996 Mercury Mystique

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

You might be low on coolant or heater core might be plugged up.

Posted on Oct 14, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Glowplugs not heating long enough

You have one or more burnt out glow plugs is the most common reason.

Jun 20, 2016 | Cars & Trucks

1 Answer

Hello i have a 2002 buick rendezvous not blowingg enough heat out. what should i do

Check the coolant level in radiator first. if its ok! then it may be a bad thermostat. God_Bless!

Jan 13, 2015 | Buick Cars & Trucks

2 Answers

I have a 2005 dodge durango that's over heating.

The basic answer is not enough coolant flow or not enough air flow thru the radiator. You'll have to find out if the coolant is flowing when the thermostat is open, is the system full of fluid, and is there enough air flow thru the radiator.
Does it get over 220 degrees if you are moving and at idle too ?

Jun 17, 2013 | Cars & Trucks

1 Answer

Little heat

probably needs thermostate or check make sure you have enough antifreeze in your radiator

Feb 17, 2013 | 1999 Oldsmobile Alero

1 Answer

Great lakes hottub wont heat up

is the heat indicator light showing on the topside panel? If the pump is running and there is not enough water flow to activate the pressure switch then the heater will not come on.
If the filters are too dirty there may not be enough water flow to activate the pressure switch which sends the power to the heating element.
You just may have a bad heating element.

Jan 24, 2013 | Cars & Trucks

2 Answers

My 1988 dodge ram 100,just does not put out enough heat and blowing power to keep up with canadian winters is there any thing i can do to get more heat and air volume.

you can try blocking the radiator with cardboard. the heat comes from your coolant so if its not producing enough heat you either are not getting the truck hot enough or you have a clogged heater core.

Aug 23, 2011 | 1988 Dodge Ramcharger

2 Answers

Rad. has small hole in it. nearly over heated this morn, could only get one gallon of anti-freeze, it was two more gallons low. would this cause the heater not to heat??

Yes! When a car runs low on antifreeze, problems occur. When antifreeze levels get low enough, a car begins exhibiting enough signs that prompt its owner to have it checked.

Low antifreeze in a car engine typically causes its heat to quit functioning. This symptom is normally only noticed during the cold months, when a driver relies on the heat to be comfortable in her vehicle.

Apr 05, 2011 | 2004 Mercury Mountaineer

1 Answer

2003 Town & Country - no heat or gauge movement

If the coolant level (antifreeze) level is low there may not be enough fluid in the system for the temperature sensor to register a proper reading ( think of it as holding an oral thermometer just outside of your mouth).

Insufficient fluid passing through the heater core (small fan that blows through a small heated radiator) may not be enough to produce heat.

However: At increased speeds the engine may be heating what little fluid there is to a point to supply heat to the heater core, and register on the temperature sensor.

Feb 28, 2010 | 2005 Chrysler Town & Country

1 Answer

2003 Jeep Libety not getting enough heat

you will need to flush the heater radiator ,by disconnecting the feed pipes and flushing the rad with the hose or a small pressure washer

Jan 30, 2010 | 2003 Jeep Liberty

1 Answer

Heater dont work properly not much heat comes out

1st check the coolant level. If it's low, you won't get sufficient heat. 2nd, what does the engine temp gauge indicate? If it is only in the low side (cool, or cold), the thermostat is probably stuck open, and the car will not warm up properly, so not enough heat. Let me know if this helps or not, there are other causes of not enough heat, 1st check the above and post what you find.

Dec 08, 2009 | 1992 Dodge Caravan

Not finding what you are looking for?
1996 Mercury Mystique Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

77499 Answers


Level 3 Expert

5622 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides