Question about Chevrolet Silverado 1500

1 Answer

1992 chevrolet k1500 350 tbi 5 speed has a skip all the time has new plugs ,wires,dist,egr,tps,iac,coil,icm on codes stored in computer how can you tell if the injectors are bad

Posted by on

  • Jimmy Jarrett
    Jimmy Jarrett Oct 14, 2010

    with the truck running and the breather off the spray from the injectors down in the throttle body goes around and around but there is a little drip in the middle of each one at the same time is this normal or could they be bad thanks jimmy

  • Jimmy Jarrett
    Jimmy Jarrett Dec 18, 2010

    put i new injectors and fuel pressure regulator kit did not help

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,826 Answers

OK, get a stethoscope to listen for the telltale clicking of the injector when it is connected to the listening tool.

Also, one can buy a noid light that connects to the harness to see if it is lighting or pulsing electricity to the injector when running or cranking.

A bad or plugged up fuel injector can cause the skip or miss in the engine.

Also, a bad or burnt 'valve' can cause this symptom.

Do a compression test to see that all of the cylinders have the same compression characteristics.

That's all I can think of right now.

Posted on Oct 14, 2010

  • Duane Wong
    Duane Wong Oct 14, 2010

    A bad injector will leak at the throttle body when the engine is turned off and you'll see it drip.



    Good luck on this repair.

  • Duane Wong
    Duane Wong Dec 19, 2010

    Then, with all of the things changed on your engine, I think that there may be mechanical wear on the rings or valves that is throwing things off. Check for even compression on all of the cylinders.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What controls the opening and closing of the EGR solenoid?


ECU controls the EGR system. Check for vacuum to the valve with the engine running. There should be no vacuum. If you have vacuum disconnect the electrical to the vacuum control solenoid and see if the vacuum goes away. If it does you have a command or wiring problem and will need to trace the signal wire back to the ECU.

Oct 25, 2014 | Cars & Trucks

1 Answer

1992 f150 5.0 idles rough and stalls when driving


iac valve means idle air controle iff its injectors you can do a pressurized injector clean take a noid light and test them for signal but your best answer is one of three, iac valve, wrong fireing order, wich i have seen numerouse times on the 5.0, and included in fireing order is timing, or catalitic converter the cat would creat the coads for the parts you changed hoped this helped

Jul 22, 2012 | 1996 Ford F150 Regular Cab

1 Answer

My 1995 mustang 5.0 bucks and stalls. evap problem?


im having a sim issue guys.. my 95 auto. once it hits running temp it dies. checked at that temp no spark.. did the coil plugs wires dist.cap n rotor fpr purge sensor and egr sensor.

Feb 05, 2012 | Ford Mustang Cars & Trucks

1 Answer

I have 1992 RS Camaro 25th anniversary I replace spark plug /wires, distributor cap and rotor, oil filters, air filter, vaccum hose,fuel sensor, idle speed sensor, but when Idle the car run good but when I...


First off, some people hate to hear it but if it ran fine before you did this work, go back over what you did.

What fuel sensor and idle speed sonsor did you replace? Could you mean the IAC (Idle Air Control) and TPS (Throttle Posistion Sensor)? Both of these are adjustable.The Pridle in the IAC has to be measured and set to specific length and the TPS has to be set to a specific voltage with the throttle closed.

Now you could also have an EGR that is getting stuck open. The EGR is meant to open when the throttle os open AND at speed. If its got carbon build op causing it to not close all the way then it would die when you lift off the throttle.

Aug 01, 2011 | 1992 Chevrolet Camaro

1 Answer

I have a 1988 k1500 seirra truck, that will idle fine then it will chock its self out and stall out.(i have a new egr synolyd,new egr, a 1992 ecm pulled from a junk yard,new cap,rotor, plugs...


Are you a TBI?(throttle body injector) if you are take the top of the air cleaner out step on the gas pedal(do this in park hood open fire extinguisher on the ready.) does it backfire through the air cleaner if it does you are in need of a whole distributor unit the distributor unit has a relector that has a high tendency for failure by the way the vehicle sound there is only 2 possible problems you coil is faulty and this includes the connection to the coil which has a tendency to seperateor the connection to the ICM.(ignition control module where the coil is) or the whole distributor reluctor

Aug 01, 2011 | 1989 GMC K1500

1 Answer

My truck idles up and down i have replaced everything on it all sencors etc. I have checked for vacum leaks and have replaced all of the lines replaced the gasket under the tbi the only thing i havent...


hi i see you have changed allot of sensors, but i notice you have not mentioned the Idle Control Valve? iCV have you changed this? as that what it sounds like it will be, also have you checked your timing? that would also do it....hope this helps

Jun 30, 2010 | 1988 Chevrolet C/K 3500

1 Answer

High idle CHevy 350 TBI


check if went from a V6 TO V8 need power two more cylinders

Jun 20, 2009 | 1992 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...