Question about 1989 Chrysler New Yorker

1 Answer

The belt squeeks after a going throught the car wash

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

The water is causing the belt to slip on the bullys and tensioner rollers. Your belts could neet to be replaced or your tensioner springs could be weak.
Inspect your belts for cracks and tightness

Posted on Oct 14, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Squeeking belts

They are not tight enough. Find another mechanic, the first one is incompetent. There is also an anti squeal spray if you prefer that:

Sep 10, 2012 | 2002 Toyota Camry

1 Answer

Why would my jaguar XJ6 pully start squeeking, sounds like bearings?

what is happening is the belt is not getting full contact with the pulley, you might just have some antifreeze residue from repair and by slowly poring 1/2 a gallon of water on the belt will wash off this residue BUT first look under the car for leaks ! AC off let car run for 10 minutes on driveway mark the tires position with a coin back car up and look for a wet spot, the coin will give you a better idea where the leak may be.. no leak YAAAA .. next step .
pulley groves may have trash in the groves this can be cleaned with a bar of lava soap WARNING this procedure is done with the engine running and is dangerous ! take the bar of vava and touch it to the inside of the belt, this pumice in the soap works well for cleaning the pulley groves. also a ice pick or a small screwdriver can be used in the groves of the pulleys to clean black residue in the bottom of the groves.. remember i I was able to help you thank me
.. jay the pool pump motor repair guy in longwood Fl

Jul 25, 2012 | Cars & Trucks

1 Answer

Sounds like serpentine belt is squeeking

If the squeek stops as the motor warms up replace it. You can also purchase some squeek stop spray and see if that helps before buying a new belt

Sep 09, 2010 | 2001 Oldsmobile Aurora

2 Answers

Peugeot 206 GTi (Engine Squeeking Noise)


Aug 20, 2009 | Peugeot 405 Cars & Trucks

2 Answers

Squeeking noise heard when starts engine

From the little information you have given me i would quess that the brushes inside your starter are going bad you may have someone check your starter!!

Aug 11, 2009 | 2004 Toyota Corolla

1 Answer

My alfa gtv ts has developed a squeek in the

The timing belt is synchronous and will not slip. if it did your car wouldn't run. it is most most likely a drive belt. replace the drive belts. if that doesn't fix it then one of the pulleys is going bad. its hard telling which one.

Jun 28, 2009 | 2000 Alfa Romeo 145

2 Answers

Engine Squeek

It may be the water pump that is making the noise if the noise is constant.

May 11, 2009 | 1998 Dodge Ram

1 Answer

Major friction/squeeking from serpentine belt!!!!

Keith,it sounds like you may need to clean the grooved surfaces on your pulleys,you could remove the belt and use some aerosol brake cleaner and a stiff brush to remove any build-up on the could also try spraying the same on the pulleys while the car is running,just be sure and wear eye protection and don't get to close to any moving parts.

Apr 29, 2009 | 1992 Mercedes-Benz 190

1 Answer

Skeaky serpentine belt

are you positive the squeek is coming form the belt area?

the squeek can be from several other places, fan clutches can cause a high speed squeek, take the fan off and see if that cures it, the water pump front bearing can also be the culprit but that is hard to figure out without swapping in a new water pump, and lastly look at the AC compressor clutch, see if the squeek changes when you turn on and off the AC

hope this helps,

Oct 12, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides