Question about 2007 Chevrolet Tahoe

1 Answer

How do I reset the o2 code on my 2009 Tahoe after I replaced the Gas Cap?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 266 Answers

TAKE AND DISCONNECT BOTH BATTERY CABLES FROM THE BATTERY AND HOLD THEM TOGETHER FOR TEN MINUTES OR PUT A JUMPER WIRE ON THEM (TAKE BOTH CABLE OFF)

Posted on Oct 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Replaced purge valve cannister & tube on 2009 chevy impala ss plus 10amp fuse, gas cap code is p0449; now the check engine light has not went out been 4 days since replace now what 2 do...help help


gas cap code p0449 ??? This is not a gas cap code ! DTC P0449: Evaporative Emission (EVAP) Vent Solenoid Control Circuit.. your best bet , take it to a qualified chevy repair shop .


Wells EVAP Training with Sgt Tech P0440 P0441 P0442 etc

Apr 12, 2017 | 2009 Chevrolet Impala

1 Answer

Engine light on with P2096 code


Did you replace the O2 sensor after the catalytic converter? This code is set by the rear O2 sensor. It usually indicates early failure or restricted catalytic converter. May want to have an exhaust back pressure test performed.

Jul 07, 2014 | 2005 Jeep Wrangler

1 Answer

Fix engine light & P2096 code


REPLACE REAR O2 SENSOR AND A MUST TO HAVE YOUR EC/PCM UPDATED. IF YOU BOUGHT YOUR O2 SENSOR FROM ANY OTHER PLACE THEN A JEEP DEALERSHIP THIS IS WHAT HAPPENS, THATS HOW THEY GET YOU TO GO TO THEM FOR REPAIRS, SORRY, BUT THE SAD TRUTH. GOOD LUCK

Jul 07, 2014 | 2005 Jeep Wrangler

1 Answer

2009 Mazda 5 check engine light after loose gas cap


If the code would have been due to the cap problem then the code will go away. Try resetting the code. Also try diagnosing again after disconnecting the battery and then reconnecting it after a few minutes.

Jun 04, 2013 | 2009 Mazda MAZDA5

1 Answer

Emiision s error code, first, check gas cap warning. then error code and emissions control symbol stays on. checked gas cap. how does this code reset?


was the gas cap loose? if it was, then it may take a few days to go back off. It it was tight and good, then you have other problems. it may be covered under warranty/

Sep 07, 2010 | 2009 Honda Odyssey

2 Answers

I have a 2003 Chevy Tahoe LT with under 54000 miles. The engine light came on and will not go off. Had someone to look at the problem and they said that it is an issue between cylonoid 1 and 2. Is this...


I don't know about that but I will tell you that if you disconnect the battery, it will reset most of the time, if the performance became bad after the light came on theres a problem take it to the shop to have a free comp. diagnostic. But if it still runs the same try the battery idea.

Aug 11, 2010 | 2003 Chevrolet Tahoe

1 Answer

I have a 97 2 door tahoe. I have trouble starting it. It turns over but wont start right away. It takes about 8-10 seconds of cranking to get it to start. It will start right away if you push the gas down...


o2 is a sensor. You could try replacing the correct one (up to 4 o2 sensors are possible any given vehicle). If check engine light is still on, have the codes cleared, have scan performed again to get the fault codes for possibly the specific o2 sensor. Hope this is helpful.

Apr 26, 2010 | 1997 Chevrolet Tahoe

2 Answers

Chevrolet 2005 Tahoe Gas cap issues


Have the cap pressure tested. Replace if need be.

Mar 16, 2010 | 2005 Chevrolet Tahoe

1 Answer

'07 Tahoe; check engine light on steady. Just came


Have a dealer or garage check your Oxygen (O2) sensor. As a quick fix, try disconnecting and reconnecting your car battery. Sometimes this will reset the check engine light.Good Luck!

Aug 01, 2009 | 2007 Chevrolet Tahoe

Not finding what you are looking for?
2007 Chevrolet Tahoe Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...