Question about 2003 GMC Sierra

1 Answer

Location of resistor pack for blower motor - 2003 GMC Sierra

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 672 Answers

Its inside the blower motor housing near the blower motor!!

Posted on Oct 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 bmw 540i blower motor relay location


don't know about the relay, it uses a resistor pack, two of them, one hidden the console and the other at the fan itself. There is a good you-tube video on the resistor pack replacement that is the console location. It's tricky, but it faily often.

May 16, 2015 | BMW 540i Cars & Trucks

2 Answers

Fan resistor


Located Usually On Front Of Engine Block About the Size Of A Quarter ( Black ) with One Wire Comiig outof it

Dec 11, 2013 | Cars & Trucks

2 Answers

Where is the location of the speed relay for blower motor on a 1990 geo prizm


Not a relay but a resistor pack, and it should be mounted in the heater case, close to the blower motor-follow the wires from the blower motor back to the resistor pack. Unplug the connector and remove the screws holding the pack to the case, to remove and replace.

Mar 22, 2013 | 1990 Geo Prizm

1 Answer

Where is the heater/ac fan resistor located on a 1999 vw beetle


Attached to the blower motor is a device called the Resistor Pack...
It has a 4 wire connector...Wire colors are...Yellow...Green...White/Blue...And Blue.
Inside this resistor pack is a fuse. If you use an ohm meter.
One probe on Yellow wire and other on the Blue.
If it reads "open" the resistor pack is defective.If you read resistance
the pack is Good. Main power to the circuit is supplied via fuse #25 (25A) located in the under-hood fuse box. So simple answer is .The blower motor resistor is located close to the blower.
Let me know.

Dec 28, 2011 | Cars & Trucks

1 Answer

Where is the heater blower resistor located?


The resistor pack wires are usually attached to the same wires as the blower motor. I strongly recommend replacing the blower motor at the same time if possible. It's the blower motor that is usually the reason for the resistor pack going out. So if you put just the resistor pack in, and shortly after, it goes out again then you'll know the blower motor needs to be replaced.
I hope this info helps!~subyguru~

Jun 23, 2011 | 2000 Subaru Outback

2 Answers

LOCATION OF BLOWER RESISTER


The Lancer blower motor's are known to heat up and burn out. If you remove it, it is labeled with "Do Not Repair", but it is possible. If you look inside of the block, you will see a flap sticking up - that needs to be soldered down in order to work in the 1 - 3 positions.
The Blower resistor is located on the passenger side under the dash, in the air plenum left of the blower motor.
Thank you for using fixya, and good luck

May 06, 2010 | 2002 Mitsubishi Lancer

1 Answer

Blower motor doesn't work and has no power to it


Check the blower multispeed control resistor pack is not faulty.
The resistor pack is usually located in the air ducting, in the blower fan airflow.
Basically, +12v power is supplied (via fuse) to the fan speed control switch, which then passes via the selected speed control resistor, to the fan motor. Often a interface relay is used to switch the blower motor high current.

Aug 31, 2009 | Dodge Pickup Cars & Trucks

1 Answer

Ac blower motor


Check fuse supplying fan is not blown,
Check blower control switch is operating OK,
Check relay controlling fan is operating OK,
Check variable speed resistor pack is not faulty (the resistor pack is usually located in the blower ducting, in the blower airflow),
Check blower motor ground connection is not missing.

Aug 12, 2009 | 2000 Mercury Grand Marquis

2 Answers

Blower only works on the two highest settings


hi the blower motor is under the right side of the dash
remove the hush pannel
you don't have to remove the blower motor but it does give you more room
disconnect the wiring to the resistor there are two 5.5mm bolts that hold the resistor in
remove the bolts and slide the resistor out
install the new resistor and reassemble
hope this helps

Jul 03, 2009 | 2001 Oldsmobile Alero

Not finding what you are looking for?
2003 GMC Sierra Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...