Question about 1992 Isuzu Rodeo

1 Answer

Om my 92 Rodeo the back light is out. Do I have to replace the entire unit or can I just replace a bulb?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 303 Answers

Just change the bulb

Posted on Oct 14, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I was told by a local car shop that in order to fix the High Mount Brake Lamp (brake light is out) that I would need to replace the entire unit. One year ago it cost me $172.03 to replace the entire unit....

check to see if you got two screws if you do all you need is the light bulb if you still have the old one look at it and see if the bulb can be replace without breaking anything i no you mention a year ago

Sep 24, 2012 | 2005 Ford Taurus

1 Answer

How do I replace burned out lights in speedometer and tach?

You have to pull the entire display meter out to get to the bulbs that are behind it.

May 16, 2011 | 1999 Isuzu Rodeo

1 Answer

How to install a rear brake light bulb on a 2004 Isuzu Rodeo

The easiest way is to open back trunk open any coverings or carpet pull it back to gain access to the bulb socket once you see the socket twist it counter clock wise and remove remove the bulb and replace with new one once installed have someone step on your brake pedal to confirm working then put upholstery back and you =have completed changing your brake light bulb.

Dec 27, 2010 | 2004 Isuzu Rodeo

1 Answer

How to access the tail light above the trunk? I

you must slide the entire high mount brake lamp unit to the left( pass side) and lift straight up. unplug the wire and remove the unit, it will be easier to change the bulb this way. make sure you use the correct bulb or the warning lamp will not go out.

Oct 20, 2009 | 1996 Lexus LS 400

2 Answers

Replace highbeam 1996 rodeo

Fig. 1: Replacing a sealed beam headlamp

  1. Disconnect the negative battery cable.
  2. Remove the front grille and/or headlight bezel.
  3. Remove the headlight bulb retaining rim, headlight and disconnect the wiring.
  4. Before installing, spray some silicone grease into the bulb socket.
  5. Connect the wiring and install the bulb.
  6. Install the retaining rim and grille.
  7. Adjustment: turn the adjusting screw (A) for vertical adjustment. Turn the screw (B) for horizontal adjustment.

Fig. 2: Replacing a headlamp bulb


Jul 24, 2009 | 1996 Isuzu Rodeo

2 Answers

Left turn signal, just buzzes, no lights no flashing, but works o.k. in hazard. since the hazard lights on the left work and flash, could this be anything but the combo switch,$249.oo

It might be worth it to check all of your bulb sockets...I had similar problem in my 91 amigo - but my turn signal would flash very fast even though the bulb was fine.
I removed bulbs, checked all sockets & noticed that one had some rust/oxidation- obvious bad connection.
I sprayed it with some PB blaster (or use wd40 or silicone), wiped it out & replaced bulb. Solved the prob. Hope it works for u!

Apr 05, 2009 | 1992 Isuzu Rodeo

2 Answers

Brake light bulb

hi cjryan 9876 when you look on the outside of the lens there are 2 philips head screws & if open your tail gate there are another 2 philips head screws in there as well one of which is located through the locking tab for the tailgate once you undo these the tail light should fall out & then to get the tail light out of the socket give it a quarter turn anti clock wise

Dec 28, 2008 | 2000 Isuzu Rodeo

1 Answer

Replacement of failed RH daylight driving headlight.

part # 9006ST...accessed from back of headlight bucket...unplug connector twist connector at bulb not touch glass on new one...your oils will cook the new bulb

Dec 08, 2008 | 2005 Cadillac Escalade

1 Answer

1999 Chevy Express Van tail light bulb replacement

Yes, you can replace just the bulb. Remove the light assembly and you can get to the bulbs on the back side.

Aug 12, 2008 | 1999 Chevrolet Astro

Not finding what you are looking for?
1992 Isuzu Rodeo Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

76051 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides