Question about 1994 Chevrolet Astro

1 Answer

Whats the easyest way to change plugs - 1994 Chevrolet Astro

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chevrolet Master
  • 4,336 Answers

On a van, there is not an easy way. Some get from the back, some from the front, some from the wheel well, some using a socket and combo wrench. Just a hard job, no matter what.
You need to be very careful to not break the plug during install. Often, a short piece of rubber hose can help you thread the plug.

Posted on Oct 13, 2010

  • Anonymous Jan 23, 2011

    yep not easy


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to change water pump on 92 toyota celca

this job needs technical skills and cannot be done by a layman.
-sample procedure on the same engine type (5S-FE):
DIY GEN3 Timing Belt Waterpump Oil Seal Change Part 1 Toyota Nation Forum... 25315368-2maz33e5jmmhtbewx0uwwxeg-2-0.jpg 25315368-2maz33e5jmmhtbewx0uwwxeg-2-2.jpg

Dec 10, 2014 | 1992 Toyota Celica

1 Answer

My mx5 n reg 1.6 is making like a pulling when travelling at any speed it feelsasthough the engine isnt getting enough petrol through . could it be a filter

Start from easyest -
1. Check spark plugs and distributor for wear and aging
2. Check air filter
3. Check exhaust for any obstructions
4. Check fuel filter.(if petrol is dark - then you should change the filter)

Jul 13, 2011 | 1996 Mazda MX-5 Miata

1 Answer

Hello, wanted to know the simplest way to change spark plugs and how what parts do I have to take off?

The easyest way I've found is to remove the coil pack assembly. If you want more room then you can take the top engine mounts loose and rotate the engine forward, this will give you a little more room. Its just a pain no matter how you do it.

Feb 21, 2011 | 2001 Pontiac Montana

1 Answer

What is the easyest way to change the modgule under the distrubeter

take plugs off one by one and number them with tape so you dont forget where they go or you could mess up your timing should be two or three screws holding the cap on take that off and the modgule should be right there in plain sit and easy to take out.

Jan 11, 2011 | 1991 Ford F150

2 Answers

Trying to replace spark plugs but we can't get to them!

start by mmarking with paint markers are besst everything you disconnect that is in the waay mark both endss whereur disconnecting until your able to get to them easyest and best way dont think youll be able to remeber what u disconnect cause you wont be tried it many timess youll never remeber make sureyou color cordinate ends you disconnect

Jan 16, 2010 | 2003 Hyundai Santa Fe

1 Answer

Easyest way to chang freeze out plugs in a87 olds regancy 98seaies

If you have access to them and plenty of room you can run a self tapping screw into them and pry them out with a pry bar or even a slide hammer. This doesn't always work though. Sometimes you can tap an edge of it in enough to rotate the plug so you can grab it with some vise grips and wriggle it out. They are soft metal.

Dec 30, 2009 | 1988 Oldsmobile Regency

1 Answer

Is there a easy way of taken injectors out

if you will get a wrench and then with engine running, loosen the fuel injector lines 1 at a time, you will find the bad cylinder when it doesn't change the way the engine runs when you loosen the line to the bad injector/cylinder

Oct 16, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

Whats the easyest way to change the spark plugs on a 01 navigator

Not to hard to do. Look on top of the valve covers and find the coils should be one for each cylinder. Remove the 8mm bolt holding the coil down and unplug it, pull up the coil to access the plugs. Some of the bolts and plugs may be harder to get to due to location you might need to have a swivel to access them. You don't have to worry about putting the coils back in the same place because they will mount anywhere. Now if you have a cylinder misfire code you can swap that coil with one of the others and see if the misfire code moves with that coil.

Sep 29, 2009 | 2001 Lincoln Navigator

1 Answer

Engine change

Drop cradle with engine, tranny, steering rack, front struts and all attached to it.

May 10, 2009 | 1994 Pontiac Trans Sport

1 Answer

Water pump

Good Day,

Follow this link for a step by step with pictures.

Good Luck and hope this helps

Jun 30, 2008 | 1994 Mitsubishi Galant

Not finding what you are looking for?
1994 Chevrolet Astro Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides