Question about 2002 Honda CR-V

Open Question

How to adjust my honda crv hand brake - 2002 Honda CR-V

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 57 Answers

SOURCE: 2004 honda crv brake won't release

Your emergency brake is a mechanical brake system that is indipendant of the regular hydrolic system. If the red brake light on the dash is on make sure it's the emerg. brake and not a problem with the fluid level or the calapers sticking. the best way to check the emerg. brake is to rase both rear wheels off the ground and spin them. If they spin, the emerg. brake is not locked up. If they don't spin, take the rear tires off and the brake drums. (you may have rear disk brakes.) check the springs to insure they are all hooked up properly. If there is no problem there, follow the parking brake cable to check for damage. The cable is like a brake cable on a bike, If the inner cable is binding inside the cable sleeve,the brake wont release. If you have rear disc, it's probly a bad calaper.The park brake cable is attached to the calapers. Rember if it wont run it's annoying but if it won't stop, it's deadly. DON"T experiment with brakes!!! If in doubt, take it to a pro.

Posted on May 12, 2009

Ad
bunnydawg
  • 5158 Answers

SOURCE: 2004 Honda CRV - Front Brakes running hot!!!

either caliper seized ? also when you installed the rotors did you have them machined ?

Posted on Oct 19, 2009

  • 105 Answers

SOURCE: how do i adjust the hand brake cable n a 2006

You have rear disc brakes and the rotors act like drums, with e-brake shoes inside. you would need to remove the calipers and rotors to access the star wheel to tighten up the e-brake.

Posted on Dec 10, 2009

  • 14036 Answers

SOURCE: honda crv 2004 brake lights night lights

LOOK FOR BRAKE LIGHT FUSE OR BURNED OUT BULBS BAD BULB SOCKETS OR GROUNDING PROBLEM.

Posted on Feb 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reg Number OY03HZN Honda CRV Petrol 2003 Overheating rear off side wheel?


check for correct bearing preload adjustment
check that the hand brake was properly adjusted off before the pads were fitted as if not on the first application the pads will stay on the disc
the problem is in the workmanship and procedure for the repair

Nov 16, 2015 | Honda Cars & Trucks

1 Answer

Honda crv 2004 brake lights night lights


LOOK FOR BRAKE LIGHT FUSE OR BURNED OUT BULBS BAD BULB SOCKETS OR GROUNDING PROBLEM.

Feb 24, 2010 | 2004 Honda CR-V

1 Answer

Smell of burning rubber rear offside wheel area


Hi there! Check out this link.
http://www.automotivehelper.com/topic175126.htm
this link will take you to a forum full of people with CRV's who are having the exact same problem. It seems to be with almost every year of the CRV as well. Unfortunately Honda has no explanation or solution for this problem. I have a 2009 CRV and have not had this smell, but I have been having a ton of other problems with it. I have been incredibly dissapointed with this car, and will never get another Honda. I hope you have better luck than I, and be careful with it cause I think there are some serious problems with these CRV's. Good Luck!

Jan 12, 2010 | 2009 Honda CR-V

1 Answer

How do i adjust the hand brake cable n a 2006


You have rear disc brakes and the rotors act like drums, with e-brake shoes inside. you would need to remove the calipers and rotors to access the star wheel to tighten up the e-brake.

Dec 09, 2009 | 2006 Honda CR-V

1 Answer

2004 Honda CRV - Front Brakes running hot!!!


either caliper seized ? also when you installed the rotors did you have them machined ?

Oct 19, 2009 | 2000 Honda CR-V

1 Answer

Were do you adjust handbrake crv r/h drive 2003


dear in most cases it will be very hard to reach adjuster but there is another way to get ur hand brake better

required tools

1- lift jack "big one"
2- proper wrench
3- car supports for safety
4- screw driver


now u have to do the following:-

1- lift up the car from the rear middle but be sure it is in NORMAL gear and hand brake is down
supports for front tires is highly recommended
2- remove both of your rear wheels put wheels under the car as if suddenly car fall it will fall on tires and nothing bad will happen
3- put car supports and both sides of rear Axle for more safety
4- now u can see your brake discs, near center of brake discs u will find a removable knob remove it by screw driver and see in side u will see the hand brake clutch push it by ur screw driver towards the center of the wheel until the maximum u can get
5- repeat last step for the other brake disc
6- restore the knob push it hard using screw driver
7- fix ur tires back, remove supports, lower the car and u r as good as new

hope this will help

regards

Jun 22, 2009 | 2003 Honda CR-V

1 Answer

How do i adjust the hand brake on my 2002 honda civic after replacing the rear drum brakes?


Do not adjust the handbrake, it is not necessary. You can adjust the new brake shoes for a better brake pedal and this will also take care of the hand brake. This will have to be done with wheels off and lugs reinstalled to keep the brake drums in place. Sometimes the adjuster is difficult to reach and do not over tighten. When the rear brakes are properly adjusted you should have 3 to 4 clicks on the handbrake.

May 03, 2009 | Honda Civic Cars & Trucks

1 Answer

How do you adjust a 2003 honda crv hand brake i have replaced the back pads but the hand brake has too much travell and it appears the hand brake does not have a cable going to the back brakes so how does...


It should have e-brake cables going to the rear,and to adjust the handle there is an adjuster on the bottom of the handle under the console it will take a four way screw driver and a 12mm wrench to fix your problem hope this helps you!

Apr 22, 2009 | 2003 Honda CR-V

1 Answer

How to adjust the parking brake on 2007 Honda Accord LX?


there is an adjusting screw atached to the hand brake cable located near the hand brake it self but before i do that i would check and replace the rear padds first and replace if needed! that could be the reason why your hand brake needs adjustment???

Dec 15, 2008 | Honda Accord Cars & Trucks

1 Answer

2001 Honda Crv Bake light on dash is on


make sure your emergency brake is off all the way.

Nov 28, 2008 | 2002 Honda CR-V

Not finding what you are looking for?
2002 Honda CR-V Logo

Related Topics:

1,179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...