Question about 1998 Oldsmobile Intrigue

1 Answer

Water getting in the oik - 1998 Oldsmobile Intrigue

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Oldsmobile Master
  • 2,050 Answers

Usually due to a leaking head gasket, or a cracked head. Do not drive or run an engine with coolant in the oil. It will destroy bearings real quick.

Posted on Oct 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where the oik sending switch is on my 89 ford ranger 2.9


It's mounted on the driver's side of the engine block

Jul 27, 2015 | Ford Cars & Trucks

2 Answers

97 Dodge dakota won't start; sounds like starter. What will it take to fix?


oik if itsthe starter motor when you start it it will do nothing or just click ,no if you tap it a few times on the solinoid itmight start ,any way i would by a reconditioned one or brand new a second hand one could last 4 ever or 1 day and the its take the positive of the battery,the take the wires off the sarter then 2 bolts and comes straight out and then put it in same way,

Jul 27, 2008 | 1987 Jeep J-Series Pickup

3 Answers

How do I close my trunk? It was -30 yesterday and I had to pop the trunk, since then I have not been able to close it. Additionally the fuel door is not working either, so they may both need to be fixed....


if you have a chance to put the car in a heated garage somewhere for some hours it would help...
-after the car is warmed up you need to spray some silicone spray on the trunk door and around all the rubber sealing and the fuel door hinge to have it better prepared for freezing temperatures.... blog carlist my
25432069-cqhooai31k0ezg2diigcturd-3-0.jpg

25432069-cqhooai31k0ezg2diigcturd-3-2.jpg

Feb 15, 2015 | 2003 Honda Civic

1 Answer

10 Reg interior light


ya dont worry bout busting it if its burnt get a flat head screw driver pry it itll pop out

May 17, 2013 | Kia Picanto Cars & Trucks

1 Answer

How to turn oil down to correct, to much oik burning ,i have had a top end done probally mechanic turned up oil because of top end rebuild how to check and do i need to bleed afterwards im not a mechanic...


Aside from you providing no vehicle

You can not adjust oil flow or pressure

That is only done an race motors

Wouldn't you ask the folks that did the work?

Nov 20, 2012 | Cars & Trucks

1 Answer

Front indicator failure but the bulb is ok on my 2007 jaguar xk. Could it be the relay and where is the relay


check the bulb with a test meter and if oik then check for a feed to holder using a earth direct to engine ,if feed ok then its a faulty earth ,

Jun 25, 2011 | Jaguar XK Cars & Trucks

2 Answers

I havea daewoo nubira and we replaced the valve cover gasket yesterday , did an oik change and now the engine is smoking white smoke. Try to check to hoses, could not see a leak. Where is the cylinder...


Hello and welcome to FixYa!

The cylinder head is located on the center of the engine. Yes it can be a worn out head gasket or piston rings. If the piston rings are worn out the oil is burnt that's why it emits white smoke. You will need to replace the head gasket and piston rings.

Hope this helps and thank you for using FixYa! Have a good one!

Apr 30, 2011 | 2000 Daewoo Nubira

2 Answers

Water in oik


This is going to be because of a blown head gasket

Feb 11, 2011 | 1997 GMC Suburban

1 Answer

Low oik pressure at times


thats a bad sending unit I would put another one in.

Oct 06, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Oldsmobile Intrigue Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...