Question about Chevrolet 1500

1 Answer

Spark plug wire to dist cap diagram - 1500 Chevrolet Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,826 Answers

What year, make (chevrolet), and model and engine size?

Posted on Oct 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do wires go from coil pack to distributor cap and where else 1990 chevytruck 350


coil HT lead to centre contact on dist cap ,the remaining HT leads go to the spark plugs you will need the firing order to get them on the correct plug follow this link may have to research site for your year vehicle
1967 1972 Chevrolet Spark Plug Wiring Diagrams

Apr 04, 2014 | Cars & Trucks

1 Answer

Crv shut down oil cap lefted off and oil all over engine and truck shutn down checked and found oil fill the spark channel and boots so replace the gasket and plugs and cleaned off the wires and now have...


have you put a new set of plug wires on it. use a spark plug tester, and put it between plug wire and dist, cap. if it is sparking you will see it. if yes and not to plugs put on new plug wires. good-day ! if above checks out. remove dist, cap and see if shaft of dist, is turning. some of the hondas have a plastic type drive gear on bottom of dist, shaft. that goes bad.

Sep 21, 2011 | 2000 Honda CR-V

2 Answers

I disconnected the spark plugs from the distributor cap and now i cant remember how to connect the plugs back up.


the firing order is 1-8-4-3-6-5-7-2. there should be alot of websites that show diagrams of this

Jun 13, 2011 | 1987 Oldsmobile Cutlass Supreme

3 Answers

Location of spark plug wires to distributor cap for jeep cherokee 4.0 1987


Here is a firing order diagram for that vehicle and engine, and let me know if you need any help to understand this diagram, or if you require any further assistance.


f833d4b.jpg

Sep 28, 2010 | Jeep Cherokee Cars & Trucks

1 Answer

I bought a 79 trans am but the spark plug wires are not connected. I need to know how to hook up the wires for the oldsmobile 403 engine


First youll need to locate top dead center, remove the first plug on the driverside, have someone tap key until compression blows out have your finger over the sparkplug hole while the key is tapped, after the air blows out remove the dist cap, then find line on crank and line up to 10 degrees btdc, look at the dist rotor # 1 on the cap will be the prong cloesest the where rotor points going counter clockwise, so mark side of dist, then install cap follow line you made to locate the #1 prong on cap start there that # 1, here a diagram with firing order and cylinder id. hope this helps.b5327b1.gif

Sep 11, 2010 | 1979 Pontiac Firebird

1 Answer

94 royal begis to cut out, chugs at about 55


Replace the spark plugs and wires along with a distributor cap and rotor. Be careful to leave the old wires and plug wires connected to dist.cap, just remove dist. cap from the distributor and lay aside with plug wires on it then install rotor then new cap and proceed to replace each wire for cap and spark plug one at a time so you don't mix up the spark plug wire firing order. Cap laying to the side is used for reference purpose.

Feb 26, 2010 | 1994 Oldsmobile 88

1 Answer

NO SPARK FROM PLUGS


REMOVE DIST. CAP AND CRANK ENGINE SEE IF ROTOR TURN IF IT NOT, CHECK TIMING BELT, IF IT TURNS CHECK FOR SPARK ON DIST. CAP WHERE COIL WIRE GOES IF SPARK CHANGE OUT SPARK PLUG WIRES.IF NO SPARK CHECK IGNITION COIL AND PICK UP COIL.

Nov 05, 2009 | 1992 Volkswagen Passat

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...