Question about 1998 Oldsmobile Bravada

1 Answer

Vehicle cranks but won't fire. This problem came on all of a sudden. It was running fine up until it wouldn't start.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Contributor
  • 254 Answers

4 important things for a no start to check.Power from the ignition switch.Power at the fuel pump relay.Fuel pressure,spark at the plugs and a signal leaving the crankshaft sensor {distributor}. etc

Posted on Oct 12, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 Cherokee will crank but won't fire. Replaced


how much is the RPM showing in the datatlogger while cranking?

Dec 03, 2012 | Cars & Trucks

1 Answer

2000 Dodge neon starts and runs fine. But sometimes does want to start Engine cranks, but won't start


How many miles on the car? Have you checked the fuel pressure when it doesn't want to start? Do that first and then move on from there. To quickly test fuel pressure with no special equip get a can of starting fluid from the auto parts store, when it fails to start spray the fluid into the air intake of the engine well it is cranking, if it fires up then the fuel pump is likely not running on for some reason. This can be electrical in nature or just a failed electric fuel pump

Aug 07, 2012 | Toyota Camry Cars & Trucks

1 Answer

03 Tahoe Z71 Flex Fuel won't start and run. Engine turns over, fires, but won't start. I can hear the fuel pump run but it is not a steady sound like I would normally hear. I am getting a P0


It wouldn't hurt to check fuel pressure with a fuel pressure gauge. you should see somewhere around 48 - 55 psi. the test port is on the fuel rail about in the middle of the rail and on the drivers side.

If the fuel fuel pressure is low it wouldn't hurt to make sure there is power to the fuel pump before condemning it. Power is supplied to the pump by the larger of the two grey wires.

The fuel pump is located in the fuel tank and the fuel tank will need to be dropped from the vehicle in order to service the fuel pump.

If you decide to replace the fuel pump get an a/c delco or a delphi pump. These are the best two option for your vehicle. Do not get an airtex brand. They are not reliable pumps although they are cheap.

Let me know if you have any questions and thank you for using fixya.com!

Feb 25, 2012 | 2003 Chevrolet Tahoe

3 Answers

1988 toyota camry 2.0 turns over but won't start. Car has been driving like a champ and one morning wouldn't start. Turns over fine but won't fire. Tested for spark by removing spark plugs...


Fuel pressure at idle is normally 30-35psi. Start by taking the gas cap off, and putting it back on. That will De-pressurize the fuel system. Also, make sure you have gas in the car. I have seen gauges on these cars read wrong. I hope this helps.

Oct 05, 2011 | 1988 Toyota Camry

1 Answer

Was driving down the road and it just went dead. It's getting gas and fire but will not crank.


I encountered a similar problem on a chev 4cyl with a coil pack ignition ( no distributor). It would run for a while and suddenly die out and wouldn't restart until a 10 to 20 min. cooling period. It turned out to be a crankshaft position sensor going bad. On this engine it was located in the engine block under the ignition module on the firewall side.

Aug 13, 2011 | 1998 Chevrolet Cavalier

1 Answer

I have a 2006 Pontiac GT G6 Coup. When we first bought it back in Nov. 2010, it was fine. After a month or two, the clock would reset almost everytime the car was started, radio stations would NOT get...


sounds like a problem with the ignition barrel.the wiring is loose or the connectors are loose or the barrel is faulty,unless thse are all run from the onboard computer.

May 31, 2011 | 2006 Pontiac G6

Not finding what you are looking for?
1998 Oldsmobile Bravada Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...