Question about 2001 Ford F150 Styleside SuperCrew

1 Answer

I have a 2001 F-150 ford truck and have no brake, turn signal or emergency flashers. I have changed the flasher and checked all fuses . any suggestions? Thanks Jack

Posted by on

  • Greg McCarthy Oct 12, 2010

    Just to make sure,many people say they checked the fuse which is a broad term.Did you look at it or swap it out with an exact same rating.I will watch for an answer to try to resolve ASAP.Greg

  • berkleyclare Oct 13, 2010

    Thanks for getting back so quick. I have replaced the fuses although they test good, but it was the easiest thing to start with, Also the Flasher.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,340 Answers

Thinking...thinking brb

Posted on Oct 13, 2010

  • 1 more comment 
  • Greg McCarthy Oct 13, 2010

    Normally,there isn't anything much in common between the 3 problems.As for the brake lights,there is a switch,normally somewhere on the back of the brake pedal which activates the brake lights,somewhere up high near the linkage.The only thing common to the flashers and hazards is the column on the steering wheel to activate them.That means possibly 2 separate problems,which is odd, but stranger things have happened.The only real thing which have all 3 in common would be the steering column itself or the harness.Tomorrow afternoon i have a 3:30 appointment but there is a library within a mile which carries haynes and chilton manuals which i commonly use so i will take a look at them and try to figure it out.There are no downloadable repair or service manual downloads available free on the internet due to copyright and patent royalties/fees so i make use of the library alot.Owner's manuals free,yes.Greg

  • Greg McCarthy Oct 13, 2010

    Just a forewarning,i have been putting off some medical tests and i think tomorrow I need a serious talk with doc.Just thought I would make you aware just in case I end up in hospital overnight or something.Very sorry.Felt the need to notify you so you do not think i forgot.Greg(been an awful night) :(

  • Greg McCarthy Oct 14, 2010

    When i went to the library,i found alot of information about your truck EXCEPT those schematics.The issue I needed wasn't there.I tried 2000 and 2002 but to no avail.I will keep on keepin on though.I'll keep up to date,have your notes written down.Greg Sorry :(

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1987. Why is there no power at the turn signal cam?


Do you have brake and parkng lights? The turnsignal switch on the column is just designed to relay a path to the flasher and then it is designed to interupt the brake and some of the parking lights lights, which cause the flashing on and off. Double check fuses double check bulb socks and bulbs for good contacts. Does the 4 ways work? If the lights all flash then locate the turn signal flasher and switch with emergency flasher if possible to rule out relay. If those are all good and the emergency flasher lights work and bulbs, then you would have a problem with the turn signal switch. Hope this all helps

Feb 22, 2016 | Ford E-150 Cars & Trucks

2 Answers

What fuse is for the turn signals in a Ford explorer sport 2002


You should find a fuse that is labeled "multi-purpose" switch or similar. That would be the fuse. You might want to play with the hazard flashers switch a bit by pressing it on and off a bunch of times. Occasionally some debris gets in there and knocks everything out. Could be a loose connector on the multi-function switch. You'll have to remove the cowling to see it.

Good luck.

Dec 10, 2014 | 2002 Ford Explorer

2 Answers

What would cause the turn signals to work sometimes and sometimes not ?


A bad flasher relay would do that. They are usually located on the fuse panel and plug into it.

Jun 27, 2014 | 1992 Ford Tempo

1 Answer

Turn signals wont work bulbs ok dont have a manual to the car dont know wich fuse goes to the turn signals


pickup a test light and check all the fuse if the fuses are good then you probably have a bad signal flasher.make sure you change the signal flasher and not the emergency flasher as they look the same.

Jul 30, 2011 | 1995 Ford Mustang

1 Answer

Emergency flashers work ok but indicators do not, have checked fuse and its ok changed bulbs all ok,


you need to replace the flasher canister, the car is equipped with two one for the emergency flashers and one for the turn signals the flasher is located on the fuse block.

May 12, 2011 | 1988 Ford Escort EXP

1 Answer

Emergency Flashers totally out, Rear lights malfunctioning


Check the ground on the passenger side rear lights, it's likely bad. As for the hazards, sounds like a bad flasher or fuse.

Sep 03, 2009 | Ford Super Duty Cars & Trucks

1 Answer

1997 Chevy Tahoe both turn signals stopped working


Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.

Jul 21, 2009 | 2001 Chevrolet Tahoe

1 Answer

1995 F150 the turn signals do not work, but


Look in the fuse panel and the turn signal flasher is the big round most likely yellow or silver in the corner of fuse panel. The emergency flasher is in the back side of fuse panel right directly behind the turn signal flasher.
Remove the emergency flasher and install it in place of the turn signal flasher and see if this corrects the problem and if so get a new flasher. If this does not correct it problem will most likely be the multi-function switch.

Mar 13, 2009 | 1984 Ford F 150

1 Answer

1991 Ford E150 turn signals do not work,emergancy flashers flash constantlly unless the flasher relay is unplugged from fuse block


Hi,

If I understand you right based on your post/description, the signal lights would still turn on even if any or both of the flasher relays are removed. Should this be the case, then the signal lights are not getting the power from the flasher relays but from the brake light circuit.

Perhaps your concern is not with any of the flasher, but simply missing or loose ground more particularly with the rear lights. Perhaps you could try determining which of the wires for the brake lights and signal lights (as they come out of the light assembly) would be ground . A test and even possibly a temporary workaround is to hard wire a second ground connection from the determined ground wire of the lights and attach it to any conveniently located bolt or screw to the body. it may be to your advantage to do this on all the rear lights assembly.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Aug 05, 2008 | 2003 Ford E150

Not finding what you are looking for?
2001 Ford F150 Styleside SuperCrew Logo

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...