Question about 2006 Dodge Durango

1 Answer

2006 Dodge Durango, engine light coming on from time to time, when rpm's get above 2500 the engine starts to cut out

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 75 Answers

You need to check the fuel pump...plan to make a major tune-up if possible...
you need to check the air filter...
god luck!

Posted on Oct 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check engine light


My advise is when you do have the check engine light on try to use a scanner in order to see what fault you do get at that time. If you get any fault try to check via an ohmmeter by checking the currency of power to that faulty given part. Probably you do have a loose wire somewhere.

May 28, 2013 | 2004 Dodge Durango

1 Answer

While driving my 2006 Dodge Durango, the malfunction indicator light was on and the engine cut out while I was driving - no exterior lights or power steering, but interior lights and radio were still on. ...


dodge durango cuts off when starting however , when I press on the gas it will stay started whats the issue ? Just had oil & change all fluids checked in may 2014 for a dodge durango . plan on taking a drive from seattle wa to California San Diego is it safe to do so ?

Jun 13, 2011 | 2006 Dodge Durango

1 Answer

Check engine light on. Will not rev up over 2500 rpm. Fluctuates between 2000 and 2500 rpm and runs rough. Upon first start, you can rev fine and it runs smooth as long as you hold the rpms over 3000. ...


Hi, there are a lot of things that could cause this behavior, so it would help us to diagnose your problem if you could get a scan of the OBD2 connector and send us the trouble code. If you live in the US you can usually get a free scan at your local parts chain.

May 19, 2011 | 2004 Dodge Durango

1 Answer

2004 Durango dies and shifts weird


I will try to help..ihave a 2000 dodge durango with the 4.7 v8..My trans started shifting funny and the rpm's would go up to 2000+rpm when i was driving, which means i was getting really crappy gas mileage at 40mph..took it to shop, engine light on,put it on machine to diagnose..got a generic p0700 code plus a couple others..code basically says tranny is fn up..
Try this a cheap fix first that worked for me..on the transmission,driver side there are two sensors..input/output transmission speed sensors..to be exact..they send info to computer to regulate shift points in trans..upshift and downshift..replace them both although one may be the culprit..cost at the dealer here in Delaware was $40.72 for one..there is one bolt(8mm)and one electrical connection to each..time to replace both about 15minutes you don't even have to jack up truck but you will have to get underneath.

Hope this helps and good luck..if you change them and find the tranny shifting properly..cycling the on and off switch will eventually turn off the engine light..just drive it normally i mean..go here shut it off..get back in start it up and go..it will go out..good luck

May 10, 2010 | 2004 Dodge Durango

1 Answer

2006 dodge durango engine light blinks 10 time and wont start?


sounds like this is a security problem ,Try this switch key on leave on 15 min.switch off then crank vehicle, the light should go off .or check manual.

Feb 28, 2010 | 2006 Dodge Durango

1 Answer

Check engine light stays on - 2006 Dodge Ram 2500 Cummins


Go to Autozone, they will check your engine codes for free.

Sep 23, 2009 | 2006 Dodge Ram 3500 Truck

1 Answer

2006 check engine light came on and RPM slowed to 2000


Not the fuel filter, this is an emissions problem. Sounds like it is in Limp Mode. You need to have the ECU scanned for trouble codes. Is this vehicle not still under warranty for the emissions system? Call your Dodge dealer and find out.

Sep 02, 2009 | 2006 Dodge Ram 2500

1 Answer

I have a 2006 Dodge Durango. At 27,000 miles, it started stalling in traffic and the dealer replaced several sensors. The cam sensor was the last one to be replaced. Now at 72,000 miles, it has began to...


if there is a knocking sound the computer will start retarding the timing to get rid of engine knock thru the knock sensor. Make sure you are using the correct grade of fuel. it will be listed in your owners manual. the improper grade of fuel can cause detonation in your engine. giving a knocking sound. if the change in fuel doesn't help you may be looking at mechanical repairs. hope this helps. mike

Jun 16, 2009 | 2006 Dodge Durango

1 Answer

2006 dodge durango 5.7 limited. engine light


Sounds right & check manual for warranty guidelines for your emission system & components, sometimes they are a little longer than 40,000 I believe.

Jun 04, 2009 | 2006 Dodge Durango

Not finding what you are looking for?
2006 Dodge Durango Logo

Related Topics:

275 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...