Question about Chrysler LeBaron

Open Question

1999 chrysler lebaron - my headlight covers will not close! Head lights work covers do not want to shut. Maybe 1/4 way. Thank you

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 46 Answers

SOURCE: How to put on Serpentine belt for 92 Chrysler Lebaron 3.o liter engine

Before replacing or installing the old belt you need to check all of the pulley's that the belt rides on for play. Pay special attention to the spring loaded tensioner pulley. They can sieze and cause the belt to come off.

I found this picture it is a bit large for the screen.

80003475.gif

Posted on Aug 30, 2008

  • 59 Answers

SOURCE: 1991 chrysler lebaron windsheild wipers will not shut off

i think the switch could have got jamed to the on position u may have to replace it to git them to turn off for now there should be a fuse for them pull it

Posted on Jan 05, 2009

  • 114 Answers

SOURCE: 1988 Chrysler New Yorker Auto Headlight panels won't stay open

It's possible the nylon gear in the door motor located behind center of grill is stripped. There is also an assist spring on the bar to the passenger side lamp door which may have become disconnected.
The motors cost around $80.00 for the part but if your just looking to keep them open you could insert a small screw near the pivot point of either lamp door.

Posted on Mar 22, 2009

  • 1986 Answers

SOURCE: how to replace our low beam headlight on 1999 town and country

1.) Open the hood of your van 2.) On the passenger side of the vehicle, look behind the headlight enclosure. You will see a set of wires running into the back of it. This is the power clip. Either with your hand or a flat-head screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful not to touch the glass part of the new bulb. The oils in your skin can substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.

Posted on Oct 29, 2009

  • 2841 Answers

SOURCE: What are the torque specs for a 1992 Chrysler

6 ft/lbs

Posted on Apr 24, 2010

Testimonial: "The information that was provided to me was excellent. i would have been lost without it. Thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Adjusting headlights on my 89 chrysler lebaron


normally 3 screws at the back of the head light case set in a triangular pattern

May 23, 2013 | Cars & Trucks

1 Answer

1986 Chrysler Lebaron dashboard lights out


probably the headlight switch. also check the fuse panel. the dash lights should have their own fuse which if blown could indicate an electrical short.

May 19, 2013 | Chrysler LeBaron Cars & Trucks

1 Answer

Headlight doors on my 1989 labaron do not operate, fuse is good


I have the same problem. I found the motor runs well but the contraption that's driven by the gear has disintegrated. Anyone know where to find one or what it's called? thanks

May 10, 2012 | 1989 Chrysler LeBaron

1 Answer

I am having problems with my 1988 Chrysler New Yorker motorized headlight covers. Both headlight covers don't close completely when I shut the headlights off. There is about 3 inches to go on both...


I have the same problem with my 93 Salon. Take a look at the torsion bar rod end close to each headlight.There are collars that have a set screw which can be loosened to adjust the range of the door opening and closing. If the doors are going through the full cycle open to close but fall back and leave a gap such as you describe, most likely you will only need to adjust those screws. Each door will require adjustment individually. May require an allen wrench. Hope this helps.

Aug 11, 2010 | 1988 Chrysler New Yorker

1 Answer

We have a 1990 lebaron 56000 miles when it gets cold outside,like35 degrees sometimes the headlights will not go on until after the car is fully warmed up. the hi beams will always work but the headlights...


the old chryslers were very suseptable to dampness esp at 35 deg after car warms up the damp wires would dry off and the problem would go away some time this also affected the ignition and car would not start on damp or rainy days as well

Dec 15, 2009 | 1990 Chrysler LeBaron

1 Answer

1995 chrysler lebaron


Here's what mine says- for a 95 Chysler LeBaron GTC Convertible. I didn't see anything about a fuel pump, but maybe it's connected to something else? I dunno. Good luck. Here's the info at least.
1 HTR-AC 30A, 2 POWER WINDOWS 30A C/B, 3 PWR SEAT, LKS, TOP 30 A C/B, 4-BLANK, 5 BACK-UP LAMPS 20A, 6 TURN SIGNAL 20A, 7 REAR WIPER 20A, 8 ILLUM LAMPS 5A, 9 INTERIOR LAMPS 10A, 11 CIGAR LIGHTER 20A, 12 RS AMO 20A, 13 INTERIOR LAMPS 10A. 14 BOD COMP MESS CTR 5A, 15 SPEED CONTROL 2A, 16 GAUGES AIRBAGS 5A, 17 STOP LAMPS 18 HEAD LAMP RT-LOW 10A, 19 HEATED MIRRORS 5A, 20 AIRBAGS 5A, 21 STOP LAMOS 20A, 22 HORN 20A, 23 RT-TAIL LAMP-EUR 5A, 24 LT-TAIL LAMP EUR 5A, 25 HEAD LAMP LT-HI 10A, 26 HEAD LAMP RT-HI 10A, 27 RADIO 104, 28 FRONT WIPER 20A

Mar 29, 2009 | 1995 Chrysler LeBaron

1 Answer

Head light problem on bmw e46


if ur side light still works then ur bulb most likely blown my e36 has a screw connector on the back off the headlight dnt know if e46s do but maybe that has come loose?

Feb 07, 2009 | 1999 BMW 328 Series

1 Answer

The headlight motor on my 1990 lebaron convertible does'nt work.. no power at the motor .. the fuse and everything else is right..what can be the problem .. maybe the body control module ????


The motor is burned out. If you look under the hood in front of the radiator there is an "emergency access panel" that you can lift up and manually open the covers. You'll need to feel around for the gears and such but you can manally open them and they will then stay open until/if you decided to replace the motor.

Hope this helps!

Jul 24, 2008 | 1988 Chrysler LeBaron

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...